Feasibility of a 1,400 m Span Steel Cable-Stayed Bridge

This paper describes the feasibility of 1,400 m steel cable-stayed bridges from both structural and economic viewpoints. Because the weight of a steel girder strongly affects the total cost of the bridge, the writers present a procedure to obtain a minimum weight for a girder that ensures safety against static and dynamic instabilities. For static instability, elastoplastic, finite-displacement analysis under in-plane load and elastic, finite-displacement analysis under displacement-dependent wind load are conducted; for dynamic instability, multimodal flutter analysis is carried out. It is shown that static critical wind velocity of lateral torsional buckling governs the dimension of the girder. Finally, the writers briefly compare a cable-stayed bridge with suspension bridge alternatives.     

Robustness of linearly solvable Markov games employing inaccurate dynamics model

As a model-based reinforcement learning technique, linearly solvable Markov decision process (LMDP) gives an efficient way to find an optimal policy by making the Bellman equation linear under some assumptions. Since LMDP is regarded as model-based reinforcement learning, the performance of LMDP is sensitive to the accuracy of the environmental model. To overcome the problem of the sensitivity, linearly solvable Markov game (LMG) has been proposed, which is an extension of LMDP based on the game theory. This paper investigates the robustness of LMDP- and LMG-based controllers against modeling errors in both discrete and continuous state-action problems. When there is a discrepancy between the model used for building the control policy and dynamics of the tested environment, the LMG-based control policy maintained good performance while that of the LMDP-based control policy deteriorated drastically. Experimental results support the usefulness of LMG framework when acquiring an accurate model of the environment is difficult.     

Visualization and concentration measurement of a direct-injection hydrogen jet in a constant-volume vessel using spark-induced breakdown spectroscopy

In this work, spark-induced breakdown spectroscopy (SIBS) was employed to investigate the mixing process of a hydrogen jet in a constant-volume vessel. The local fuel concentration of the hydrogen jet was measured at several locations, using a SIBS sensor. A high-speed camera was used to visualize spark discharge fluctuations, and hydrogen jet concentration measurements were conducted simultaneously. Spectrally resolved atomic emissions from the plasma generated by the spark plug were examined to determine the local equivalence ratio. Direct visualization of the spark discharge provided useful information about the influence of spark discharge characteristics related to the spark timing. Using the developed SIBS sensor, atomic emission spectra were obtained from hydrogen H_α at 656 nm and nitrogen N (I) at 501 nm. Comparison of the intensity peaks of atomic emissions from hydrogen and nitrogen allows the local hydrogen concentration in a measured volume to be determined, and hence also the local equivalence ratio. The measurement results demonstrate the local variation in the equivalence ratio throughout the jet and along its axis. From the results, the spatial structure of the hydrogen jet affects the hydrogen/nitrogen mixing and could be clarified with SIBS technique when the spark is discharged.     

Shape memory properties of polypeptide hydrogels having hydrophobic alkyl side chains

Polypeptide hydrogels were prepared by cross-linking of hydrophobically-modified poly[N⁵-(2-hydroxyethyl) l-glutamine] having alkyl side chains –C_nH_2n+1. Chain length of the alkyl group was n = 8, 16, and 18, and their mole fractions in the polypeptide were varied in the range of 0.05–0.16. Shape memory ability of the prepared polypeptide hydrogels was investigated. After deformation at 60 °C, the hydrogel was cooled in order to fix the temporary deformed shape. It was found that crystallization of the alkyl side chains did not occur, and the fixation ability of the hydrogel at 0 °C was low. In the subsequent heating process, the deformed temporary shape spontaneously recovered to the original shape gradually with increasing temperature, in other words, the shape recovery ratio varied with depending on the recovery temperature. From these observations, it was proposed that the shape fixation of the polypeptide hydrogel was achieved by strong segregation of the hydrophobic alkyl chains at low temperature, and the shape recovery of the deformed hydrogel was accompanied by the gradual decrease of the segregation strength with the temperature increase.     

Detection of Buckminsterfullerene in Usual Soots and Commercial Charcoals

Abstract

It was confirmed that soot produced by free burning of small hydrocarbons like benzene and cyclohexane generally contains less than 0.1 ppm of C₆₀. Small, but measurable amounts of C₆₀ were found in two samples of charcoal, providing the first indication of fullerene formation in the solid state.     

Satellite data visualization system for education

It is important for environment protection to monitor changes in the environment by natural and human causes. It is also important to educate the next generation on the importance of the global environment issues. Recently, it has become possible to continually monitor the global environment using various satellite sensor data. But these satellite data are used for highly specialized analysis by experts in such fields, and the data cannot easily be used by non-experts. In this paper, we propose a satellite data visualization system for educational use. In the proposed system, a gray-scale 2-dimensional image is created from the satellite data. Next, a pseudo-color image is created from the gray-scale image to assist the comprehension of the data. A 3-dimensional data representation of the image is also created, to assist the comparison of the individual data. The aim of the created image is for educational use, and the image is created with emphasis on comprehension of the data, rather than presentation of data details. The aim of the proposed system is presenting the satellite data visually so that non-experts can easily understand. The target of this research is to apply the proposed system for natural science education and to improve the awareness of global environmental issues.     

Solid–Liquid Phase Behaviors of Binary Mixtures of Various Partial Acylglycerols by Differential Scanning Calorimetry

Monoacylglycerol (MAG), diacylglycerol (DAG), and triacylglycerol (TAG) are impurities in biodiesel and a major cause of precipitation. Understanding the behavior of such acylglycerols is essential for predicting biodiesel cold flow properties (CFPs). The previous study on MAG/MAG binary mixtures shows that they tend to solidify by forming molecular compounds. In contrast, TAG/TAG mixtures, which have been studied extensively, are commonly eutectic or monotectic systems, in which each component solidifies separately. The present study focuses on binary mixtures of DAG/DAG and different acylglycerol pairs (MAG/DAG, TAG/MAG, and DAG/TAG), and determination of their solid–liquid phase behavior by differential scanning calorimetry. These mixtures are found to behave as eutectic or monotectic systems with no sign of compound formation. As DAG and TAG have lower contents than MAG in biodiesel and they are unlikely to form molecular compounds with MAG, it is suggested that DAG and TAG have little effect on the biodiesel CFPs. Practical Applications: Biodiesel has attracted much interest because its blending with conventional fossil diesel has become more standard with biofuel mandates. From an energy perspective, the solid–liquid phase behavior of acylglycerols will contribute to building prediction models for biodiesel CFPs.