X80焊管H_2S环境应力腐蚀开裂行为研究

采用三点弯曲加载法和微电极扫描测试技术,研究了X80高强度级管线钢及其焊缝区的抗H2S环境应力腐蚀开裂(SSCC)行为。测定了焊接接头的显微硬度分布,分析了显微组织结构、力学性能及抗腐蚀性能之间的相关性。研究表明,热影响区(HAZ)对应力腐蚀开裂最为敏感,母材的纵向和横向取样对应力腐蚀敏感性影响不显著,薄壁管材比厚壁管材有较好的抗H2S环境应力腐蚀性能。HAZ晶粒粗大、硬度高,局部腐蚀倾向大,由此导致该区SSCC敏感性高。     

Reduced-rate retransmissions for spread-spectrum packet radio multimedia networks

A reduced-rate retransmission (RRR) scheme is proposed for improving the throughput performance of spread-spectrum packet radio networks. The scheme takes advantages of the available multi-rate scalable source coding techniques. It assumes that several versions of a data packet with different sizes (number of information bits) are available. The transmission of a packet starts from its full-size version. If the full-size version is not correctly received, its half-size version is used in the retransmission. If further retransmissions are needed, the quarter-size version and so on are used. The shrunk packets are transmitted either in a minislot if the processing gain is kept the same, or occupying a slot duration by increasing the processing gain proportionally. In both cases, the effective signal to interference ratio for a packet is increased. As a result, the system throughput is improved. Theoretical and numerical results are provided in this paper which illustrate the throughput improvement. Another advantage of the proposed RRR scheme is that the packet-size reduction provides finer granules for link adaptation. Therefore, it is especially suitable for multimedia applications for which codes of variable rate for the source data are available and which can tolerate gracefully degraded quality of service. The performance of the proposed scheme in fading channels is also addressed.     

Global stability of Internet congestion controllers with heterogeneous delays

In this paper, we study the problem of designing globally stable, scalable congestion control algorithms for the Internet. Prior work has primarily used linear stability as the criterion for such a design. Global stability has been studied only for single node, single source problems. Here, we obtain conditions for a general topology network accessed by sources with heterogeneous delays. We obtain a sufficient condition for global stability in terms of the increase/decrease parameters of the congestion control algorithm and the price functions used at the links.     

双层有机电致发光器件有机层厚度优化的数值研究

在陷阱电荷限制电流传导理论的基础上,提出了双层有机电致发光器件的数值模型,研究了结构为"阳极/空穴输运层(HTL)/发光层(EML)/阴极"的器件中电流密度和量子效率随有机层的特征陷阱能量、陷阱密度和载流子迁移率的依赖关系. 研究发现,对于给定的HTL和EML的特征陷阱能量、陷阱密度和载流子迁移率,存在一个最优的HTL和EML之间的厚度比率,在此最优厚度比下,器件的电流密度和量子效率达到最大.通过有机层厚度的优化,器件的电流密度和量子效率可提高多达两个数量级.另外,还研究了最优厚度比随有机层特征陷阱能量、总陷阱密度和载流子迁移率之间的定量关系.     

Supermedia-enhanced Internet-based telerobotics

This paper introduces new planning and control methods for supermedia-enhanced real-time telerobotic operations via the Internet. Supermedia is the collection of video, audio, haptic information, temperature, and other sensory feedback. However, when the communication medium used, such as the Internet, introduces random communication time delay, several challenges and difficulties arise. Most importantly, random communication delay causes instability, loss of transparency, and desynchronization in real-time closed-loop telerobotic systems. Due to the complexity and diversity of such systems, the first challenge is to develop a general and efficient modeling and analysis tool. This paper proposes the use of Petri net modeling to capture the concurrency and complexity of Internet-based teleoperation. Combined with the event-based planning and control method, it also provides an efficient analysis and design tool to study the stability, transparency, and synchronization of such systems. In addition, the concepts of event transparency and event synchronization are introduced and analyzed. This modeling and control method has been applied to the design of several supermedia-enhanced Internet-based telerobotic systems, including the bilateral control of mobile robots and mobile manipulators. These systems have been experimentally implemented in three sites test bed consisting of robotic laboratories in the USA, Hong Kong, and Japan. The experimental results have verified the theoretical development and further demonstrated the stability, event transparency, and event synchronization of the systems.     

X射线光刻掩模背面刻蚀过程中的形变仿真

开发了理论模型以验证有限元方法用于X射线光刻掩模刻蚀过程数值仿真的正确性。利用相同的有限元技术，对X射线光刻掩模的背面开窗、Si片刻蚀过程进行数值仿真。结果表明，图形区域的最大平面内形变(IPD)出现在上、下边缘处，最大非平面形变(OPD)出现在左、右边缘处。此外对Si片单载荷步刻蚀和多载荷步刻蚀的仿真进行比较，结果表明图形区域最终的形变量与Si片刻蚀的过程无关。     

基于MPEG-2文件的合并

介绍了具有相同音频、视频编码方式的MPEG - 2节目流如何合并成一个节目流。合并后的文件播放流畅并且时间显示正确 ,它包括PATPMT表的重写 ,系统头部分相关字段的更改 ,PCR值的修改 ,解码时间标签 (DTS)和显示时间标签 (PTS)的重新确定 ,传送速率的修改以及添加相应的空包     

Software Cold Test Simulation of Coupled Cavity Slow-Wave Structure in Millimeter Wave TWT

In this paper, the software cold-test simulation method to obtain RF dispersion, interaction impedance by MAFIA software is discussed considering effect of the conducting barrel in the millimeter-wave TWT. The dispersion simulation result is obtained more consistent with experiment data than the method that ignoring effect of the conducting barrel. By changing the structure parameter, high frequency characteristic will be affected. The change relationship of high frequency characteristic with structure parameter is obtained. The different calculation methods of the interaction impedance are discussed. These results are received and are consistent with experiment data.     

地形测绘激光成像雷达技术研究

激光雷达作为一种低成本、高效率的获取空问数据的方法,已成为测绘遥感技术的重要发展方向.结合地形测绘领域的应用要求,对激光雷达在该领域的国外发展状况进行了评述,简要介绍了激光成像雷达的工作原理,对指标和关键技术进行了分析.     

复合材料管状结构的能量吸收性能

复合材料结构作为防撞结构的能量吸收元件,已经逐步得到工程领域的广泛认同。复合材料结构的能量吸收能力是一种特殊要求的力学性能,它的研究目标和研究手段有其独特之处。综述了近年来复合材料管状结构能量吸收性能研究的最新进展,以及有待进一步研究的问题。