Collective modes and a theory of response ofd-wave superconductors

We present a theory of the response ofd-wave superconductors to weak applied fields, by taking account of the Coulomb interaction and all the collective degrees of freedom as well as crystal symmetry. We choose two representative phases: the d phase, which has point nodes in the energy gap, and theY _2–1 phase, which has line as well as point nodes. The former is a self-consistent solution for cubic as well as spherical symmetries and the latter is one for spherical, cubic, and hexagonal symmetries. We obtain obviously gauge-invariant expressions for the order-parameter fluctuations and the currents, having forms common not only to thed-wave states, but also to thep-wave states studied earlier. We also investigate the collective excitations; in the long-wavelength limit for spherically symmetric systems, there are, on the frequency-temperature plane, seven branches for eachd-wave phase considered, in addition to the common plasma mode and orbital Goldstone modes resulting from the spontaneous breakdown of the rotational invariance. In theY _2–1-phase two eigenmodes are found to become gapless at a finite temperature, below which they are purely imaginary. This implies instability of the phase. The effect of crystal anisotropy on the collective spectra is also studied.A preliminary report on the present work was published inJpn. J. Appl. Phys. Suppl. 26-3, 167 (1987).     

Analysis of weakly guiding cladded acoustic fibers of hexagonal crystal symmetry

An approximate analysis of the weakly guiding cladded acoustic fiber consisting of a core and infinite thick cladding both with hexagonal crystal symmetry is presented. The crystalline Z axis is parallel to the fiber axis. Weak guidance conditions require that the stiffness constants of the core are slightly less than those of the cladding, and the density of the core and cladding are almost the same. Approximate dispersion and cutoff equations are derived for all pure guided modes. Dispersion curves of several lower-order guided torsional, radial-axial and flexural modes are evaluated using both exact and approximate formulas and they are in good agreement. A simple approximate dispersion equation for leaky (longitudinal-type) modes is also obtained.     

基于建筑施工中的安全管理工作探讨

高层建筑的供水、供电等维修费用是一般建筑的3倍,而且超越消防极限,逃生几率相对小,建筑物越高,发生地震造成的伤亡就越大。权衡利弊,高层建筑的经济意义受到质疑,世界各国对高层建筑持谨慎的态度。因此应该严格履行高层建筑的论证和审批程序,适度控制标志性高层建筑,并对已有的高层建筑进行安全排查。高层建筑对节约城市土地、缩短公用设施和市政管网的开发周期、加快改善人们居住条件等方面都起到了重要作用,但也潜伏着不少危险。文章指出要根据城市发展总体规划,综合考虑人口大量集中对城市供应和交通的影响等因素,协调单体高层建筑及高层建筑群同周围环境、已有建筑、名胜古迹、城市风貌之间的分布关系。     

Intermediate temperature solid oxide fuel cell based on fully integrated plasma-sprayed components

This work addresses the fabrication of membrane-type solid oxide fuel cells (SOFCs) operating at medium temperatures, where all components are fabricated by plasma spray technology, and the evaluation of the performance of the SOFC single unit in a temperature range of 500 to 800 °C. Single cells composed of LaSrMgO₃ cathodes, LaSrGaMgO₃ (LSGM) electrolytes, and Ni/yttria-stabilized zirconia anodes were fabricated in successive atmospheric plasma-spraying processes. Plasma-spraying processes have been optimized and tailored to each layer to achieve highly porous cathode and anode layers as well as high-density electrolyte layers. A major effort has been devoted to the production of the LSGM electrolyte that has a high density and is free of cracks. Electrochemical impedance spectroscopy was used to investigate the conductivity of the electrode layers, and particularly the resistance of the electrolyte layer. It revealed that the heat treatment had a great influence on the specific conductivity of the sprayed electrolyte layers and that the specific conductivity of the heat-treated layers was dramatically increased to the same magnitude as is typical for sintered LSGM pellets. The experimental results have demonstrated that the plasma-spraying process has a great potential for the integrated fabrication of medium-temperature SOFC units. The original version of this article was published as part of the ASM Proceedings, Thermal Spray 2003: Advancing the Science and Applying the Technology, International Thermal Spray Conference (Orlando, FL), May 5–8, 2003, Basil R. Marple and Christian Moreau, Ed., ASM International, 2003.     

The T Cell Repertoires from Nickel Sensitized Joint Implant Failure Patients

Nickel (Ni²⁺) is one of the most common allergens, affecting around 10–15% of the general population. As the demand for orthopedic implant surgery rises, the number of surgical revisions due to joint implant failure also increases. There is evidence that some patients develop joint failure due to an immune response to a component of the implant, and we have found that Ni²⁺ is an especially important cause. Hence, understanding the mechanisms by which Ni²⁺ allergy induces joint implant failure becomes a critical research question. The structural basis of Ni²⁺ activation of pathogenic T cells is still not clear. The purpose of this study was to characterize Ni²⁺-reactive T cell repertoires derived from the peripheral blood of joint failure patients due to Ni²⁺ sensitization using single-cell sequencing techniques. We stimulated the proliferation of Ni²⁺ -reactive T cells from two implant failure patients in vitro, and sorted them for single-cell VDJ sequencing (10× genomics). We identified 2650 productive V-J spanning pairs. Both TCR α chains and β chains were enriched. TRBV18 usage is the highest in the P7 CD4+ population (18.1%), and TRBV5-1 usage is the highest in the P7 CD8+ population (12.1%). TRBV19 and TRBV20-1 segments are present in a high percentage of both P7 and P9 sequenced T cells. Remarkably, the alpha and beta chain combination of TRAV41-TRBV18 accounts for 13.5% of the CD4+ population of P7 patient. Compared to current Ni specific T cell repertoire studies of contact dermatitis, the Vα and Vβ usages of these joint implant failure patients were different. This could be due to the different availability of self-peptides in these two different tissues. However, TRBV19 (Vβ17) was among frequently used TCR β chains, which are common in previous reports. This implies that some pathogenic T cells could be similar in Ni²⁺ hypersensitivities in skin and joints. The alignment of the TCR CDR3β sequences showed a conserved glutamic acid (Glu) that could potentially interact with Ni²⁺. The study of these Ni²⁺ specific TCRs may shed light on the molecular mechanism of T cell activation by low molecular weight chemical haptens.     

Permissive Modulation of Sphingosine-1-Phosphate-Enhanced Intracellular Calcium on BKCa Channel of Chromaffin Cells

Sphingosine-1-phosphate (S1P), is a signaling sphingolipid which acts as a bioactive lipid mediator. We assessed whether S1P had multiplex effects in regulating the large-conductance Ca²⁺-activated K⁺ channel (BK_Ca) in catecholamine-secreting chromaffin cells. Using multiple patch-clamp modes, Ca²⁺ imaging, and computational modeling, we evaluated the effects of S1P on the Ca²⁺-activated K⁺ currents (I_K(Ca)) in bovine adrenal chromaffin cells and in a pheochromocytoma cell line (PC12). In outside-out patches, the open probability of BK_Ca channel was reduced with a mean-closed time increment, but without a conductance change in response to a low-concentration S1P (1 µM). The intracellular Ca²⁺ concentration (Ca_i) was elevated in response to a high-dose (10 µM) but not low-dose of S1P. The single-channel activity of BK_Ca was also enhanced by S1P (10 µM) in the cell-attached recording of chromaffin cells. In the whole-cell voltage-clamp, a low-dose S1P (1 µM) suppressed I_K(Ca), whereas a high-dose S1P (10 µM) produced a biphasic response in the amplitude of I_K(Ca), i.e., an initial decrease followed by a sustained increase. The S1P-induced I_K(Ca) enhancement was abolished by BAPTA. Current-clamp studies showed that S1P (1 µM) increased the action potential (AP) firing. Simulation data revealed that the decreased BK_Ca conductance leads to increased AP firings in a modeling chromaffin cell. Over a similar dosage range, S1P (1 µM) inhibited I_K(Ca) and the permissive role of S1P on the BK_Ca activity was also effectively observed in the PC12 cell system. The S1P-mediated I_K(Ca) stimulation may result from the elevated Ca_i, whereas the inhibition of BK_Ca activity by S1P appears to be direct. By the differentiated tailoring BK_Ca channel function, S1P can modulate stimulus-secretion coupling in chromaffin cells.     

致密油藏直井多层缝网压裂产量递减分析

垂向多层发育的致密油藏常采用缝网压裂进行开采,从而改善储层渗透率,提高油井产量。为此建立直井多层缝网压裂不稳定渗流数学模型,压裂后各层划分为人工裂缝区、改造区和未改造区。绘制分析Blasingame产量递减典型曲线,曲线分为7个流动阶段,总裂缝长度一定时,裂缝半长短的储层流体渗流率先到达未改造区,流体渗流阻力大,Blasingame曲线靠下;总改造体积一定时,各层改造体积差异越大,Blasingame曲线越靠下。用所建立的模型,对实测生产资料进行解释,获得各层裂缝半长、改造区渗透率等相关地层参数,该模型对进行多层缝网压裂直井产量分析具有指导意义。     

基于Windows的液压实时测试浅析

本文通过分析WINDOWS实时处理的局限性，提出了解决问题的几种机制；同时以液压元件的实时测试中断程序的实现为例说明了机制的应用，研究表明，这种机制较传统方法实用、有效。     

Preparation of High Strength and Toughness Aramid Fiber by Introducing Flexible Asymmetric Monomer to Construct Misplaced-Nunchaku Structure

High performance fibers with high strength and toughness have great potential in composites, but contradiction between tensile strength and elongation at break makes the preparation to become a current challenge. Herein, an asymmetric structure of more flexible diamine, 3,4′-diaminodiphenyl ether (3,4′-ODA), is introduced into heterocyclic aramid (PBIA) fibers to replace rigid symmetric p-phenylenediamine (PDA). By studying the properties of copolymer (mPEBA) fibers with different ratios of diamine, it is found that the mPEBA fiber reached the optimal mechanical properties with the 30% content of 3,4′-ODA. Compared with homopolymerized heterocyclic aramid fibers, the tensile strength and elongation at break of mPEBA fiber are improved by 26.2% and 38.7%, respectively. Results of X-ray diffraction show that the introduction of 3,4′-ODA structure can increase stretchability of mPEBA fibers, improving the orientation degree during hot-drawing. Molecular dynamics simulations confirm that 3,4′-ODA structure undergoes a conformation transformation to form a straightened chain during hot-drawing, while symmetrical 4,4′-diaminodiphenyl ether (4,4′-ODA) cannot form the same conformation. The misplaced-nunchaku structure is formed based on the special meta-para position of 3,4′-ODA, achieving the synergy of high strength and high toughness.