低电压氧化锌压敏电阻器的研究

研究了一种制造低电电压氧化锌压敏电阻器的方法。在基本成分的基础上适当加入二氧化钛可降低梯度电压（Ｖ１ｍＡ／ｍｍ），适量掺硼和改进热处理工艺可减小元件的漏电流和提高其稳定性。     

Site occupations and ordering behaviour of O phase in Ti2AlNb—based intermetallics

1　ＩＮＴＲＯＤＵＣＴＩＯＮＴｈｅｏｒｔｈｏｒｈｏｍｂｉｃａｌｌｏｙｓａｒｅｏｆｇｒｅａｔｔｅｃｈ ｎｏｌｏｇ ｉｃａｌｉｎｔｅｒｅｓｔｉｎｈｉｇｈｔｅｍｐｅｒａｔｕｒｅａｐｐｌｉｃａｔｉｏｎｓｓｉｎｃｅｔｈｅｙｈａｖｅａｇｏｏｄｂａｌａｎｃｅａｍｏｎｇｓｔ     

An Analytical Model Including Interface Traps and Temperature Effects in Negative Capacitance Double Gate Field Effect Transistor

Silicon - In this paper, an analytical model for negative capacitance double gate field effect transistor (NC-DG-FET) is proposed. This model includes interface traps and temperature effects, which...     

煤焦油加工技术的探讨

煤焦油曾为近代有机化工作出了历史性贡献。我国煤焦油资源丰富,但尚未得到有效和合理利用。根据高温煤焦油的组成特点,对煤焦油的初馏、沥青加工利用和煤焦油产品的深加工技术进行了探讨,提出一些建议。此外还讨论了煤焦油加工企业的发展模式。     

6m大容积焦炉烘炉实践与体会

介绍了 6 m大容积焦炉由冷态到转入正常加热温度的烘炉操作过程中 ,按照一定的升温曲线 ,通过对焦炉热工和炉体膨胀的科学管理 ,确保新建焦炉顺利由冷态过渡到生产状态。     

混合材对碱—碳酸盐反应的影响

利用快速测长法研究了混合材对碱—碳酸盐反应的影响。通过试验证明混合材能减缓碱—碳酸盐反应的速度,但不能有效地抑制碱—碳酸盐反应,并初步探讨了混合材不能有效地抑制碱—碳酸盐反应的机理。     

Measurement of the rheological properties of polymer melts with annular rheometer

An annular die has been designed having a very thin gap distance between two coaxial cylinders. The die was then used to measure wall normal stresses along the longitudinal direction of polymer melts flowing through the thin annulus. The materials investigated were high-density polyethylene, low-density polyethylene, polypropylene, and polystyrene. Also investigated were blends of polystyrene and polypropylene, and blends of polystyrene and high-density polyethylene The measurements of wall normal stresses were used to determine the rheological properties of the melts, namely, the melt viscosity from the slope of axial wall normal stress profiles and the melt elasticity from exit pressures. The interpretation of the experimental data was made possible by the fact that the narrow-gap annular die can be considered as a substitute for a thin slit die. It has been found that the results obtained in the present study are consistent with those reported earlier by the author, who at that time used both capillary and slit dies.     

Rheological properties of mixtures of molten polymer and fluorocarbon blowing agent. I. Mixtures of low-density polyethylene and fluorocarbon blowing agent

The viscosities of mixtures of low-density polyethylene and fluorocarbon blowing agent were determined from the measurement of wall normal stress along the longitudinal axis of a capillary die. For the study, three different grades of commercial high-pressure low-density polyethylene were used, together with the following fluorocarbon blowing agents, dichlorodifluoromethane (FC-12), dichlorotetrafluoroethane (FC-114), and blends of FC-12 and FC-114. In the experiment, blowing agent concentration and melt temperature were varied for each combination of polymer and blowing agent employed. Analysis of the experimental data has led to a correlation between the viscosity reduction factor (VRF) and the blowing agent concentration, in which VRF is defined as the ratio of the viscosity of polymer-blowing agent mixture to that of the polymer alone. It was found that the correlation obtained is independent of shear rate and temperature and dependent upon only the type of fluorocarbon blowing agent. The practical significance of the correlation is discussed. We have shown that the entrance pressure drop obtained in the absence of phase separation in the entrance region may be used as a measure of the elastic properties of mixtures of fluorocarbon blowing agent and low-density polyethylene resin.     

半刚性钢-混凝土组合节点受弯承载力的计算

在半刚性钢 -混凝土组合框架中 ,混凝土板中的纵向钢筋增加了节点的强度和刚度 ,但是 ,传统的设计方法往往忽略纵向钢筋的作用而采用简化的计算模型。因此 ,出于经济效益考虑 ,应该根据半刚性组合节点的实际受力性能建立更加准确的计算方法。这里详细介绍了考虑混凝土板纵向钢筋作用的半刚性组合节点受弯承载力的计算方法 ,计算结果表明 ,建议的公式与试验结果吻合良好 ,可供规范制定和工程应用参考。     

Guerbet十四醇的合成与表征

以正庚醇为原料 ,通过Guerbet反应合成Guerbet十四醇 (2 戊基壬醇 ,C14 GA)。用IR、NMR和元素分析测定了C14 GA的结构 ,并研究了反应温度和用料比对其产率的影响。实验结果如下 :(1)在较优化的反应条件下 (正庚醇的总加入量为 1mol,在实验过程中 ,先加入 1/ 3mol庚醇和 1/ 4mol的KOH ,在 16 0℃下反应 2h ,然后再加入剩下的 2 / 3mol庚醇和 4g 5 %Pd -C催化剂 ,在 15 5℃下反应 6h)合成产物 ,其产率可达到 5 4 2 0 % ;(2 )所合成的产物与试图要得到的Guerbet十四醇 (2 戊基壬醇 ,C14 GA)含有相同的基团 (2×—CH3、10×—CH2 —、1×CH、1×—CH2 —O—和 1×—OH) ,而且 ,所合成的产物中 ,w (C) =79 0 6 % ,w (H ) =13 6 2 % ,与从Guerbet十四醇分子式计算的理论值w(C) =78 5 0 % ,w (H) =14 0 1%基本一致。可见所合成的产物正是Guerbet十四醇 (C14 GA)