Solvent Extraction of Copper from Sulfate–Chloride Solutions Using LIX 84-IC and LIX 860-IC

ABSTRACT

The effect of chloride ions on the copper extraction equilibria, the rate of extraction, copper/iron selectivity, and chloride extraction was studied for organic phases containing pure ketoxime (LIX 84-IC) and pure nonylaldoxime (LIX 860N-IC). In these systems, the used aqueous phase contained total chloride concentrations from 0 to 110 g/l. It was determined that the chloride ions in the aqueous solution had a large negative effect on the extraction equilibria for LIX 84-IC and a small effect for LIX 860N-IC. This deleterious effect is attributed to an increase in the hydrogen ion activity coefficient in the presence of chloride ions. The chloride accelerated the rate of copper extraction even though the reaction was fast in all the tested conditions. An increase in the temperature from 25°C to 35°C affected positively the extraction equilibria for LIX 84-IC.     

Effects of SiC particles codeposition and ultrasound agitation on the electrocrystallisation of nickel-based composite coatings

This study analysed the influence of the codeposition of SiC particles with different sizes: 50 nm, 500 nm and 5 μm, and the type of bath agitation (stirring or ultrasonic) on the electrocrystallisation of nickel coatings. The composites matrix microstructure was analysed by means of SEM, EBSD and XRD, to evaluate the grain size, crystal orientation, and internal stresses and was benchmarked against pure nickel samples electrodeposited in equivalent conditions. The codeposition of nano- and microsize particles with an approximate content of 0.8 and 4 vol.%, respectively, caused only a minor grain refinement and did not vary the dominant?<?100?>?crystal orientation observed in pure Ni. The internal stress was, however, increased by particles codeposition, up to 104 MPa by nanoparticles and 57 MPa by microparticles, compared to the values observed in pure nickel (41 MPa). The higher codeposition rate (11 vol.%) obtained by the addition of submicron-size particles caused a change in the grain growth from columnar to equiaxial, resulting in deposits with a fully random crystal orientation and pronounced grain refinement. The internal stress was also increased by 800% compared to pure nickel. The ultrasound (US) agitation during the deposition caused grain refinement and a selective particle inclusion prompting a decrease in the content of the particles with the larger particles. The deposits produced under US agitation showed an increase in the internal stresses, with double values compared to stirring. The increase in the deposits microhardness, from 280 HV in pure Ni to 560 HV in Ni/SiC submicron-US, was linked to the microstructural changes and particles content.

Graphical abstract

     

Treatment of gas-phase methanol in conventional biofilters packed with lava rock

The performance of laboratory scale methanol-degrading biofilters packed with lava rock was checked during almost 1 yr under different conditions. The biomass concentration and biomass adaptation of the inoculum dramatically affected the start-up and the performance of the systems during the first stages of operation. A fast start-up was obtained when using concentrated and adapted inocula, while diluted or non-adapted inocula proved to be much less efficient. The performance of the reactor during long-term operation was significantly affected by the toxic load and moisture content of the gas. Critical loads between 120 and 280 g/m(3)h were reached during different phases of the study. The reactor had a high stability to EBRT changes when working at values between 48.0 and 91.1s, showing little or no negative effect when decreasing the EBRT. Hardly any difference was observed regarding performance when using either a downflow or upflow feed, although slightly better results were obtained when working in a downflow mode.     

A study of a water-reducing agent from cashew nutshell liquid

The water-reducing agent better known as superplasticizer is a recent development. A number of base materials have been used for the development of such water-reducing agents which can act better than ordinary plasticizers in concrete. The sulphonated salts of melamine, napthalene, lignin, hydroxycarboxylic acids and hydroxylated polymers are some typical compounds. Recently cashew nutshell liquid obtained from a natural product waste as a thick black phenolic compound has been converted into a water-reducing agent. This paper describes the results obtained on its effectiveness in influencing the rheological properties of flow, viscosity, particle size distribution, etc, of cement particles in hydrating cements and the water-reducing capabilities in cement mortars and concretes.     

Effect of agitation, turbidity, aluminium foil reflectors and container volume on the inactivation efficiency of batch-process solar disinfectors

We report the results of experiments designed to improve the efficacy of the solar disinfection of drinking water, inactivation process. The effects of periodic agitation, covering the rear surface of the container with aluminium foil, container volume and turbidity on the solar inactivation kinetics of Escherichia coli (starting population = 10(6) CFU ml(-1)) were investigated. It was shown that agitation promoted the release of dissolved oxygen from water with subsequent decrease in the inactivation rates of E. coli. In contrast, covering the rear surface of the solar disinfection container with aluminium foil improved the inactivation efficiency of the system. The mean decay constant for bacterial populations in foil-backed bottles was found to be a factor of 1.85 (std. dev. = 0.43) higher than that of non-foil-backed bottles. Inactivation rates decrease as turbidity increases. However, total inactivation was achievable in 300 NTU samples within 8 h exposure to strong sunshine. Inactivation kinetics was not dependent on the volume of the water container for volumes in the range 500-1500 ml.     

Elimination of beta-blockers in sewage treatment plants

beta-Blockers are used to treat high blood pressure as well as patients recovering from heart attacks. In several studies, they were detected in surface water, thus indicating incomplete degradability of these substances in sewage treatment plants (STPs). In this study, we determined the sorption coefficients (K(D)) and degradation rates of the four beta-blockers sotalol, atenolol, metoprolol and propranolol in sludge from an STP operating with municipal wastewater. The sorption coefficients (K(D), standard deviations in brackets) were determined as 0.04(+/-0.035), 0.04(+/-0.033), 0.00(+/-0.023) and 0.32(+/-0.058) Lg(-1)(COD), and the pseudo-first-order degradation rate constants were estimated to be 0.29(+/-0.02), 0.69(+/-0.05), 0.58(+/-0.05) and 0.39(+/-0.07) Ld(-1)g(-1)(COD) for sotalol, atenolol, metoprolol and propranolol, respectively. These values translate into a typical elimination in STPs (sludge concentrations of 4g(COD)L(-1) and a hydraulic retention time of 6h) of 25%, 37%, 44% and 50% for sotalol, propranolol, metoprolol and atenolol, respectively. These results are also confirmed by measurements in two municipal STPs for atenolol, sotalol and propranolol. The estimated eliminations are slightly too high for metoprolol.     

A novel multi-electrode system for electrolytic and biological water treatments: electric charge transfer and application to denitrification

A novel multi-electrode system is proposed for electrolytic and biological water treatments. The multi-electrode system is comprised of multiple working electrodes and their counter electrode, where electric current or potential applied to each electrode is controlled independently. Experimental result for different electrolyte solutions showed that electric charge in the system was efficiently carried by dissociative electrolytes such as carbonate ions. This transfer mechanism is regarded as being effective both in keeping pH level around neutrality and in passing certain amounts of electric current especially in dilute solutions such as groundwater and surface water. A long-term (over 500 days) experiment also showed the enhanced and stable denitrification performance of biofilm-electrode reactor (BER) equipped with the multi-electrode system, comparing to former BERs. This superior performance was thought to be attributable to large effective surface area of electrode, the charge transfer mechanism by dissociative electrolyte, and the formation of highly reducing (or oxidizing) zones. From these results, we conclude that the multi-electrode system is useful for electrolytic and biological treatments of groundwater and surface water.     

Enhanced adsorption of Cd (II) on a hydrous Al (III) floc in the presence of a modified form of polyethylenimine

A polymer modified with succinic anhydride has been investigated for the adsorption of cadmium (II) on a freshly precipitated aluminium (III) hydroxide floc. The proportion of chelate attached to the polymer is varied to determine the relationship between carboxyl and amino groups on the polyelectrolyte, in terms of enhanced adsorption of cadmium (II) on a hydrous aluminium floc. The presence of polyelectrolyte enhanced the adsorption of 3.3 ppm Cd (II) on a 333 ppm Al (III) floc at every concentration of polyelectrolyte investigated. The proportion of succinic anhydride attached to the polymer had an impact on the increased adsorption of Cd (II) on an Al (III) floc observed. A decreasing proportion of succinic anhydride to polymer resulted in a decrease in the amount of cadmium adsorbed on the floc. Above pH 8, a decrease in the % Cd (II) adsorbed on the floc and % Al (III) retained within the floc decreases with the presence of polyelectrolyte as a result of the formation of soluble Cd-Polyethylenimine-succinic acid (PEISA) complexes. When the Al-PEISA combination was applied to a complex matrix where Cd (II), Cu (II) and Ni (II) ions competed for adsorption, enhanced adsorption was observed for Cd (II) and Ni (II). At pH 7, dissolution of the floc observed with the addition of discrete chelates was not observed with the addition of polyelectrolytes.     

Semi-volatile organic compounds in the Campaspe River system (Victoria, Australia)

The levels of semi-volatile organic compounds (SVOCs) in the Campaspe River system, North Central Victoria, Australia, were monitored from January to September 1995, and the environmental trends and sources of these compounds were determined. The land use within particular catchments dictated the complexity of the SVOCs in run-off water. Run-off from native forest contained the greatest number of SVOCs. Soil and ground litter were shown to contain the greatest complexity of SVOCs, mostly terpenes. However, only a small proportion were leached by run-off with the remainder being tightly bound to the soil or volatilizing to the atmosphere. Under the prevailing drought of early 1995, the rivers contained no detectable SVOCs until the first catchment run-off after significant rainfall in May. The maximum complexity and concentration of the SVOCs coincided with extensive run-off after heavy rainfall in June, effecting a surge of SVOCs with the flood peak. Fatty acids, their amides and hydrocarbons made up the majority of the compounds identified and were in the 1-39 micrograms/l concentration range. The levels then diminished as the catchment was flushed by continual run-off. These results support Lake's 1967 hypothesis that natural floodwaters contain a signature of SVOCs entering from the catchment. The downstream passage of these compounds was obstructed by a man-made storage, Lake Eppalock, with only low concentrations of SVOCs (1-3 micrograms/l) in the outflow, displaying no correlation to run-off.     

Mercury contamination in fish from gold mining areas in Indonesia and human health risk assessment

This study investigates the effects on fish and assesses human health hazards from mercury released in two gold mining areas in Indonesia: Tatelu (North Sulawesi Province) and Galangan (Katingan District, Central Kalimatan Province). In Tatelu, 154 fish specimens of 10 freshwater species were collected, as well as five marine species from the fish market. The mean concentration of total mercury in muscles of freshwater fish from this area was 0.58+/-0.44 microg/g, with more than 45% of fish having Hg levels above the WHO guideline for human consumption of 0.5 microg/g. In Galangan, where 263 fish specimens of 25 species were collected, the total mercury in muscles averaged 0.25+/-0.69 microg/g. Excluding data from flooded open pits in sub-area P4, mean Hg levels in fish from Galangan were 2 to 4 times lower than 0.5 microg/g, while fewer than 10% of fish from Galangan exceeded WHO guidelines. The Hazard Quotient (HQ) was applied to both areas to determine the threat of MeHg exposure for communities in both areas. The HQ is a risk assessment indicator which defines the ratio of exposure level to a single substance in relation to a reference dose. Samples from Tatelu (excluding marine species) had an HQ above one, while those from Galangan resulted in values of 2.4 for the whole area and 9.9 for sub-area P4, pointing to potentially harmful fish consumption for the local population. By using the single-compartment model to estimate mercury levels in blood and hair from daily intake dose, sub-area P4 showed the highest levels, higher than the upper limit guideline for pregnant women, but still lower than threshold levels associated with observed clinical effects.