Colloidal silica removal in coagulation processes for wastewater reuse in a high-tech industrial park.

Four experiments of coagulation and flocculation were conducted to investigate the characteristics of colloidal silica removal in a high-tech industrial wastewater treatment plant for reclamation and reuse of the effluent. Experimental results illustrated that poly-aluminium chloride (PACl) showed higher performances on colloidal silica removal than alum. Interestingly, the two coagulants demonstrated the same capacity on silica removal. The specific silica removal capacity was approximately 0.135 mg SiO2/mg Al2O3 when the dosage of coagulants was in the range 30-150 mg/L Al2O3. In addition, the silica was reduced significantly at the condition of pH above 8. Experimental data implied that precipitation of aluminium flocs was the major mechanism for colloid silica removal in PACl and alum coagulation, besides, charge adsorption was also important for improving removal efficiency. Moreover, the addition of polyacrylic acid (PAA) as a flocculant could slightly advance silica removal in the PACl coagulation. The combined PACl/PAA/flocs coagulation was effective for the removal of colloidal silica, soluble COD, and turbidity and also suitable as a pretreatment unit in wastewater reclamation and reuse processes.     

钇铁石榴石薄膜材料的光吸收谱及Bi,Al掺入对谱的影响研究

采用单离子晶场跃迁模型，拟合出钇铁石榴石（ＹＩＧ）薄膜材料的光吸收谱，与实验谱吻合得较好。从实验和理论上分析了（ＢＩＡＩ）ＹＩＧ 薄膜材料的光吸收谱，结果表明，Ａｌ３＋离子的作用如同稀释剂一样，减小了光吸收，Ｂｉ３＋离子由于其强的自旋轨道耦合作用，增大了跃迁振子强度和跃迁线宽，从而增大了光吸收损耗，在此基础上所作的（ＢｉＡｌ）ＹＩＧ的理论谱与实验谱符合得较好。     

Observation of atomic steps on CaCO3 crystal surface

By using scanning polarization force microscopy,the deliquescence process and the atomic steps on the cleavage surface of CaCO3 in air were studied in situ.Under an exposure to medium umidity(-57%),the sloiw step movement has been observed.     

On the current delivery limit of semiconducting carbon nanotubes

The current carrying capacity of single-walled semiconducting carbon nanotubes (CNTs) is studied by self-consistent quantum simulations using the non-equilibrium Green’s function formalism with the self-consistent Born approximation. The simulation shows that the current carrying capacity depends on the bias regime and is drastically different from that of metallic tubes. For long CNTs (with a length much longer than zone boundary and optical phonon scattering mean free path), the current saturates around 20 μA in the forward bias regime with unipolar transport due to phonon scattering. In ambipolar transport regime, the current delivery limit is still about 20 μA due to recombination of electron and hole currents. In contrast, for short semiconducting CNTs, the current delivery capacity can be above 25 μA in the unipolar transport regime and further double in the ambipolar transport regime. In reverse bias regime, the current of a long CNT can exceed 20 μA due to the second subband conduction and increased electron injection from the drain. The simulation provides a coherent explanation to the dependence of current delivery limit on bias regime and channel length, which is consistent with recent experiments.     

寄生电容不敏感的开关电容乘法器的设计与分析

本文论述了寄生电容不敏感型开关电容四象限模拟乘法器的设计，并提出了一种新型的电路结构，分析了它的性能，以及元器件的非理想特性对其性能的影响和采取的补偿方法。     

致力于持续增长的战略——在2002年信息产业经济年会上的演讲(摘要)

在电信业,设备制造商采取了两种截然不同的战略,即中国通讯厂商的紧缩战略和国外跨国公司的扩张战略。国内通讯企业实现持续增长面临着从投资增长型向效益增长型的转变和加入世贸组织后的冲击和考验。普天公司在寻找持续增长的道路时,恪守的理念是:品牌至上、合作共赢、关注产业链、激活组织。     

Geometry-Dependent R-Curve for Quasi-Brittle Materials

Fracture of quasi-brittle materials such as ceramics and cement-based materials can be described by an R -curve, defined as fracture resistance. The R -curve can be constructed as the envelope of the strain energy release rates ( G ). In this study, R -curve is defined as an envelope of G -curves obtained by varying the dimensions of identical specimens, while keeping the geometry and the initial flaw size constant. By approximating the G -curve with a second-order function of the crack length, a simple formulation of the R -curve is derived by solving a differential equation. Three parameters are needed for the proposed R -curve. These parameters can be obtained by testing a notched-beam specimen and using linear elastic fracture mechanics. The proposed R -curve simulates well the geometry dependency as well as other characteristics of the fracture response of quasi-brittle materials.     

葡萄糖电解氧化还原工艺研究

采用自制的无膜电解槽，对同时电解氧化还原葡萄糖生成葡萄糖酸和山梨醇的工艺进行了研究。所得到的最佳工艺条件为：葡萄糖浓度０．４ｍｏｌ／Ｌ，ｐＨ值１１，电流密度３Ａ／ｄｍ￣２。在此条件下电解１２ｈ，葡萄糖转化率可达９６．４％，葡萄糖酸产率８８％，山梨醇产率１０％。同时，考察了和Ｚｎ￣（２＋）加入以及ｐＨ值对电流效率的影响。     

High performance liquid chromatography mobile phase composition optimization for the quantitative determination of a carboxylic acid compound in human plasma by negative ion electrospray high performance liquid chromatography tandem mass spectrometry

A systematic investigation was undertaken to study the effects of varying concentrations of additives in the acetonitrile/water high performance liquid chromatography mobile phase, especially formic acid and ammonium formate, on the negative ion electrospray response of a carboxylic acid compound. The study showed that the response progressively decreased with increase in the formic acid concentration. While such a decrease in the response could be qualitatively explained by the decrease in the concentration of the ionized form of the carboxylic acid compound due to the lower pH of the mobile phase, the change in response was not as large as expected from the change of the concentration of the ionized form. The response also progressively decreased with increase in the ammonium formate concentration but the decrease cannot be explained by the change in the pH of the mobile phase. Although the best negative ion electrospray response was obtained with a water/acetonitrile mobile phase that contained no additives at all, the retention time of the analyte was not found to be adequately reproducible on repeated injections. Thus, this mobile phase was deemed unacceptable for practical, routine use. Comparing formic acid against ammonium formate, the former was preferable since it caused a smaller attenuation of the negative ion response. Equally important was the fact that addition of formic acid had the desirable effect of maintaining a reasonably high capacity factor (k') for the analyte even at a relatively high acetonitrile concentration. A concentration of 1 mM formic acid in the mobile phase was large enough to achieve the reproducible elongated retention time for the analyte, with a loss in the analyte response of about 60% only. It should be noted that the sensitivity achieved with the 1 mM formic acid mobile phase, in which the carboxylic acid is expected to be about 10% in the ionized form, is about 9 times better than the sensitivity achieved in the 1 mM ammonium formate mobile phase, in which the carboxylic acid is expected to be about 99% in the ionized form.     

Osteogenesis of electrically stimulated bone cells mediated in part by calcium ions

Culture selected and expanded osteoblastic cells may be able to be reintroduced into massive skeletal defects to accelerate cell mediated regeneration of skeletal tissues, especially in bone ingrowth in total joint replacement, fracture healing, and osteoporosis. In vitro osteogenic cell culture is a useful model in studying the mechanism of bone metabolism under direct current stimulation. In this study, an osteoblastlike cell line was isolated from newborn rat calvaria. The osteogenic processes of the in vitro cultured cell line were studied by cytochemical, electron microscopic, and energy dispersive x-ray analysis techniques that resembled those observed in membrane bone ossification centers in vivo. Direct current stimulation of 100 microA/cm2 accelerated greatly the proliferation and calcification of the in vitro cultured cells. Intracellular free calcium ion metabolism was measured with an Adherent Cell Analysis and Sorting Machine. Under direct current stimulation, intracellular free calcium ion concentration increased an average of 2.3 times of the original level, which may play a key role in regulating osteogenesis and bone metabolism.