在线安全预警和决策支持系统的软件构架与实现

安全预警和决策支持（EWSC）系统作为未来控制中心自动化系统的重要功能，一方面需要对能量管理系统（EMS）成熟功能进行封装，另一方面需要适应自动化系统功能演变的需要。提出了一种基于多代理系统（MAS）的软件开发范式，用于开发EWSC系统的软件构架。该系统具有一个松散、开放的可插入式结构。其中核心框架是负责系统通信和任务调度的协调层，是相对固定的;其余部分为独立模块，由一系列相对独立的决策分析和人机表达智能体组成，可以独立开发，方便地嵌入系统。在该框架下系统各个模块层次分明，具有很强的解耦性，并且可以实现把历史遗留系统集成到新的环境中。基于文中所提出的软件构架的在线EWSC系统已在某省级电网投运。     

浅谈气泡混合轻质土的特点及应用

结合高速公路的发展,分析了气泡混合轻质土的设计机理,详细地介绍了气泡混合轻质土的工程特性,阐述了气泡混合轻质土在公路建设中的应用,最后对气泡混合轻质土的应用前景进行了展望。     

部分可渗透直立圆柱的消波作用研究

本文导出了线性波浪作用于上部可渗透的直立刚性圆柱体上的水动力的解析解。在线性有势流的假定下，用特征函数展开方法求出了内部和外部流场的解。给出了不同波浪要素及结构尺寸参数下的数值结果。由结果可知，提高可渗透性可以有效消减波幅。     

Evaluation of Morphology—Stable Critical Size of KNbO3 Crystals

Skeletal form of KnbO3 crystals growing in Li2B4O7 solvent was in-situ observed at 900℃ and it was found that shallow depression started to develop on the surface of KnbO3 crystals when the crystal size exceeded several micron,typically 7 micron.Based on the quantitative criterion derived by Chernov,the estimated critical size of KNbO3 crystals was 1 micron,which was consistent with the experimental measurement.The kinetic coefficients,Kcorner and Kcr,in the criterion were experimentally obtained in the diffusive-convective and diffusive-advective flow states respectively.     

A time aggregation approach to Markov decision processes

We propose a time aggregation approach for the solution of infinite horizon average cost Markov decision processes via policy iteration. In this approach, policy update is only carried out when the process visits a subset of the state space. As in state aggregation, this approach leads to a reduced state space, which may lead to a substantial reduction in computational and storage requirements, especially for problems with certain structural properties. However, in contrast to state aggregation, which generally results in an approximate model due to the loss of Markov property, time aggregation suffers no loss of accuracy, because the Markov property is preserved. Single sample path-based estimation algorithms are developed that allow the time aggregation approach to be implemented on-line for practical systems. Some numerical and simulation examples are presented to illustrate the ideas and potential computational savings.     

对氧化物熔体浮区中重力对流的数值模拟

利用有限元分析方法数值模拟了界面形状对氧化物高温熔体碟形浮区中的温度分布和重力对流速率的影响，发现界面形状对重力对流速率有较大的影响，对于凸面，相对于炉圈平面5％的偏离使重力对流速率增大25％，偏离越大，重力对流速度越大，对于凹面，5％的偏离使重力对流速率减小15．7％，偏离越大，重力对流速度越小。     

Properties of latex blends and its modified cement mortars

In this paper, the mechanical properties of three latex blends and the mechanical properties and chloride diffusivity of the latex-modified mortars are studied. The relationships between the properties of polymer films formed from latex blends and the properties of the latex blend-modified mortars are illustrated. The test results showed that the modified mortar with the blend of styrene-acrylic ester (SAE) and styrene-butadiene rubber (SBR) showed synergistic effect; especially the flexural strength of the SAE/SBR blend-modified mortars was about 20-40% higher than that of monolatex-modified mortars. However, the vinyl chloride-vinylidene chloride copolymer (PVDC)/SBR and PVDC/SAE blends-modified mortars showed antisynergistic effect. The compressive strength of the modified mortars increased with the increasing of the tensile strength of the latex films, while the flexural strength of the modified mortars did not depend on the tensile strength of the latex films. When PVDC with the mass fraction of 0.2 or SAE copolymer emulsion with mass fraction of 0.4 was blended into SBR latex, the latex blend-modified mortars showed lower chloride diffusivity. The chloride diffusivity of the modified mortars increased approximately linear with the tensile strength of the latex blend films, and decreased with increase of the elongation at rupture of the latex blend films. When the elongation at rupture of the latex blend films increased from 200-300% to more than 800%, the chloride diffusivity of the modified mortars decreased from 10-15×10⁻¹² to 3-4×10⁻¹² m²/s.     

活化铁矿粉技术及其效果评价

随勘探技术发展,高压超高压油气井日益增多,高密度、超高密度钻井液使用也越来越多.室内为配制密度大干2.4 g/cm3的超高密度钻井液,采用铁矿粉作为加重剂,并通过表面活化的原理对铁矿粉进行表面处理,以提高钻井液的固相容纳能力.该活化工艺借鉴了国内外相关产品的技术特点,以优选的表面活性剂为主要活化材料,并添加了无机盐和硅酸盐作为助吸附材料,提高了活化效果.室内实验表明,用活化铁矿粉加重的钻井液体系能保持良好的流变性和悬浮能力,能保证钻进时的正常循环,并且摩阻系数也低于常规铁矿粉加重钻井液.     

Bright Blue Light—emitting Diodes Based on a Novel Fluorescent Dye Containing Heterocyclic Groups

Novel molecular material ,1-benzothiazoly-3-pheny1-pyrazoline (BTPP) was found to function as bright blue light emitting dye in organic electroluminescent device, and its optical and electric characteristics were investigated. This heterovyclic compound exhibited good characteristics of blue photoluminescence and electroluminescence,which had the emission peak at 450nm .The single layer light-emitting devices using BTPP as light -emitting material dispersed in poly(N-vinylcarbazole)(PVK) and double layer ones using PBD as hole block layer above the light-emitting layer were fabricated using conventional spin-casting and vaccum vapour deposition methods. The introduction of PBD has enhanced electron injection and luminance efficiency, compared with the single layer LEDs.     

用变角XPS定量分析研究GaAs光电阴极激活工艺

用变角X射线光电子能谱 (XPS)技术分析了GaAs光电阴极的激活工艺 ,定量计算了阴极表面激活层和界面氧化层的厚度和组成。界面氧化物是由于O原子穿过激活层 ,扩散到GaAs与 (Cs,O)激活层的界面上而形成的。导入过量O会增加O GaAs界面层的厚度 ,而对 (Cs,O)激活层厚度影响较小。在激活过程中 ,严格控制和减少每次导入的O量是减少界面氧化层厚度 ,提高灵敏度的重要途径。在第一步激活后的阴极样品 ,通过较低温度的加热和再激活 ,能获得比第一步高出 30 %的光电灵敏度的原因是较低温度加热减少了界面氧化层的厚度和界面势垒