Influence of protein and lipid concentration of the test lubricant on the wear of ultra high molecular weight polyethylene

To gain a better understanding of the ultra-high molecular weight polyethylene (UHMWPE) wear mechanism in the physiological environment, the effects of protein and lipid constituents of synovial fluid on the specific wear rate of UHMWPE were examined experimentally. The multidirectional sliding pin-on-plate wear tester was employed to simulate the simplified sliding condition of hip joint prostheses. Bovine serum γ-globulin and synthetic l--DPPC were used as model protein and lipid constituents of synovia, respectively. Results of the wear test indicated that the UHMWPE wear rate primarily depended on the protein concentration of the test lubricant. Lipids acted as a boundary lubricant and reduced polyethylene wear in the low protein lubricants. However, the polyethylene wear rate increased with increasing lipid concentrations if the protein concentration was within the physiological level. Increased interactions between protein and lipid molecules and lipid diffusion to polyethylene surface might be responsible for the increased wear.     

Ozone micro-bubble disinfection method for wastewater reuse system.

Reuse of wastewater is regarded as one important way to deal with the world's shortage of potable water. The authors focused on a disinfection system using micro-bubbles and evaluated its capability for wastewater reuse. This paper reports experimental results from examination of the basic characteristics of micro-bubbles and disinfection of secondary effluent by air or ozone micro-bubbles. The results suggest that when micro-bubbles are applied in an ozonation system it is possible to reduce the reactor size, the amount of ozone decomposition equipment needed and the ozone dose rate.     

An expert system for XPLE cable deterioration diagnosis and life forecasting

The recent increase in the demand for power in urban areas has caused changes in the way power is supplied. Underground distribution systems have been introduced for convenience in urban areas and to prevent injuries in case of a crisis. As a result, many new types of power cables are being used. One type, XPLE cables (also called CV cables) have been rapidly taking the place of conventional cables such as OF or SL cables since the 1960s because of their relatively easy installation and maintainability. However, distribution cables used under severe environmental conditions deteriorate rapidly (due mainly to water treeing), and some cables experience insulation breakdown. Therefore, many diagnostic methods have been developed, though they have not been very effective. By combining methods, a high reliability can be achieved in comparison to the use of a single method. However, processing the data is difficult for on-site personnel, so many experts are required. But there is a lack of qualified experts, hence we have turned to the development of expert systems.     

Simple and modified rule of mixtures of deformation parameters in stage III of single ductile fibre-ductile matrix composites

By employing a single thick molybdenum fibre-copper matrix composite with very weak interfacial bonding, it was confirmed that flow stress, internal stress, effective stress and change in flow stress due to change in strain rate of the composite obey the simple rule of mixtures; strain-hardening exponent, stress exponent of strain rate, effective stress exponent of dislocation velocity and activation volume obey the modified rule of mixtures in the whole range of plastic deformation of the composite. This means that the inherent features of the fibre in the present composite were conserved beyond the failure strain of the fibre tested alone, and the above deformation parameters of the composite were, to a first approximation, determined by the inherent parameters of the fibre and the matrix.     

Characteristics of estrogen decomposition by ozonation.

Since the natural estrogens 17 beta-estradiol (E2) and estron (E1), and the synthetic estrogen 17 alpha-ethynyl estradiol (EE2) have strong endocrine disrupting effects and the tendency to persist in effluent from wastewater treatment plants, effective measures are needed to remove them from wastewater. In this research, to gain an understanding of the characteristics of estrogen decomposition by ozonation, experiments were conducted using effluent from an actual wastewater treatment plant. In this experiment, estrogen was added to effluent at a concentration of 200 ng/l and 20 ng/l before the ozonation experiments. The results showed 90% or more of estrogen concentration and estrogenic activity of E2, El and EE2 to be removed at an ozone dose of 1 mg/l. At an ozone dose of 3 mg/l, the estrogen concentration and estrogenic activity of E2, El and EE2 in the treated water fell below the detection limit. The removal rate was not influenced by the kind of estrogen. No generation of byproducts with estrogenic activity was observed. The authors conclude that estrogen in secondary treated wastewater can be almost entirely removed at the practical ozone dose rate applied for the purpose of disinfection, which is up to about 5 mg/l.     

Design of nonlinear controllers for active vehicle suspension with state constraints

Design of active vehicle suspension has tradeoffs between three main performance metrics (passenger comfort, suspension deflection and road holding ability). It has been known that each performance can be achieved by H _∞ controller and they can be gathered by LPV (Linear Parameter Varying) method. However, because the suspension deflection limit was not explicitly considered, this limit may be exceeded. In this paper, the authors propose a “reference shaping“ based method in order to improve the control performance. In this approach, a “virtual reference” signal is imposed to the system such that the suspension deflection is kept small. The effectiveness of the approach is examined by numerical simulations. This work was presented in part at the 13th International Symposium on Artificial Life and Robotics, Oita, Japan, January 31–February 2, 2008     

Torque sensorless control in multidegree-of-freedom manipulator

A torque sensorless control for a multi-degree-of-freedom manipulator is described. In the method, two disturbance observers are applied to each joint. One is used to realize a robust motion controller. The other is used to obtain a sensorless torque controller. A robust acceleration controller based on the disturbance observer is shown. To obtain the sensorless torque control, it is necessary to calculate the reaction torque when the mechanical system performs a force task. The calculation method for the reaction torque is explained. Then the method is expanded to workspace force control in the multi-degree-of-freedom manipulator. Several experimental results are shown to confirm the validity of the proposed sensorless force controller     

Rapid Quenching Technique Using Thermal-Image Furnace for Glass Preparation

A new technique combining a thermal-image furnace and a twin roller is described for quenching the melt to form glass. The technique was applied to the simple system Li₂O-SiO₂, since its fundamental parameters in the estimation of critical cooling rate are available. Glass flakes were obtained in the composition Li₄SiO₄, for which a very large critical cooling rate (∼10⁹ K·s⁻¹) was needed for glass formation.     

SEPARATION AND ENRICHMENT OF WEAK ORGANIC ACIDS OR BASES BY IMMOBILIZED LIQUID MEMBRANES

A new and effective liquid membrane process to achieve both separation and enrichment simultaneously of weak organic acids or bases was developed. The process utilizes effectively the difference in the apparent partition coefficient of the constituent species between the aqueous and organic phases, and uses the change of the apparent partition coefficients with the hydrogen ion concentration of the aqueous phase. For such a fundamental model apparatus as a diaphragm diffusion cell being operated batch wise, the effects of pK value of solutes, permeability of solutes through the membrane, volume ratio of liquids in two aqueous phases, and pH value of aqueous phase on enrichment factor and selectivity for the solute to be concentrated were discussed analytically. Separation and enrichment were demonstrated using aqueous mixed solutions of fumaric acid and L-malic acid. The results were in good agreement with the theoretical predictions.