Synthesis and analysis of transformer-isolated converters

A systematic and straightforward procedure is developed for the synthesis and analysis of transformer-isolated power converters. The procedure can be used to determine the ranges of duty-ratio over which the transformer-isolated power converters of a given class can be operated without transformer saturation. The procedure can also be used to study the dependence of the power converter switch stresses on duty-ratios. This information is useful in the selection of the transformer-isolated power converter most suitable for a given application and in the design of this power converter with minimum switch stresses, high power density, and low cost     

Acidogenic fermentation of blended food‐waste in combination with primary sludge for the production of volatile fatty acids

The performance of a laboratory‐scale anaerobic acidogenic fermenter fed with a mixture of blended kitchen food‐waste and primary sludge from a sewage treatment plant was investigated for the production of volatile fatty acids (VFA). The operating variables for acidogenic fermentation were kitchen food‐waste content (10 and 25 wt %), hydraulic retention time (HRT: 1, 3 and 5 days), temperature (ambient: 18 ± 2 °C, and mesophilic: 35 ± 2 °C) and pH (varied from 5.2 to 6.7). The experimental results indicated that effluent VFA concentrations and VFA production rates were higher at ambient temperature than at mesophilic conditions. The net amount of VFA with 10 wt % food‐waste increased up to 920 mg dm^?3 with an increase of HRT, but contrasting results (a decrease of 2610 mg dm^?3) were found due to the conversion of VFA into biogas in the case of 25 wt % food‐waste, which increased significantly at HRT of 3–5 days. In terms of biogas composition (CO₂ and CH₄), the organic matter was converted into CO₂ through the oxidative pathway by facultative species at low temperature while mesophilic temperature and optimum pH (6.3–7.8) played a pivotal role in increasing rate of conversion of VFA into biogas by methanogenesis. Rates of VFA production and their conversion are dependent on the food‐waste content in the mixture. Yet, the higher concentration of food‐waste (25% compared with 10%) did not produce VFA proportionally due to the increased rate of conversion of VFA into gaseous products. The maximum VFA production rate (0.318 g VFA_produced g^?1 VS_fed day^?1) was achieved in the 10 wt % food‐waste at ambient temperature and at a 5‐day HRT. Copyright © 2005 Society of Chemical Industry     

Capacitor coupled converter (C3) for high power DCconversion

The bang-bang controlled capacitor coupled converter (C³) is described in this paper. Due to the converter's inherent commutating property, the C³ can accommodate thyristors as well as high-power gate turn-off switches, due to zero-current switching transitions. The zero-current switching is achieved at no current stress increase, therefore, the topology is considered appropriate for high-power processing. DC and small signal AC models are derived for the bang-bang controlled C³, a design procedure is proposed, and simulation results are discussed. Finally, oscillograms from a proof of principle prototype circuit are presented     

Photochemical oxidation of fatty acid esters with and without chlorophyll

1. It has been confirmed that the principal products formed in the oxidation of methyl oleate by oxygen under a variety of conditions are predominantlytrans hydroperoxides. However no inversion of the double bond occurs in unoxidized oleate. Hence the conversion ofcis totrans double bonds and peroxide formation occur together in the same molecules.
2. The autoxidation of methyl linoleate at low temperature yields predominantlycis,trans conjugated hydroperoxides. Autoxidation at 25°C., oxidation catalyzed by visible light, or ultraviolet light and copper soap catalyzed oxidation at temperatures appreciably above 0°C., lead to the formation primarily oftrans,trans conjugated hydroperoxides. The inversion of the second double bond in this case appears to be independent of the peroxide-forming reactions.
3. The photochlorophyll oxidation of methyl linoleate leads to the formation of some unconjugated hydroperoxides, some of which containtrans double bonds.
4. Under all of the conditions employed in the present investigation, the oxidation of methyl oleate and linoleate led primarily to the formation of monomeric peroxides which retained most of the unsaturation of the parent compound.

     

Prediction of the viscosities of liquid mixtures by a group solution model

Group solution models of liquid mixtures have been used previously to predict thermodynamic properties of non-ideal systems. A model of this type has been developed which enables the viscosities of liquid mixtures to be predicted. The concept of an “ideal viscosity” is introduced, and allowance made for the interaction between the groups present and for the structural contributions of differing molecules. Predictions require a knowledge of only the viscosities of the pure components of a mixture. It has been tested for mixtures of alkanes, alcohols and water at 25°C, and gives good agreement with experiment. Experimental viscosities for ethanol/n-hexane, for n-propanol/water, and for four multi-component mixtures at 25°C are presented.     

Oxidation of Branched Chain Fatty Acids by Chromic Acid

The kinetics of oxidation of isobutyric and isovaleric acids by chromic acid in sulphuric acid medium have been studied. The end product acetic acid is supposed to be derived from the ketones which are the initial oxidation products of the corresponding branched chain fatty acids. The influence of acetic acid on the oxidation velocity has been examined and a marked effect on the rate constants with increasing acetic acid concentration has been observed. A mechanism involving the electrophilic attack of the oxidant on the tertiary carbon atom of the fatty acid to yield a carbonium ion has been postulated.     

Lithium/V6O13 cells using silica nanoparticle-based composite electrolyte

The electrochemical behavior of Li/V₆O₁₃ cells is investigated at room temperature (22 °C) both in liquid electrolyte consisting of oligomeric poly(ethyleneglycol)dimethylether+lithium bis(trifluoromethylsulfonylimide) and composite electrolytes formed by blending the liquid electrolyte with silica nanoparticles (fumed silica). The addition of fumed silica yields a gel-like electrolyte that demonstrates the desirable property of suppressing lithium dendrite growth due to the rigidity and immobility of the electrolyte structure. The lithium/electrolyte interfacial resistance for composite gel electrolytes is less than that for the corresponding base-liquid electrolyte, and the charge-discharge cycle performance and electrochemical efficiency for the Li/V₆O₁₃ cell is significantly improved. The effect of fumed silica surface group on the electrochemical performance is discussed; the native hydrophilic silanol surface group appears better than fumed silica that is modified with a hydrophobic octyl surface moiety.     

Earthquake onset detection using spectro-ratio on multi-threshold time–frequency sub-band

Automatic onset detection and picking algorithm has been proposed by applying the spectro-ratio on time–frequency sub-band. The proposed algorithm does not need any parameter settings as it will work on data generated by either short or very broad band seismometers. Our algorithm is applied on local events from Cairo region recorded by three stations of the Egyptian National Seismic Network (ENSN). Maximum standard deviation is observed to be 0.113 s of the corresponding manual picks made by analysts.     

Greenhouse gases mitigation by CO<Subscript>2</Subscript> reforming of methane to hydrogen-rich syngas using praseodymium oxide supported cobalt catalyst

This study focuses on the potential of hydrogen-rich syngas production by CO₂ reforming of methane over Co/Pr₂O₃ catalyst. The Co/Pr₂O₃ catalyst was synthesized via wet-impregnation method and characterized for physicochemical properties by TGA, XRD, BET, H₂-TPR, FESEM, EDX, and FTIR. The CO₂ reforming of methane over the as-synthesized catalyst was studied in a tubular stainless steel fixed-bed reactor at feed ratio ranged 0.1–1.0, temperature ranged 923–1023 K, and gas hourly space velocity (GHSV) of 30,000 h^?1 under atmospheric pressure condition. The catalyst activity studies showed that the increase in the reaction temperature from 923 to 1023 K and feed ratio from 0.1 to 1.0 resulted in a corresponding increase in the reactant’s conversion and the product’s yields. At 1023 K and feed ratio of 1.0, the activity of the Co/Pr₂O₃ catalyst climaxed with CH₄ and CO₂ conversions of 41.49 and 42.36 %. Moreover, the catalyst activity at 1023 K and feed ratio of 1.0 resulted in the production of H₂ and CO yields of 40.7 and 40.90 %, respectively. The syngas produced was estimated to have H₂:CO ratio of 0.995, making it suitable as chemical building blocks for the production of oxygenated fuel and other value-added chemicals. The used Co/Pr₂O₃ catalyst which was characterized by TPO, XRD, and SEM-EDX show some evidence of carbon formation and deposition on its surface.