Theoretical Evalution of Signatures and CNR Penalties Caused by Modem Impairments in Multilevel QAM Digital Radio Modems

A calculation method for symbol error probability is proposed for multilevel QAM systems. Carrier-to-noise ratio penalties are estimated by this method for seven typical impairment factors, including recovered carrier phase error, timing error, receive filter residual delay, etc. The validity of the method is verified by experiments on penalties caused by recovered carrier phase error and timing error. Based on the new method of analysis, signatures of a 64 QAM modem are estimated theoretically, using a pseudo-two-ray model of multipath fading. The dependence of signatures on the above-mentioned impairment factors is investigated in detail. A qualitative deduction of impairment factors from a measured signature is demonstrated. The measured signature agrees well with a calculated one in which reasonable values of the impairment factors are assumed.     

Field test results of multi-channel digital tv transmission at 15 and 30 Mb/s through an intelsat satellite using a PSK/FDMA system

This paper describes field test results of multi-channel digital TV transmission using a PSK/FDMA system and the related subjective test results of received TV pictures. The picture quality of the multi-channel 15 or 30 Mb/s transmission for both NTSC and PAL systems through the INTELSAT POR satellite are subjectively evaluated for various bit-error rates. In addition, subjective evaluations were made at various values of earth-station e.i.r.p. to compare the picture quality of digital transmissions with that of current half-transponder FM transmission.     

Voltage Control of Static Var Compensator for a Remote System Interconnected by Long‐Distance AC Cables

The voltage variation in a remote system is large when the system is connected by long‐distance AC cables due to the cable capacitance. In Japan, the longest 54‐km 66‐kV AC submarine cable interconnection between the Kyushu mainland and Goto Islands was commissioned in 2005. It was requested to mitigate the voltage variation caused by switching off and on one circuit of the two circuits in the AC cables when a fault occurs. Since the conventional voltage control methods such as transformer tap changer or shunt capacitor and reactor banks are not sufficient because of their slow response time, a static var compensator (SVC) was installed on the Goto Islands. In such an application, an SVC control method should be developed so as not to override the existing voltage control systems. This paper describes the SVC control method developed for the Goto Islands AC interconnection project, which can be applied to similar situations. The effectiveness of the control method was verified by the results of effective value simulation and of field testing, which was implemented before the SVC was commissioned in 2007. © 2013 Wiley Periodicals, Inc. Electr Eng Jpn, 186(3): 19–30, 2014; Published online in Wiley Online Library ( wileyonlinelibrary.com ). DOI 10.1002/eej.22337     

Wave venation in downward gas-liquid two-phase flow (part I,time-spatial behavior chart of interface and analysis of main wave-vein)

Time-series information on both the cross-sectional mean liquid holdup along a tube axis and the gas-liquid phase distribution along a tube diameter was obtained by means of supermultiple cross-sectional mean liquid holdup probes (S-CHOP) and semi-supermultiple point-electrode probes (SS-PEP) for vertical downward gas-liquid two-phase flow. Typical time-spatial behavior charts of interface and gas-liquid interfacial profiles are presented. Close inspection of these results reveals that a huge wave and a disturbance wave appear in downward two-phase flow as well as upward flow. It was clarified that the huge wave flow region covers a wide range of superficial gas velocities. Wave velocity, wave width and maximum liquid holdup of individual waves were examined by wave-vein analysis. Histograms of these flow parameters were also studied. It was found that there exist distinct differences in wave width between the huge wave and the disturbance wave. © 1997 Scripta Technica, Inc. Heat Trans Jpn Res, 25(8): 499–510, 1996     

Interactive visualization of three-dimensional magnetic fields

In order to observe the physical values (magnetic flux density and eddy current) in 3D magnetic field analysis, an interactive and highly manipulative visualization system depicting stereo images is intalled in a graphics workstation with high functional graphic processors. The system has the following characteristics:

• 1 An interactive and highly manipulative menu window with many functions: it enables visualization of complex phenomena in a 3D field through observation of various combinations of physical values from various viewpoints.
• 2 Simultaneous display of both magnetic flux density and eddy current by using the appropriate use of two colour display methods for stream lines and distribution maps of density: this function facilitates observation of the mutual relations between two physical values in a 3D field.
• 3 Animations and stereo displays: since they give extremely distinct images, observers can easily understand even highly complex 3D phenomena.

In this paper, the calculation method of density vectors, their display methods, and interactive functions are described. Some examples are also illustrated.     

Improvement of cyclic behavior of a ball-milled SiO and carbon nanofiber composite anode for lithium-ion batteries

The cyclic performance of a composite SiO and carbon nanofiber (CNF) anode was examined for lithium-ion batteries. SiO powder of several micrometers was pulverized using high energy mechanical milling. The SiO was ball-milled for 12 h with CNF to produce a composite electrode material that exhibited excellent cycling performance. A reversible capacity of approximately 700 mAh g⁻¹ was observed after 200 cycles. The excellent cyclic performance was discussed with respect to the change of the valence state of Si by ball-milling. A large irreversible capacity at the first cycle for the SiO/CNF composite electrode was reduced to 2% by chemically pre-charging with a lithium film attached to the rim of the electrode.     

Influence of Steeping Conditions for Kernels on Some Properties of Corn Starch

The steeping conditions for kernels affected the physicochemical properties of corn starch. Steeping in an alkaline solution minimized the nitrogen and phosphorus contents, while that in water and a sulfite solution gave high contents. The alkaline-steeping appeared to slightly reduce the crystallinity of starch granules, as judged on X-ray diffraction. Steeping at a low temperature produced the starch showing the lowest pasting temperature, on amylography, but it showed a similar gelatinization temperature, on photopastegraphy. to those of the other starches. The starches with low nitrogen and lipid contents swelled largely and were extensively solubilized on heating. The actual amylose contents were 20–21%, which were considerably lower than the apparent contents.     

Molecular Hydrogen Enhances Proliferation of Cancer Cells That Exhibit Potent Mitochondrial Unfolded Protein Response

Molecular hydrogen ameliorates pathological states in a variety of human diseases, animal models, and cell models, but the effects of hydrogen on cancer have been rarely reported. In addition, the molecular mechanisms underlying the effects of hydrogen remain mostly unelucidated. We found that hydrogen enhances proliferation of four out of seven human cancer cell lines (the responders). The proliferation-promoting effects were not correlated with basal levels of cellular reactive oxygen species. Expression profiling of the seven cells showed that the responders have higher gene expression of mitochondrial electron transport chain (ETC) molecules than the non-responders. In addition, the responders have higher mitochondrial mass, higher mitochondrial superoxide, higher mitochondrial membrane potential, and higher mitochondrial spare respiratory capacity than the non-responders. In the responders, hydrogen provoked mitochondrial unfolded protein response (mtUPR). Suppression of cell proliferation by rotenone, an inhibitor of mitochondrial ETC complex I, was rescued by hydrogen in the responders. Hydrogen triggers mtUPR and induces cell proliferation in cancer cells that have high basal and spare mitochondrial ETC activities.     

An evaluation of an olfactory sensor and recognition system using metal-oxide semiconductor gas sensor with variable heater controller

An artificial olfactory, which is called an electronic nose system (e-nose), is studied for realizing new human–machine interface. The system consists of sensor unit and a signal processing unit. There are some types of sensors for the sensor unit, metal oxide semiconductor gas sensors (MOGS) and quartz crystal microbalance gas sensors are useful in our study. Our system in this paper has MOGS. Many of MOGS utilize an effect of an oxidation–reduction reaction on the surface of the sensors. One of the features of the sensor, the character of the sensor is changed by temperature of the sensors. In this paper, we build a extend output sensor unit using this feature, and show experimental result of classification applying multilayer perceptron. In the experiment, we choose soy sauce as classification targets because we are considering applying the system for management of cooked foods.     

Alignment control of liquid crystals in a 1.0‐μm‐pitch spatial light modulator by lattice‐shaped dielectric wall structure

We achieved uniform liquid crystal (LC) alignment in lattice‐shaped dielectric walls 1 μm in pitch; this is a prerequisite when driving the individual pixels of spatial light modulators, facilitating the development of practical electronic holographic displays with a wide field of view. In lattice‐shaped dielectric walls, LC alignment becomes unstable, particularly on the bottom and the walls; the LC directors tend to align parallel to the walls. To overcome this problem, we created lattice‐shaped walls featuring partition plates that allow uniform LC alignment. When the plates confine LCs to small regions exhibiting spatial anisotropy, the LC elastic effect and wall anchoring forces align the LC directors parallel to the long anisotropic axis. We found that pixels 0.5 μm × 1.0 μm in pitch formed if the partition plates were sufficiently thick to allow shielding of electric field leakage.