Fracture Resistance Behavior of High‐Thermal‐Conductivity Silicon Nitride Ceramics

Silicon nitride ceramics were prepared from a high‐purity silicon powder doped with 2 mol% Y₂O₃ and 5 mol% MgO as sintering additives via a route of sintering of reaction‐bonded silicon nitride (SRBSN). The materials sintered at 1900°C for 3, 6, 12, and 24 h had thermal conductivities of 109, 125, 146, and 154 W/m/K, and four‐point bending strengths of 786, 676, 608, and 505 MPa, respectively. The fracture toughness values, determined by the single‐edge‐precracked‐beam (SEPB) method, were 8.4, 8.6, 9.7, and 10.7 MPa m^1/2 for the materials sintered for 3, 6, 12, and 24 h, respectively, which were similar to the results measured by the chevron‐notched‐beam (CNB) test method. The materials sintered for longer times (12 and 24 h) showed stronger R‐curve behaviors over longer range of crack extension, in comparison with the materials sintered for shorter times (3 and 6 h).     

Push-Pull Fatigue of Sintered Silicon Nitride Ceramics at Elevated Temperatures

The fatigue tests under push-pull completely reversed loading and pulsating loading were performed for silicon nitride ceramics at elevated temperatures. Then the effects of stress wave form, stress rate, and cyclic understressing on fatigue strength, and cyclic straining behavior, were examined. The cycle-number-based fatigue life is found to be shorter under trapezoidal stress wave loading than under triangular stress wave loading, and to become shorter with increasing hold time under the trapezoidal stress wave loading. Meanwhile, the equivalent time-based life curve, which is estimated from the concept of slow crack growth, almost agrees with the static fatigue life curve in the short and intermediate life regions, showing the small cyclic stress effect and the dominant stress-imposing period effect on cyclic fatigue life. The fatigue strength increased in stepwise stress amplitude increasing test, where stress amplitude is increased stepwise every given number of stress cycles, at 1100° and 1200°C. Occurrence of cyclic strengthening was proved through a gradual decrease in strain amplitude during a pulsating loading test at 1200°C in this material, corresponding to the above cyclic understressing effect on fatigue strength.     

Distributions of hydroperoxide positional isomers generated by oxidation of 1-palmitoyl-2-arachidonoyl-<Emphasis Type="Italic">sn</Emphasis>-glycero-3-phosphocholine in liposomes and in methanol solution

The differences in distribution of geometric isomers of unsaturated PC hydroperoxides generated by free radical oxidation were compared, as corresponding hydroxy analogs, in heterogeneous liposomes and in a homogeneous methanol solution by using HPLC with UV detection due to the presence of conjugated dienes. Identification of fractionated peak components was carried out by GC-MS. When the oxidation of 1-palmitoyl-2-linoleoyl-sn-glycero-3-phosphocholine, PC(16∶0/18∶2), was initiated in liposomes by a hydrophilic azo radical initiator, and in a methanol solution by a hydrophobic azo radical initiator, there was no significant difference in the relative percentages of 1-palmitoyl-2-(9-hydroxy-trans-10,trans-12-octadecadienoyl)-sn-glycero-3-phosphocholine (9-t,t-OH PC) and 1-palmitoyl-2-(13-hydroxy-trans-9,trans-11-octadecadienoyl)-sn-glycero-3-phosphocholine (13-t,t-OH PC) between the PC oxidized in liposomes and in the methanol solution. For the oxidation of 1-palmitoyl-2-arachidonoyl-sn-glycero-3-phosphocholine, PC(16∶0/20∶4), the relative percentage of 1-palmitoyl-2-(5-hydroxy-trans-6,cis-8,11,14-eicosatetraenoyl)-sn-glycero-3-phosphocholine (5-OH PC) was significantly higher (P<0.01) than that of 1-palmitoyl-2-(15-hydroxy-cis-5,8,11,trans-13-eicosatetraenoyl)-sn-glycero-3-phosphocholine (15-OH PC) in liposomes. For the homogeneous methanol solution of PC(16∶0/20∶4), the relative percentage of 5-OH PC was close to that of 15-OH PC. For the PC(16∶0/20∶4) oxidized in bulk with added pentamethylchromanol, the individual amount of 15-OH PC, 1-palmitoyl-2-(11-hydroxy-cis-5,8trans-12,cis-14-eicosatetraenoyl)-sn-glycero-3-phosphocholine (11-OH PC), 1-palmitoyl-2-(12-hydroxy-cis-5,8,trans-10,cis-14-eicosatetraenoyl)-sn-glycero-3-phosphocholine (12-OH PC), 1-palmitoyl-2-(8-hydroxy-cis-5,trans-9,cis-11,14-eicosatetraenoyl)-sn-glycero-3-phosphocholine (8-OH PC), 1-palmitoyl-2-(9-hydroxy-cis-5,trans-7,cis-11,14-eicosatetraenoyl)-sn-glycero-3-phosphocholine (9-OH PC), and 5-OH PC were close to each other compared to the corresponding values in liposomes and in methanol solution. The results obtained by gel permeation chromatography of the PC liposomes containing hydrophilic 2,2′-azobis-2-amidinopropane) dihydrochloride (AAPH) suggest that the AAPH added to the liposomes of PC(16∶0/20∶4) was partitioned into the water phase and out of the hydrophobic region of the fatty acyl moieties of the PC. These results confirm that the distance that exists in the bis-allylic carbons of the unsaturated fatty acyl moieties of PC from the interface between the hydrophilic region of PC and the water phases played an important role in influencing hydrogen abstraction to form a symmetrical distribution of hydroperoxide isomers in both the heterogeneous liposomes and the homogeneous methanol solution.     

Effect of steric hindrance on hydrogen‐bonding interaction between polyesters and natural polyphenol catechin

The phase behaviors for the blends of poly(3‐hydroxypropionate) (PHP), poly(L ‐lactide) (PLLA), poly(D ‐lactide) (PDLA), and poly(D,L ‐lactide) (PDLLA) with catechin were investigated by differential scanning calorimetry. In PLLA/catechin, PDLA/catechin, and PDLLA/catechin blends, two glass transitions were detected when the catechin content was ≥40 wt %, whereas in PHP/catechin blends only one glass transition was observed over the whole range of blend compositions. The former and the latter results should reflect the inhomogeneous and the homogeneous nature of the blends, respectively, in the amorphous phase. These different phase behaviors should arise from the differences in the chemical structures between PHP and PLLA/PDLA/PDLLA, which dominates the strength and the number of intermolecular hydrogen‐bonding interactions between the ester carbonyl groups of polyesters and the phenol groups of catechin. As detected by FTIR spectroscopy, in comparison with PHP, the steric hindrance of side‐chain methyl groups of PLLA, PDLA, and PDLLA might restrain the formation of hydrogen bonds between their ester carbonyl groups and the phenol hydroxyl groups of catechin, even weakening the strength of such hydrogen bonds. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 91: 3565–3573, 2004     

HNF1A Mutations and Beta Cell Dysfunction in Diabetes

Understanding the genetic factors of diabetes is essential for addressing the global increase in type 2 diabetes. HNF1A mutations cause a monogenic form of diabetes called maturity-onset diabetes of the young (MODY), and HNF1A single-nucleotide polymorphisms are associated with the development of type 2 diabetes. Numerous studies have been conducted, mainly using genetically modified mice, to explore the molecular basis for the development of diabetes caused by HNF1A mutations, and to reveal the roles of HNF1A in multiple organs, including insulin secretion from pancreatic beta cells, lipid metabolism and protein synthesis in the liver, and urinary glucose reabsorption in the kidneys. Recent studies using human stem cells that mimic MODY have provided new insights into beta cell dysfunction. In this article, we discuss the involvement of HNF1A in beta cell dysfunction by reviewing previous studies using genetically modified mice and recent findings in human stem cell-derived beta cells.     

Simple evaluation of aortic arch calcification by chest radiography in hemodialysis patients

Vascular calcification is associated with a poor prognosis in dialysis patients. It can be assessed with computed tomography but simple inoffice techniques may provide useful information. We compared the results obtained with a simple noninvasive technique with those obtained using multidetector computed tomography for aortic arch calcification volume (AoACV) in chronic hemodialysis (HD) patients. The enrolled study subjects were 63 (32 men and 31 women) maintenance HD patients. Calcification of the aortic arch was semiquantitatively estimated with a AoAC score (AoACS) on plain chest radiology. The AoACV was increased, with a mean value of 6.6 ranging from 0% to 36.5%. The coefficient of intraobserver variation was less than 2.5%. Aortic arch calcification score was highly correlated with AoACV (r=0.635, P<0.001). Multiple regression analysis showed age (F value=12.62, P<0.001) and pulse pressure (F value=4.54, P=0.037) to be significant independent determinants of AoACS. In conclusion, a simple measurement of AoACS may be useful for inoffice imaging to choose a therapeutic regimen in HD patients.     

Reaction joining of SiC ceramics using TiB2-based composites

SiC ceramics were reaction joined in the temperature range of 1450–1800 °C using TiB₂-based composites starting from four types of joining materials, namely Ti–BN, Ti–B₄C, Ti–BN–Al and Ti–B₄C–Si. XRD analysis and microstructure examination were carried out on SiC joints. It is found that the former two joining materials do not yield good bond for SiC ceramics at temperatures up to 1600 °C. However, Ti–BN–Al system results in the connection of SiC substrates at 1450 °C by the formation of TiB₂–AlN composite. Furthermore, nearly dense SiC joints with crack-free interface have been produced from Ti–BN–Al and Ti–B₄C–Si systems at 1800 °C, i.e. joints TBNA80 and TBCS80, whose average bending strengths are measured to be 65 MPa and 142 MPa, respectively. The joining mechanisms involved are also discussed.     

Space charge field effect on light emitting from tetracene field-effect transistor under AC electric field

By applying square wave AC voltage to the Au source electrode of tetracene based field-effect transistor (FET), electroluminescence (EL) was obtained. The results suggest that electrons and holes were injected alternately from the source electrode and recombined each other, and lead to the EL. This type of EL was localized at the interface between the source electrode and tetracene, and enhanced periodically with two relaxation times in accordance with the applied AC voltage cycle. We modeled the carrier behavior in the FET and explained the decay of EL, taking into account the space charge field contribution. Finally, using an AC voltage superposed on DC bias voltage, it was shown that electron injection was prompted only by space charge field.     

Highwall Stability due to Punch Mining at Opencut Coal Mines

Conventional highwall mining extracts coal with an auger machine or a continuous miner from exposed seams at the base of opencut or strip operations. However, under poor strata and high stress conditions, highwall mining cannot be conducted due to pillar and roof failures. In such cases, punch highwall mining is more effective than the conventional highwall mining. This paper describes conventional highwall mining and punch highwall mining systems and discusses the stability of the highwall due to punch highwall mining at opencut coal mines.