Optimized partitioning of a wavelength distributed data interfacering network

A fiber optic ring network, such as fiber distributed data interface (FDDI), can be operated over multiple wavelengths on its existing fiber plant consisting of point-to-point fiber links. Using wavelength division multiplexing (WDM) technology, FDDI nodes can be partitioned to operate over multiple subnetworks, with each subnetwork operating independently on a different wavelength, and inter-subnetwork traffic forwarding performed by a bridge. For this multiwavelength version of FDDI, which we refer to as wavelength distributed data interface (WDDI), we examine the necessary upgrades to the architecture of a FDDI node, including its possibility to serve as a bridge. The main motivation behind this study is that, as network traffic scales beyond (the single-wavelength) FDDI's information-carrying capacity, its multiwavelength version, WDDI, can gracefully accommodate such traffic growth. A number of design choices exist in constructing a good WDDI network. Specifically, we investigate algorithms using which, based on prevailing traffic conditions, partitioning of nodes into subnetworks can be performed in an optimized fashion. Our algorithms partition the nodes into subrings, such that the total traffic flow in the network and/or the network-wide average packet delay is minimized     

Radiation-Induced graft copolymerization of methacrylic acid onto polypropylene fibers. V. Mechanical properties

Mechanical properties of polypropylene-g-poly(methacrylic acid) fibers, prepared by graft copolymerization of methacrylic acid onto polypropylene fiber using simultaneous gamma ray irradiation technique, were evaluated. In general, an improvement in the mechanical behavior of the polypropylene fiber by grafting was observed. Denier and initial modulus of the fiber showed a linear increase with the percent graft, and elongation showed an opposite trend. The results have been explained in terms of reinforcing effect of poly(methacrylic acid) grafts and reduction in the segmental mobility of the polymeric chains. Tenacity also increases up to certain graft level, beyond which a sharp decrease occurs, probably due to the influence on the compactness of the macromolecular chains with the further grafting.     

Simplified steady-state model of an SCR-inverter-basedload-commutated commutatorless series motor

This paper presents a simplified analytical model of a silicon-controlled-rectifier based, load-commutated inverter driven, commutatorless series motor to predict its speed-current, torque-current and torque-speed characteristics. The model has been formulated, keeping in view the steady state equivalent circuit of a conventional DC series motor. The proposed analytical expressions relating torque and current with speed are found to follow an inverse law and that relating torque and current is found to be parabolic, as is expected in a "series" machine. The drive has been implemented, loaded with a DC generator and experimentally similar characteristics have been obtained, as predicted by the analytical model. The characteristics obtained experimentally are seen to follow the ones, predicted by the analytical model closely     

Kinetics study of Ti[O(CH2)4OCHCH2]4 initiated ring‐opening polymerization of ε‐caprolactone by differential scanning calorimetry

Chemical shrinkage was used for the in situ measurement of the progressing chemical stabilization reactions and the influence of ozone during the stabilization of polyacrylonitrile. A method for evaluating the activation energy through the sensitivity temperature is presented. The calculated results show that the activation energies were 161.57 kJ/mol in air and 181.23 kJ/mol in ozone-enriched air. Therefore, the chemical reactions were postponed during stabilization in ozone-enriched air. Ozone seemed to act in three ways: first, ozone promoted the formation of the serious skin–core structure. Second, ozone accelerated the chemical reactions and shortened the stabilization time at lower heating rates. Third, ozone postponed the chemical reactions. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

Channel sharing in multi-hop WDM lightwave networks: realizationand performance of multicast traffic

A local lightwave network can be constructed by employing two-way fibers to connect nodes in a passive-star physical topology, and the available optical bandwidth may be effectively accessed by the nodal transmitters and receivers at electronic rates using wavelength division multiplexing (WDM). The number of channels, ω, in a WDM network is limited by technology and is usually less than the number of nodes, N, in the network. We provide a general method using channel sharing to construct practical multi-hop networks under this limitation. Channel sharing may be achieved through time division multiplexing. The method is applied to a generalized shuffle-exchange-based multi-hop architecture, called GEMNET. Multicasting-the ability to transmit information from a single source node to multiple destination nodes-is becoming an important requirement in high-performance networks. Multicasting, if improperly implemented, can be bandwidth-abusive. Channel sharing is one approach toward efficient management of multicast traffic. We develop a general modeling procedure for the analysis of multicast (point-to-multipoint) traffic in shared-channel, multihop WDM networks. The analysis is comprehensive in that it considers all components of delay that packets in the network experience-namely, synchronization, queuing, transmission, and propagation. The results show that, in the presence of multicast traffic, WDM networks with ω相似文献   

Descriptive epidemiology of childhood cancers in Bangalore, India

While fairly complete and reliable incident data on childhood cancers are available from the registries in India, mortality and survival information is not. Information concerning the latter was obtained by the Bangalore cancer registry through active follow-up involving visits to homes of patients. Between 1982 and 1989, 617 cases of cancers in childhood were registered, giving an age-standardized incidence rate of 84.8 and 48.4 per million in male and female children, respectively. Active follow-up provided mortality/survival information in 532 or 86.2 percent of these cases. Overall, observed five-year survival was 36.8 percent (both genders combined) with a relative survival of 37.5 percent when childhood mortality in the general population was taken into account. The five-year relative survival was best for thyroid carcinoma (100 percent) followed by Hodgkin's disease (73 percent) and retinoblastoma (72.9 percent). Survival was comparatively low, being 9.9 percent in acute nonlymphatic leukemia and less than 20 percent in rhabdomyosarcoma and the category grouped as 'other malignant neoplasms.' Survival in Hodgkin's disease was influenced by clinical stage at presentation, but was not statistically significant possibly due to small numbers.     

The design,analysis, and cost estimation of a generic adder and subtractor using the layered T (LT) logic reduction methodology with a quantum-dot cellular-automata-based approach

The quantum-dot cellular automata (QCA) is considered to be one of the ground-breaking nanotechnologies developed over the last two decades. A layered T (LT) logic cell library is constructed herein, and the methodology is extended to generic adder and subtractor module designs. The two proposed algorithms lead to more efficient QCA layout designs for an n-bit ripple carry adder (RCA) and subtractor based on an effective clock zone assignment approach. The suggested one-, four-, and eight-bit RCAs and subtractors surpass most of their existing counterparts by offering lower effective area and cell complexity. A comparative analysis is presented regarding the complexity, irreversible power dissipation, and Cost_α of the proposed n-bit layouts from a cost estimation purview.