Analysis and Simulation of S-shaped Waveguide in Silicon-on-insulator

The simulation and analysis of S-shaped waveguide bend are presented.Bend radius larger than 30 mm assures less than 0.5 dB radiation loss for a 4-μm-wide silicon-on-insulator waveguide bend with 2-μm etch depth.Intersection angle greater than 20° provides negligible crosstalk (<-30 dB) and very low insertion loss.Any reduction in bend radius and intersection angle is at the cost of the degradation of characteristics of bent waveguide and intersecting waveguide, respectively.     

电接点压力表补水泵定压系统的应用

阐述了电接点压力表补水泵定压系统的一些应用问题 ,给出了电接点压力表定压点的上、下限计算公式 ,并提出了该系统补给水泵、补给水箱及安全阀的设计选型方法     

基于PSR模型的水电工程生态效应评价指标体系构想

从水电工程生态效应评价指标体系研究的意义出发,通过分析水电工程生态效应评价的内涵,确立了评价指标的选取原则,基于压力(Pressure)-状态(State)-响应(Response)概念模型,构建了以科学、实用和可操作为目标的评价指标体系的框架。     

Viterbi译码器的硬件实现

介绍了一种Vkerbi译码器的硬件实现方法。设计的基于硬判决的Viterbi译码器具有约束长度长（9)、译码深度深（64)的特点。为了兼顾硬件资源与电路性能两个方面，在设计中使用了4个ACS单元，并根据Xilinx Virtex系列FPGA的结构特点．利用FPGA内部的BlockRAM保存汉明距离和幸存路径，提高了译码速度。     

聚醚酰亚胺热焓松弛的分子量依赖关系

采用ＤＳＣ对不同分子量的聚醚酰亚胺的等温及动态热焓松弛行为进行了研究，并以ＫＷＷ方程对实验数据进行了非线性拟合。结果表明，分子量对热焓松弛的影响是由高分子端基引起自由体积的差异所致。不同分子量的聚醚酰亚胺分子具有不同数量的端基，淬冷时端基数目的差异将产生不同数量的过剩自由体积，从而影响松弛热焓及松弛速率、低分子量的聚醚酰亚胺松弛相对较快，且起始热焓高，松弛的表观活化能亦较小。     

粘土矿物对低渗透储层性质的影响——以鄂尔多斯盆地三叠系低渗透储层为例

粘土矿物是低渗砂岩储层的主要胶结物，对储层物性及开发过程中储层物性变化趋势有着重要的影响和控制作用。另外，粘土矿物也蕴含着大量沉积环境介质的物理化学信息，认识其自然规律，可以有效地指导预测有利储层，认识和改造油层。以鄂尔多斯盆地砂岩储层中的粘土矿物为研究对象，探讨分析粘土矿物对低渗储层性质的影响，该研究对含油气盆地低渗储层有效开发具有一定的参考价值。     

Microstructure and Mechanical Properties of Heat-treated GeSb_2Te_4 Thin Films

The effect of annealing on microstructure,adhesive and frictional properties of GeSb 2 Te 4 films were experimentally studied.The GeSb 2 Te 4 films were prepared by radio frequency(RF)magnetron sputtering,and annealed at 200℃and 340℃under vacuum circumstance,respectively.The adhesion and friction experiments were mainly conducted with a lateral force microscope(LFM)for the GeSb 2 Te 4 thin films before and after annealing.Their morphology and phase structure were analyzed by using atomic force microscopy(AFM)and X-ray Diffraction(XRD)techniques,and the nanoindention was employed to evaluate their hardness values.Moreover,an electric force microscope(EFM)was used to measure the surface potential. It is found that the deposited GeSb 2 Te 4 thin film undergoes an amorphous-to-fcc and fcc-to-hex structure transition;the adhesion has a weaker dependence on the surface roughness,but a certain correlation with the surface potential of GeSb 2 Te 4 thin films.And the friction behavior of GeSb 2 Te 4 thin films follows their adhesion behavior under a lower applied load.However,such a relation is replaced by the mechanical behavior when the load is relatively higher.Moreover,the GeSb 2 Te 4 thin film annealed at 340℃presents a lubricative property.     

异构数据的管理方法及异构数据源的集成研究

工程应用中软件工具的多样性和设计活动的分散性形成了大量异构数据。本文分析了传统的异构数据管理方法的不足，提出使用数据库系统的文件系统结合的管理方法。针对此方法下所形成的异构数据源问题，给出了基于J2EE规范的数据访问对象抽象工厂解决方案。     

基于IPC的直流电机控制实验装置设计

介绍了工业控制计算机（IPC）在工业自动化领域中对直流机控制的应用，以工控机作为实验平台。设计了IPC测控系统之一的直流机测控子系统的实验装置，叙述了如何用IPC进行直流机转速的脉冲调宽式（PWM）控制，并通过软件实现在多任务实时操作系统（MROS）申直流机的速度测控和速度曲线绘制。