试验温度和停放时间对胶料加工性能的影响

研究试验温度和停放时间对胶料加工性能的影响。结果表明，试验温度对胶料的门尼粘度、门尼焦烧时间和硫化特性均有一定影响。门尼粘度测定的试验温度选择100℃；门尼焦烧时间测定的试验温度一般选120℃，SBR胶料可提高至130℃左右，以缩短试验时间；硫化特性测定的试验温度一般选185℃。试验前模腔达到规定温度后再保持15min，以使转子与模腔温度一致。胶料停放时间应控制在2h左右。     

振动筛板槽中液滴分散动力学的研究(Ⅰ)实验研究及理论分析

本文通过实验观察发现,液滴的破碎只有在液滴与振动筛板孔口发生碰撞时才发生.基于这个实验现象,建立了振动筛板槽内液滴破碎的新模型.把筛板孔口附近的剪应力作为破碎力,破碎速率可表示为:G(d)=C_12Af/H(?)~n_4(d/d_h)~n_5[1-(d_(cr)/d)~(2n_1+1)]~0.5n(d)液滴的凝聚可以按气体分子碰撞过程来处理.凝聚速率可以用下式表示:ω(d_1,d_2)=C_Ⅱ(d_1+d_2)~(7/3)∈~（1/3)[β_d∈~(2/3)d_1+d_2/σ(d_1+d_2）~（1/3）]~n_6n(d_1)n(d_2)     

High temperature swelling of coal/tetralin mixtures in a high pressure microdilatometer

High pressure microdilatometer experiments were performed on a subbituminous (Wyodak) and a bituminous (Illinois no. 6) coal in helium and hydrogen atmospheres with and without added tetralin. Wyodak coal samples showed no swelling but contractions ranging between 24 and 40 vol% upon heating at 20 and 100 °C min^{− 1} under helium or hydrogen pressures between 150 and 1000 psig (˜1.0–6.9 MPa). Under the same conditions, Illinois no. 6 coals displayed contractions (25–60 vol%) prior to swelling up to 117 vol%. Upon tetralin addition (at 35–190 wt% of the coal), Wyodak coal samples did not swell but showed an increasing contraction with increasing helium or hydrogen pressure due to a slight softening and fusion of the coal particles. In contrast, addition of tetralin at much lower concentrations (5–35 wt%) had a marked effect on the contraction and swelling behaviour of Illinois no. 6. A maximum swelling of 200 vol% was obtained at a tetralin addition of 30 wt%. The increased swelling results from more extensive softening and fusion of coal particles in the presence of tetralin. Both coals showed a decreasing char yield with increasing tetralin concentration. The substantially lower extent of interaction observed between Wyodak coal samples and tetralin compared to Illinois no. 6 coal can be attributed to the differences in pore structure and/or chemical constitution of the two coal samples. Examination of the resultant solids by optical microscopy revealed the microstructural changes produced by thermal treatment in dilatometer experiments.     

基于STM32F407和OV7670的低端视频监控系统

本系统采用了意法半导体公司的STM32F407微处理器作为核心,以OV7670作为监控系统的视频采集传感器,并将传感器采集的数据通过DMA控制器成功地发送至液晶模块(SSD1289)显示。该系统运行流畅,为低端视频监控系统提供了一种新的解决方案。     

Processing and fracture behaviour of hot pressed silicon carbide whisker reinforced alumina

The improvement of mechanical properties of silicon carbide whisker reinforced alumina has been investigated with emphasis on the effects of the whisker type and content, the hot pressing temperature and the influence of an interfacial film between the whisker and the matrix. The introduction of silicon carbide whiskers significantly improves the fracture toughness, flexural strength and creep resistance of polycrystalline alumina.

However, these properties are strongly dependent on the size and morphology of whiskers. Large diameter whiskers generate extensive micro-cracking which leads to a decrease in flexural strength. Also, the presence of carbon-coated SiC whiskers substantially increases the high temperature strain rate by promoting cavitation. A grain boundary glassy phase introduced by the carbon coating was also detected.     

基因扩增仪与PC机串口通信的设计与实现

主要利用OK6410开发板串口通信模块和Qtcreator环境下使用的第三方串行通信控件qextserialport,在基因扩增仪下的LINUX操作系统基础上,对串口应用程序进行了开发和设计。完成对基因扩增仪进行外部控制命令的操作,使得基因扩增仪可根据PC机不同的请求执行相应的程序,并通过PC机进行数据反馈。     

TD-LTE与TD-SCDMA切换判决机制的探究与仿真

不同网络之间的切换问题是网络间互操作的重要组成部分,尤其是当前备受关注的TD-LTE与TD-SCDMA的切换问题。该文在对常规切换机制剖析的基础上,通过详尽的理论分析,根据现有切换机制的不足,提出了新的切换判决算法机制。新机制中结合了多属性切换判决中的层次分析算法和二维函数收益法,考虑了移动用户的业务喜好,并使用Matlab搭建了网络模型着重针对数据业务进行仿真,根据不同的网络收益值来实现切换的选择,验证了数据业务切换判决算法的有效性。     

一体化办公系统分布式部署

信息化的发展,移动互联的猛进,进一步催生了云计算的健康发展,在互联网环境下办公是IT发展的趋势,如何满足现代化办公的需要,如何建立高效、方便的运维方式,是我们认真考虑的问题。基于互联网,在系统架构时必须考虑可靠性、安全性,还要考虑系统能动态的方便扩充和访问流畅行,这便要求产品要有良好的系统架构,支持动态扩展和高效并发。本文以永中云办公为例,介绍了一体化办公系统分布式部署解决方案。