Boiling two-phase flow under microgravity

To study the effects of reduced gravity on the flow regime and the heat transfer characteristics of a boiling two-phase horizontal flow, parabolic flight experiments were performed by using an aircraft. The gravity level during the parabolic flight and the duration time were about −0.01g_e +0.01g_e and 20 s, respectively. Under earth gravity, many small bubbles are detached very frequently from the heater rod surface, flowing into the upper stream due to the buoyancy and resulting in a stratified flow in the cases of lower inlet fluid velocity and higher heat flux. Under microgravity conditions, bubbles are hardly detached from the heater rod, growing and coalescing to become much larger along the heater rod, surrounding the heater rod in the downstream. This tendency was more noticeable in the cases of lower inlet fluid velocity, higher heat flux and lower inlet fluid subcooling. The local heat transfer coefficients at the bottom of the heater rod tend to decrease slightly under microgravity compared with those under earth gravity because of the reduction of the heat removal due to natural convection. On the other hand, the local heat transfer coefficients at the top of the heater rod tend to increase slightly under microgravity. However, the differences of the local heat transfer coefficients are very small in spite of large differences of the flow regimes under earth gravity and microgravity.     

Plasma amino acid profile in relation to arterial ketone body ratio in surgical patients

A total of 357 plasma amino acid profiles from 93 surgical patients were statistically analyzed in relation to the changes in arterial ketone body ratio, which reflects the hepatic mitochondrial redox state. When the arterial ketone body ratio was above 0.7, all plasma amino acid levels were within the normal range. When it was between 0.7 and 0.4, plasma levels of aspartate, glutamate, valine, isoleucine, leucine, ornithine, and arginine decreased, and plasma levels of tyrosine, phenylalanine, proline, and methionine increased. Furthermore, when it was below 0.4, almost all plasma amino acids markedly increased. These results indicate that arterial ketone body ratio accurately reflects the alterations in plasma amino acid profile, and can serve as an indicator for providing nutritional support by amino acid supplement in surgical patients.     

Bending fatigue strength of case-carburized helical gears with large helix angles up to 40 degrees

Case-carburizing of helical gears with large helix angles may form too large hardened layers near the tooth width end on the acute angle side (ACUTE-END), and adversely affect the bending fatigue strength. We investigated the bending fatigue strength of casecarburized helical gears with large helix angles up to approximately 40° through a bending fatigue test, hardness test, and residual stress measurement. We found that the case-carburizing formed large hardened layers near ACUTE-END, reduced the compressive residual stress near ACUTE-END, and restricted the improvement of the bending fatigue strength in a meshing state where tooth root stress became large near ACUTE-END. Based on the obtained bending fatigue limits, we revealed that ISO 6336-3:2006 overestimated the rate of increase of the permissible circumferential loads for helix angles exceeding approximately 30°, and ISO/DIS 6336-3:2018 underestimated this rate for helix angles near 30°.

     

Synthesis of Sintered Diamond with High Electrical Resistivity and Hardness

Diamond and diamond-ultrafine Co powder mixtures were sintered at 7.7 GPa and 1800° to 2000°C. A well-sintered body with a fine-grained homogeneous microstructure, high hardness, and high electrical resistivity was produced when a diamond-5 vol% Co powder mixture was used as the starting material.     

Extraction of negative hydrogen ions from a compact 14 GHz microwave ion source

A pair of permanent magnets has formed enough intensity to realize electron cyclotron resonance condition for a 14 GHz microwave in a 2 cm diameter 9 cm long alumina discharge chamber. A three-electrode extraction system assembled in a magnetic shielding has formed a stable beam of negative hydrogen ions (H(-)) in a direction perpendicular to the magnetic field. The measured H(-) current density was about 1 mA∕cm(2) with only 50 W of discharge power, but the beam intensity had shown saturation against further increase in microwave power. The beam current decreased monotonically against increasing pressure.     

A high-speed bit synchronization circuit by direct control of the oscillation phase of a VCO

In a large-scale broadband communication system, thousands of high-speed serial data interconnections are used and a bit synchronization circuit (a clock and data recovery circuit) is required in each of the receiver side interconnection circuits. In this paper, the requirements and the implementation of a bit synchronization circuit for the interconnection are considered, and one solution is proposed. In the proposed circuit, the oscillation phase of a VCO is directly controlled by the trigger signal extracted from the input data. Synchronization capture is quick and the circuit is applicable to burst signals. The circuit tolerates jitter and phase variation of the incoming data. The circuit requires no external components, and is suitable for an integrated circuit. The circuit was implemented using a 0.5 μm CMOS process and the data recovery operation from a 440 Mbps pseudo-random pattern was confirmed. Data acquisition is accomplished within three clock periods from 440 Mbps burst data. © 1998 Scripta Technica, Electr Eng Jpn, 125(2): 35–43, 1998     

Study of prevention of solidification cracking in Al‐Mg‐Si alloy laser welds. CO2 laser welding of Al‐Mg‐Si alloys (1st report)

The choice of weld bead size in the case of welded cruciform joints can be problematic, especially when the sheets forming the joint are of differing thickness. Technological standards generally recommend a weld bead thickness less than the minimum thickness of the sheets to be joined, whereas structural standards do not envisage any dependency between joint static and fatigue strength and weld bead dimensions, unless these are so reduced as to lead to failure starting and propagating in the weld bead itself rather than the base metal plates. The scope of this study is the theoretical and experimental analysis of the change in fatigue strength with varying weld bead thickness and minimum welded plate thickness.     

Evaluation of corrosion behaviors for reactor pressure vessels/primary containment vessels in Fukushima Daiichi units 1–3 nuclear power plant

Fukushima Daiichi nuclear power plants (1F) were damaged by unprecedented severe accident in the Great East Japan Earthquake on 11 March 2011, and seawater has been injected as an emergency countermeasure for the core cooling. Although, the RPV and PCV were not supposed to be exposed to diluted seawater, they have been exposed to diluted seawater environment or high-moisture environment. Therefore, seawater corrosion has become an important issue. Immersion corrosion tests were performed for low-alloy steel of RPV material and carbon steel of PCV material in 1F cooling-water-simulated environment. As a result, the mass loss by corrosion was reduced with the decreasing temperature and chloride ion concentration. Moreover, the effects of nitrogen deaeration and Na₂WO₄ addition on corrosion protection were remarkable among the selected corrosion countermeasures. In addition, the integrity assessments of RPV and PCV were performed considering the reduction of plate thickness based on corrosion test data and the load condition based on earthquake response analysis results. It had been confirmed that primary stresses for RPV and PCV equipment satisfied with the allowable values until at least 15 years after the accident.     

Simulation study of the influence of different urban canyons element on the canyon thermal environment

The heat island effect is an important issue for large cities, especially those located in hot and moist climates. The phenomenon is more severe in urban canyons because surrounding high-rise buildings allow little ventilation and dissipation of heat caused by traffic. The primary goal of the present study is to investigate the thermal environment of a major street in Osaka by intensive measurement during the summer of 2006. Osaka is the second largest city in Japan and suffers from the most severe heat island effect. In addition, several fundamental renovations and a composite renovation for the improvement of thermal environment in the urban canyon are proposed, and the efficacies of these measures are verified by computational fluid dynamics (CFD) simulation. It was found that by modifying the heights of buildings along the street and the ground surface materials and increasing the quantity of vegetation, the thermal environment can be improved by a 2.0°C. reduction in standard new effective temperature (SET^*) at maximum.     

Completely Chemically Synthesized Long DNA Can be Transcribed in Human Cells

Chemical ligation reaction of DNA is useful for the construction of long functional DNA using oligonucleotide fragments that are prepared by solid phase chemical synthesis. However, the unnatural linkage structure formed by the ligation reaction generally impairs the biological function of the resulting ligated DNA. We achieved the complete chemical synthesis of 78 and 258 bp synthetic DNAs via multiple chemical ligation reactions with phosphorothioate and haloacyl-modified DNA fragments. The latter synthetic DNA, coding shRNA for luciferase genes with a designed truncated SV promoter sequence, successfully induced the expected gene silencing effect in HeLa cells.