An inhibitor of DNA topoisomerase I from Xenopus laevis ovaries

A novel, heat-resistant and Pronase-sensitive, inhibitor of eukaryotic DNA topoisomerase I has been purified from Xenopus laevis ovaries. Sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) of the most purified fraction revealed three bands with apparent molecular masses of 25, 28.5, and 33.5 kDa. The 25- and 33.5-kDa peptides recovered from an SDS-PAGE gel inhibited X. laevis DNA topoisomerase I. The purified inhibitor was specific to DNA topoisomerase I and did not inhibit other DNA enzymes tested. The inhibitor blocked the catalytic activity of DNA topoisomerase I by interacting with the enzyme, rather than by competing for binding sites on substrate DNA. Binding of DNA topoisomerase I to substrate DNA was blocked by the inhibitor, as was the cleavage reaction catalyzed by DNA topoisomerase I. Inhibition of DNA topoisomerase I was relieved by divalent cations Ca2+, Mg2+, or Mn2+.     

Ultrasound‐activated Knoevenagel condensation of malononitrile with carbonylic compounds catalysed by alkaline‐doped saponites

α,β‐Unsaturated nitriles have been synthesized by Knoevenagel condensation of a carbonylic compound with malononitrile, assisted by sonochemical irradiation. Two alkaline‐promoted clays (Li⁺‐ and Cs⁺‐exchanged saponites) have been employed as catalysts. The influence of the carbonylic compound (benzaldehyde or cyclohexanone) and the use of a solvent on the catalytic activity have been studied. Remarkable increase in the conversion values has been found when the reaction is activated by ultrasound, as compared with the thermal activation. In this green, solvent‐free procedure, α,β‐unsaturated nitriles have been produced in very high yields (97%) when the Cs⁺‐saponite is used as catalyst. Copyright © 2004 Society of Chemical Industry     

The influence of preparation conditions on the electrochemical behaviour of CuO in a Li/CuO cell

A dozen CuO samples prepared under various conditions and from different starting materials were evaluated as cathode materials for a primary Li/CuO cell. The “thin electrode” method was used for rapid evaluation of the samples. Both coulombic efficiency and discharge voltage depend considerably on the method of synthesis. No correlation was found between the specific surface area and the resistivity of the samples on the one hand and the cathode performance on the other. Best results were obtained from CuO prepared by the oxidation of Cu₂O under controlled temperature and time of oxidation.     

Lithium/lithium vanadium oxide secondary batteries: IV. Evaluation of factors affecting the performance of test cells

With the aim of optimizing the performance of Li/Li_1+xV₃O₈ cells, several aspects of cathode preparation have been examined. The influence of synthesis technique, nature and amount of conductive additives, compacting pressure, cathode loading, and particle size, has been investigated. Furthermore, the role played by the solutions on cathode efficiency has been outlined. The formulations which perform best are based on small-sized particles blended with about 20% acetylene black and compacted at very high pressures to improve the contact between particles. Such cathodes can provide high capacities at high rates and good cycling efficiencies. The kinetic loss of capacity, observed during the first few cycles, may be alleviated by choosing solutions with high fluidity and conductivity.     

Application of a general health policy model in the American health care crisis

There is near consensus that the US health care system requires reform. Only a quarter of the American public has faith in the current system. Health care was one of the major issues considered in the 1992 US presidential election and the search for innovative solutions has transcended administrations.