A new space-vector-modulated control for a unidirectionalthree-phase switch-mode rectifier

A unidirectional three-phase switch-mode rectifier that delivers sinusoidal input currents in phase with the corresponding input phase voltages is proposed and analyzed in this paper. In the proposed topology, three AC switches are placed before the bridge rectifier and, respectively, across two power lines. A simple control scheme combing space-vector modulation and hysteresis current control is presented. Sinusoidal input line currents are observed in experimental results     

Performance evaluation of a multichannel transceiver system forADSL and VHDSL services

The authors study the performance of a multichannel modulation method for asymmetric digital subscriber lines (ADSLs) and very high-speed digital subscriber lines (VHDSLs). In the ADSL case, over all unloaded North American subscriber lines in the test set, a unidirectional 1.536 Mb/s data rate service from the end office to the customer premises is possible on a single twisted pair at an error rate of 10^-7 with at least a 6 dB margin used coded multichannel modulation with sufficient transmit power. In the VHDSL case, data rates in excess of 100 Mb/s can be transmitted reliably, at an error rate of 10^-7, using uncoded multichannel modulation on a single twisted pair over a distance ⩽150 ft with a sufficiently high sampling rate (≈24 MHz) and transmit power. It is shown that a cost-effective multichannel transceiver design suggested for high-speed digital subscriber line (HDSL) service will also work well for ADSL and VHDSL services with only minimal modifications     

Stability of Mixtoxantrone Hydrochloride in Solution

A stability-indicating reversed-phase high performance liquid chromatographic method was developed for the detection of mitoxantrone HC1 and its degradation products under accelerated degradation conditions. The degradation kinetics of mitoxantrone HC1 in aqueous solution over a pH range of 1.18 to 7.20 and its stability in propylene glycol-or polyethylene glycol 400-based solutions were investigated. The observed rate constants were shown to follow apparent first-order kinetics in all cases. The pH-rate profile shows that maximum stability of mitoxantrone HC1 was obtained at pH 4.01. No general acid or base catalysis from acetate or phosphate buffer species was observed. The catalysis rate constants on the protonated mitoxantrone imposed by hydrogen ion water and hydroxy ion were determined to be 3.72 × 10 min^-1 5.64 × 10-min^-1 and 1.108 × 10^-2min^-1, respectively. The degradation rate constants of mitoxantrone affected by different ionic strength systems. Irradiation with 254 nm UV light at 25±0.5°C was found when canpared with the light-protected controls. Incorporation of nonaqueous propylene glycol or polyethylene glycol in the pH 4.01 mitoxantrone solution shows an increase in its stability at 502±0.5°C.     

工业废渣磷石膏用作充填材料的研究

研制了以工业废渣磷石膏为基材的充填材料.改性后磷石膏的耐水性大大增强,抗压强度≥0.79 MPa、渗透系数≤1×10-5cm.s-1,并且具有合适的C、Φ值.     

基于SPI双机通信的弧光保护系统

针对弧光保护系统的实际需要,设计了一种基于SPI的双机通信系统。简要阐述了该系统的设计思路,并给出了具体的实现方法。实验表明,采用该方法能够满足实际工程中的需求,对于其他SPI的应用也有很好的借鉴价值。     

Perforating pseudoxanthoma elasticum. Its distinction from elastosis perforans serpiginosa

It is not generally appreciated that pseudoxanthoma elasticum (PXE) can be associated with epidermal perforation by elastic fibers. We report an example of this phenomenon. The term "perforating PXE" is suggested and a distinction is made from elastosis perforans serpiginosa (EPS). We believe that most reported cases of coexistence of PXE and EPS are perforating PXE and that the coexistence of EPS has not been clearly demonstrated.     

基于Internet的空分设备远程监视与故障诊断专家系统的研究

简介了远程监视与故障诊断专家系统在国内空分设备中应用的实际意义，着重分析了大型空分设备远程监视与故障诊断专家系统中远程监视模块和故障诊断模块的开发。     

造纸过程水分智能控制

针对造纸过程的复杂性、工艺特点及要求，本文对造纸过程的水分控制，提出模糊控制和专家系统结合的智能控制方法。实践证明该控制器满足了造纸过程对水分的工艺要求，且具有良好的鲁棒性。     

圆柱体质心测量中转角取值分析

为获得质量非均匀圆柱体质心的三维坐标，测量时需使圆柱体转过一定的角度。分析表明，转角最好取为90度以获得最佳测量效果。如果受条件限制，宜在45度到90度之间选取，尽量避免取小于30度的值。