CuO/SnO2-In2O3 sensor for monitoring CO concentration in a reducing atmosphere

The CO sensing property of CuO-loaded SnO₂-In₂O₃ sensor was investigated in a reducing atmosphere. The sensor response to CO for CuO/SnO₂-In₂O₃ (8/2) was much higher than that for CuO/SnO₂ in the range of 200-1000 ppm of CO concentration. Such a high sensor response of CuO/SnO₂-In₂O₃ may originate from the high dispersion of CuO playing a role as sensing site.     

Properties of variations in the periods of ring neural oscillators with noise

Effects of additive noise on a series of the periods of oscillations in unidirectionally coupled ring neural networks of ring oscillator type are studied. Kinematical models of the traveling waves of an inconsistency, i.e. the successive same signs in the states of adjacent neurons in the network, are derived. A series of the half periods in the network of N neuron is then expressed by the sum of N sequences of the N-first order autoregressive process, the process with the spectrum of exponential type and the first-order autoregressive process. Noise and the interaction of the inconsistency cause characteristic positive correlations in a series of the half periods of the oscillations. Further, an experiment on an analog circuit of the ring neural oscillator was done and it is shown that correlations in the obtained periods of the oscillations agree with the derived three expressions.     

Slow eye movement as a possible predictor of reaction delays to auditory warning alarms in a drowsy state

In recently developed intelligent vehicles, warning alarms are often used to prompt avoidance behaviours from drivers facing imminent hazardous situations. However, when critical reaction delays to auditory stimulation are anticipated, the alarm should be activated earlier to compensate for such delays. It was found that reaction times to an auditory stimulus significantly increased in the presence of slow eye movement (SEM), which is known to occur frequently during the wake-sleep transition. The reaction delay could not be attributed to temporal effects such as fatigue and was invariant regardless of response effectors (finger or foot). Moreover, it was found that applied pedal force decreased immediately after an auditory stimulus interrupted SEM. Consequently, it was concluded that SEM can be a good predictor of reaction delays to auditory warning alarms when drivers are in a drowsy state. STATEMENT OF RELEVANCE: The present study demonstrated that simple auditory reaction time significantly increased when SEM emerged. In the design of vehicle safety systems using warning alarms to prompt avoidance behaviours from drivers, such reaction delays during SEM must be taken into account.     

Information gathering and searching approaches on the Web

The information accessible through the Internet is increasing explosively as the Web is getting more and more widespread. In this situation, the Web is indispensable information resource for both of information gathering and information searching. Though traditional information retrieval techniques have been applied to information gathering and searching in the Web, they are insufficient for this new form of information source. Fortunately some Al techniques can be straightforwardly applicable to such tasks in the Web, and many researchers are trying this approach. In this paper, we attempt to describe the current state of information gathering and searching technologies in the Web, and the application of AI techniques in the fields. Then we point out limitations of these traditional and AI approaches and introduce two aapproaches: navigation planning and a Mondou search engine for overcoming them. The navigation planning system tries to collect systematic knowledge, rather than Web pages, which are only pieces of knowledge. The Mondou search engine copes with the problems of the query expansion/modification based on the techniques of text/web mining and information visualization. Seiji Yamada, Dr. Eng.: He received the B.S., M.S. and Ph.S. degrees in control engineering and artificial intelligence from Osaka University, Osaka, Japan, in 1984, 1986 and 1989, respectively. From 1989 to 1991, he served as a Research Associate in the Department of Control Engineering at Osaka University. From 1991 to 1996, he served as a Lecturer in the Institute of Scientific and Industrial Research at Osaka University. In 1996, he joined the Department of Computational Intelligence and Systems Science at Tokyo Institute of Technology, Yokohama, Japan, as an Associate Professor. His research interests include artificial intelligence, planning, machine learning for a robotics, intelligent information retrieval in the WWW, human computer interaction, He is a member of AAAI, IEEE, JSAI, RSJ and IEICE. Hiroyuki Kawano, Dr.Eng.: He is an Associate Professor at the Department of Systems Science, Graduate School of Informatics, Kyoto University, Japan. He obtained his B.Eng. and M.Eng. degrees in Applied Mathematics and Physics, and his Dr.Eng. degree in Applied Systems Science from Kyoto University. His research interests are in advanced database technologies, such as data mining, data warehousing, knowledge discovery and web search engine (Mondou). He has served on the program committees of several conferences in the areas of Data Base Systems, and technical committes of advanced information systems.     

SiO2 thin film deposition on the inner surface of a poly(tetra-fluoroethylene) narrow tube by atmospheric-pressure glow microplasma

SiO₂ thin films were deposited on the inner surfaces of a commercial poly(tetrafluoroethylene) narrow tube with an inner diameter of 0.5 mm using tetraethoxysilane/O₂ feedstock gases and He carrier gas by atmospheric-pressure microplasma-enhanced chemical vapor deposition. A glow microplasma was generated inside the tube by radio frequency (RF) capacitively coupled discharge. X-ray photoelectron spectroscopy spectra showed that the tube inner surface was covered by a SiO₂ thin film. Transparent SiO₂ thin films were obtained with a deposition rate of 230 nm/min at an RF power of 6 W and substrate temperature of 100 °C. The wettability of the SiO₂-coated tube was about 3 times as large as that of an untreated sample tube.     

Thermal buckling of cross-ply laminated composite and sandwich plates according to a global higher-order deformation theory

A two-dimensional global higher-order deformation theory is presented for thermal buckling of cross-ply laminated composite and sandwich plates. By using the method of power series expansion of continuous displacement components, a set of fundamental governing equations which can take into account the effects of both transverse shear and normal stresses is derived through the principle of virtual work. Several sets of truncated Mth-order approximate theories are applied to solve the eigenvalue problems of a simply supported multilayered plate. Modal transverse shear and normal stresses can be calculated by integrating the three-dimensional equations of equilibrium in the thickness direction, and satisfying the continuity conditions at the interface between layers and stress boundary conditions at the external surfaces. Numerical results are compared with those of the published three-dimensional layerwise theory in which both in-plane and normal displacements are assumed to be C⁰ continuous in the continuity conditions at the interface between layers. Effects of the difference of displacement continuity conditions between the three-dimensional layerwise theory and the global higher-order theory are clarified in thermal buckling problems of multilayered composite plates.     

Shape from Shading with Interreflections Under a Proximal Light Source: Distortion-Free Copying of an Unfolded Book

We address the problem of recovering the 3D shape of an unfolded book surface from the shading information in a scanner image. This shape-from-shading problem in a real world environment is made difficult by a proximal, moving light source, interreflections, specular reflections, and a nonuniform albedo distribution. Taking all these factors into account, we formulate the problem as an iterative, non-linear optimization problem. Piecewise polynomial models of the 3D shape and albedo distribution are introduced to efficiently and stably compute the shape in practice. Finally, we propose a method to restore the distorted scanner image based on the reconstructed 3D shape. The image restoration experiments for real book surfaces demonstrate that much of the geometric and photometric distortions are removed by our method.     

A versatile planar QCM-based sensor design for nonlabeling biomolecule detection

Despite high theoretical sensitivity, low-cost manufacture, and compactness potentially amenable to lab-on-a-chip use, practical hurdles have stymied the application of the quartz crystal microbalance (QCM) for aqueous applications such as detection of biomolecular interactions. The chief difficulty lies in achieving a sufficiently stable resonance signal in the presence of even minute fluctuations in hydrostatic pressure. In this work, we present a novel versatile planar sensor chip design (QCM chip) for a microliter-scale on-line biosensor. By sealing the quartz resonator along its edges to a flat, solid support, we provide uniform support for the crystal face not exposed to solvent, greatly decreasing deformation of the crystal resonator under hydrostatic pressure. Furthermore, this cassette design obviates the need for direct handling when exchanging the delicate quartz crystal in the flow cell. A prototype 27-MHz sensor signal exhibited very low noise over a range of flow rates up to 100 microL/min. In contrast, signals obtained from a conventional QCM sensor employing an O-ring-based holder were less stable and deteriorated even further with increasing flow rate. Additional control designs with intermediate amounts of unsupported undersurface yielded intermediate levels of stability, consistent with the interpretation that deformation of the crystal resonator under fluctuating hydraulic pressure is the chief source of noise. As a practical demonstration of the design's high effective sensitivity, we readily detected interaction between myoglobin and surface-bound antibody.