Iodine reaction of vinyl acetate/vinyl propionate copolymers. III. Iodine affinities of the radically polymerized copolymers and the copolymers derived from partially saponified polyvinyl acetate

The minimum sequence lengths (n_c) of vinyl acetate (VAc) units necessary to form a colored iodine complex were determined to be 4 and 17 for radically polymerized VAc/vinyl propionate (VPr) and VAc/isopropenyl acetate (IPAc) copolymers, respectively. The iodine affinities (I/VAc) of VAc/VPr copolymers (SP-series) obtained by propionylation of partially saponified polyvinyl acetate (PVAc) were remarkably affected by the saponification conditions. An increase of the water content in acetone/water mixture as saponification solvent brought about a decrease of the iodine affinities of the SP-series. The dependence of the iodine affinity on the saponification of monomer units in the SP-series was compared with that in the radically polymerized VAc/VPr copolymers by taking the sequence probability as the measure of monomer unit distribution. The results strongly supported an occurence of the slide fastener reaction at high degrees of saponification, which was well-known in the saponification of PVAc. Furthermore, it was found that the saponification mode of PVAc at low degrees of saponification was influenced uniquely by the water content in saponification solvents and the saponification temperature.     

Water electrolysis under microgravity: Part 1. Experimental technique

Water electrolysis was conducted in both alkaline (25 wt.% KOH, 2 wt.% KOH) and acid (0.1N H₂SO₄) solutions for 8 s under microgravity environment realized in a drop shaft. The gas bubble formation of hydrogen and oxygen on platinum electrodes was observed by CCD camera. In alkaline solutions, a bubble froth layer grew on the electrode surface. Hydrogen bubble size was smaller than that of oxygen. The current density at constant potential decreased continually with time. In spite of the growth of a bubble froth layer on the electrode, the electrolysis never stopped, apparently because fresh electrolyte is supplied to the electrode surface by microconvection induced by the gas bubble evolution. In acid solution, hydrogen gas bubbles frequently coalesced on the cathode surface, yielding a larger average bubble than that of oxygen. The current density did not vary at constant potentials from –0.4 to −0.8 V versus reversible hydrogen electrode (RHE), because the effective electrode surface area was significantly reduced by the larger bubble size compared to alkaline electrolyte. The present experiments indicate that, especially in a microgravity environment, the bubble evolution behavior and the resultant current–potential curves are significantly influenced by the wettability of the electrode in contact with the electrolyte.     

Preparation of superacid of iron-supported zirconia for reaction of butane to isobutane

A highly active superacid of 2 wt% Fe-supported ZrO₂ for the skeletal isomerization of butane to isobutane was obtained by sfexposing Fe₂O₃/ZrO₂ to 1 N H₂SO₄ followed by calcining in air at 700°C for more than 24 h; the Fe₂O₃/ZrO₂ was prepared by impregnating zirconia gel with a solution of Fe(NO₃)₃ followed by drying at 300°C (2 wt% Fe). A much lower activity was observed with the opposite procedure, where the first impregnation was sulfation of the gel, followed by a second impregnation with the iron compound. It was proved from analysis of the sulfur content in the catalysts that residual sulfur species were not related with generation of the superacidic sites. XPS showed the catalyst to be Fe₂O₃ supported on ZrO₂.Superacids by metal oxides, VIII. For previous publications VI and VII in this series see refs. [10,11].     

Chaos in parametric resonance flow at water-mercury interface

In the electrochemical system with liquid-liquid interface, intense local convections by the resonance with potential pulses take place. Therefore, with laser beam scattering, temporal movement of the water-mercury interface was observed. As a result, the scattering efficiency showed non-linear oscillation.

Such non-linear response could be controlled by potential pulse height. As the potential height was increased, new scattering peaks in the oscillation emerged, which was expected of a kind of bifurcation phenomenon. From these results, phase portrait, Poincarè section, correlation dimension of the strange attractor and the largest Lyapunov exponent of the trajectories were obtained. Consequently, it was concluded that all the parameters indicate chaotic behavior of the resonance flow.     

Cationic copolymerization behavior of a bicyclic orthoester having hydroxy group with glycidyl phenyl ether and volume change on their copolymerization

This article describes cationic ring‐opening copolymerization of a bicyclic orthoester having hydroxy group (BOE‐OH) and glycidyl phenyl ether (GPE), and the volume shrinkage behavior during the copolymerization. THF soluble polyethers [poly(BOE‐OH‐co‐GPE)] were obtained by the copolymerizations at 80–180°C, while crosslinked poly(BOE‐OH‐co‐GPE) was obtained by the copolymerizations at 220–250°C. This crosslinking reaction may originate from the dehydration of methylol groups in the side chain of poly(BOE‐OH‐co‐GPE). The volume shrinkage during the cationic copolymerization reduced as the increase of the BOE‐OH feed ratio. By contrast, the volume shrinkage on the crosslinking polymerization was almost independent on the BOE‐OH feed ratio. Poly(BOE‐OH‐co‐GPE)s with higher BOE‐OH composition showed lower thermal weight loss temperature owing to the release of H₂O by dehydration of methylol groups. The BOE‐OH component in the THF soluble poly(BOE‐OH‐co‐GPE)s lowered the glass transition temperature (T_g), while that in the crosslinked poly(BOE‐OH‐co‐GPE) increased the T_g probably because of the higher crosslinking density. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 101: 1356–1361, 2006     

The Failure of the Strong Pumping Lemma for Multiple Context-Free Languages

Seki et al. (Theor. Comput. Sci. 88(2):191–229, 1991) showed that every m-multiple context-free language L is weakly 2m-iterative in the sense that either L is finite or L contains a subset of the form \(\{ u_{0} w_{1}^{i} u_{1} \cdots w_{2m}^{i} u_{2m} \mid i \in \mathbb {N}\}\) , where w ₁?w _2n ≠ε. Whether every m-multiple context-free language L is 2m-iterative, that is to say, whether all but finitely many elements z of L can be written as z=u ₀ w ₁ u ₁?w _2m u _2m with w ₁?w _2m ≠ε and \(\{ u_{0} w_{1}^{i} u_{1} \cdots w_{2m}^{i} u_{2m} \mid i \in \mathbb {N}\} \subseteq L\) , has been open. We show that there is a 3-multiple context-free language that is not k-iterative for any k.     

Balanced corpus of contemporary written Japanese

The balanced corpus of contemporary written Japanese (BCCWJ) is Japan’s first 100 million words balanced corpus. It consists of three subcorpora (publication subcorpus, library subcorpus, and special-purpose subcorpus) and covers a wide range of text registers including books in general, magazines, newspapers, governmental white papers, best-selling books, an internet bulletin-board, a blog, school textbooks, minutes of the national diet, publicity newsletters of local governments, laws, and poetry verses. A random sampling technique is utilized whenever possible in order to maximize the representativeness of the corpus. The corpus is annotated in terms of dual POS analysis, document structure, and bibliographical information. The BCCWJ is currently accessible in three different ways including Chunagon a web-based interface to the dual POS analysis data. Lastly, results of some pilot evaluation of the corpus with respect to the textual diversity are reported. The analyses include POS distribution, word-class distribution, entropy of orthography, sentence length, and variation of the adjective predicate. High textual diversity is observed in all these analyses.     

The effect of sputter etching on the surface characteristics of dyed aramid fabrics

Three kinds of aramid fabrics, Technora (modified p-aramid), Conex (m-aramid) and Kevlar (p-aramid), were subjected to sputter etching and argon low-temperature plasma treatments after dyeing in black with disperse dyes. The depth of shade increased considerably on Technora and Kevlar with the sputter etching treatment, but not on Conex fabrics. Argon low-temperature plasma treatment had virtually no effect on the depth of shade on the aramid fabrics.