佛山市中心组团桥梁群对河道影响的数值分析

在不同频率流量和阻水程度条件下,采用一维明渠非恒定流网河数学模型,分析规划中的佛山市桥梁群对区间河道洪季行洪、枯季水环境的影响,计算洪季不同频率洪峰流量下规划桥梁群对区间河道行洪洪水位、分流比的影响,枯季时规划桥梁群对区间河道过流量、分流比的影响,结果表明,利用一维网河数学模型计算佛山市中心组团规划桥梁群对区间河道断面平均水位、流量和流速的影响,结果有足够的数值精度,是可信的。     

锂离子电池有机电解液成膜添加剂的研究现状

文章综述了锂离子电池有机电解液成膜添加剂的作用原理，具体介绍了CO2、SO2、VC化合物、卤化物、有机铜盐以及马来酐等添加剂的研究现状。     

IPv6过渡机制讨论

本文在简要地介绍Ngtrans工作组提出的大多数过渡机制的基础上，尝试对它们进行区分、分类，并对每一种过渡机制的优缺点进行分析。另外．还对这些机制的布置以及一部分支持这些机制的产品平台进行讨论。     

上海外环隧道水下最终接头的施工技术

沉管隧道采用水下最终接头,可以大大缩短工期和减少成本,但施工难度较大,而且有一定风险。文章以上海外环隧道工程为例,对沉管隧道水下最终接头的施工工艺中管段轴线精度控制、安装保护罩、间隙间的安全排水和混凝土施工等四大难点进行探讨,并介绍了水密性施工和管内结构施工的具体工艺和步骤。指出其成果对今后类似工程具有较大的参考价值。     

WCDMA的软切换算法和TD-SCDMA的接力切换算法的分析与比较

本文概述了WCDMA的软切换算法和TD-SCDMA中的接力切换算法,分析和比较了这两种算法的各自得特点.     

Identify unrepairability to speed-up spare allocation for repairing memories

In this paper, we discuss some strategies for identifying unrepairable memories, and from that to introduce a novel theorem that can make more precise identification. A new algorithm for searching repair solutions is also proposed, which characterizes the rows, and columns of defective memory cells with revised effective coefficients. We have simulated it on many generated example maps, and compared it with the previous algorithms to verify its efficiency. It's combined with those arranged strategies of judging unrepairability to generate a complete flow. The complete algorithm has also been run on many examples with various memory sizes, defect numbers, and distribution types. The simulation results further show that identifying unrepairability in advance can help the reconfiguration procedure run much faster than searching solutions directly.     

基体温度对磁控溅射沉积ZAO薄膜性能的影响

利用中频交流磁控溅射方法 ,采用氧化锌铝陶瓷靶材 [w(ZnO) =98%、w(Al2 O3 ) =2 % ]制备了ZAO(ZnO∶Al)薄膜 ,观察了基体温度对ZAO薄膜的晶体结构、电学和光学性能的影响 ,采用X射线衍射仪对薄膜的结构进行了分析 ,采用光学分度计和电阻测试仪测量了薄膜的光学、电学特性 ,采用霍尔测试仪测量了薄膜的载流子浓度和霍尔迁移率。结果表明 :沉积薄膜时的基体温度对薄膜的结构、结晶状况、可见光透射率以及导电性有较大的影响。当基体温度为 2 5 0℃ ,Ar分压为 0 8Pa时 ,薄膜的最低电阻率为 4 6× 10 -4Ω·cm ,方块电阻为 35Ω时 ,可见光 (λ =5 5 0nm)透射率高达 92 0 %。     

绿色再生混凝土利用途径与评定思路

就再生混凝土骨料进行深入系统的研究 ,建立了一套与现行评价天然骨料标准相一致的评定方法 ,具有工程实际意义 ,为将来实际应用作好了基础理论研究     

IF钢冷轧及再结晶初期微观组织的TEM研究

采用透射电子显微镜对不同压下量和再结晶初期的IF钢样品进行了研究．结果表明：无论是在较小形变量下还是在较大形变量下，形变不均匀性是普遍存在的；冷变形程度不同，织构组分不同，TEM形貌也不同；在再结晶的最初期，冷轧的形变组织演变为近乎等轴的亚晶，优先形成{111}〈uvw〉取向的晶核，晶核逐渐吞并周围的形变基体而长大，最终形成再结晶γ-纤维织构．     

Formation of composites fabricated by exothermic dispersion reaction in A1-TiO2-B2O3 system

The formation of aluminum matrix composites fabricated by exothermic dispersion reaction in A1-TiO2-B2O3 system was investigated. The thermal analysis results show that the reactions are spontaneous and exothermic. The Gibbs free energy of α-Al2O3 is the lowest among all the combustion products, followed by TiB2 and Al3Ti. It is noted that when the B2O3/TiO2 mole ratio is below 1, the reaction products are composed of particle-like α-Al2O3, TiB2 and rod-like Al3Ti. The α-Al2O3 crystallites, resulting from the reaction between A1 and TiO2 or B2O3, are segregated at the grain boundaries due to a lower wettability with the matrix. SEM micrographs show that rod-like Al3Ti phase distributes uniformly in the matrix. When the BEO3/TiO2 mole ratio is around 1, the Al3Ti phase almost disappears in the composites, and the distribution of α-Al2O3 particulates is improved evidently.