A Study on Turbo—rotor Multi—fault Diagnosis Based on a Neural Network

The multi-fault phenomena are common in the turbo-rotor system of a liquid rocket engine.As it has many excellent qualities,the neural network might be used to solve the problems of multi-fault diagnasis of a turbo-rotor system.First,the feature expression of a common turbo-rotor fault was studied in order to build up the standard fault pattern and satisfy the need of neural network studying and diagnosing.Then.the turbo-rotor fault identification and diagnosis problems were investigated by using a BP(back-propaga-tion)neural network.According to the BP neural network problems,the parallel BP neural network method of multi-fault diagnosis and classification was presented and investigated.The results indicated that the parallel Bp neural network method could solve the turbo-rotor multi-fault diagnosis problems.     

激光扫描加工图形控制模型的研究

针对激光扫描加工中存在固有图形畸变的情况,提出了DEA(dual-ends approch)控制模型。由于该模型不仅考虑了透镜焦距f、激光入射角θ、振镜偏转角和光学镜组之间的距离,而且还考虑了透镜中心厚度、透镜曲面曲率半径以及透镜介质折射率,因此提高了激光扫描加工系统的加工精度,减小了加工误差。同时利用VC++6.0编制了一个对话框程序,对传统fθ控制模型和DEA控制模型进行了分析比较,结果显示,DEA控制模型能正确表达所设计的加工图形,其精度高于fθ图形控制模型。     

大系统分散鲁棒容错控制的进展及主要成果

综述了近２０年来关联大系统分散鲁棒容错控制的研究动态及取得的主要成果。说明了统一地研究分散鲁棒容错控制的必要性。在分散控制、鲁棒控制和容错控制研究领域内，分析了各种设计方法的主导思想及实质；指出了这些研究成果的意义与存在的问题。文中着重论述了分散、鲁棒、容错控制研究方法的发展途径。     

Modeling and CW operation of a quasi-three-level 946 nm Nd: YAG laser

A model is developed for an end-pumped quasi-three-level laser with population in the lower laser level at equilibrium such as for transitions to the manifolds⁴I9/2in Nd³⁺,⁴I15/2in Er³⁺,⁵I8in Ho³⁺and³H6in Tm³⁺. It is shown that the effect of residual lower laser level population on laser operation can be treated as a saturable loss. Room temperature operation on the⁴F3/2-⁴I9/2transition in Nd:YAG under CW dye laser pumping has been demonstrated with a threshold as low as 11.5 mW incident power and a slope efficiency of 7 percent with 0.3 percent output coupling. Performance is limited by the low output coupling and diffraction loss.     

测定钠中杂质的手动阻塞计的研究

文章介绍了测定钠中杂质浓度的手动阻塞计的原理、装置和实验结果。为了减少测量误差,我们研究了影响准确测定阻塞温度的因素,并且找到了减少测量误差的办法。在同样的杂质饱和温度下,该阻塞计测得的高、低阻塞温度所对应的杂质浓度差是很接近的。对氧其差值为1.03ppm;对氢为0.0763ppm。     

Effect of misalignment on electrical characteristics of ACF joints for flip chip on flex applications

The effect of misalignment on the electrical properties of anisotropic conductive film (ACF) joints is investigated in this work. It is found that along with the increase of misalignment, the connection resistance of ACF joints increases. When the misalignment in x-direction is less than 5 μm, the increase rate of connection resistance is quite large. Then, along with the severity of misalignment, the increase rate becomes smaller. Finally, when the misalignment is close to 20 μm, the increase rate rises again. The Holm's electric contact theory is used for understanding the connection resistance variation. On the other hand, with the increase of misalignment in x-direction, the insulation resistance between ACF joints decreases. If the misalignment exceeded 10 μm, the decrease is prominent for the Ni particle ACF joints. This phenomenon can be explained by the effect of dielectric damage of the epoxy.Computer programs are also developed to calculate the variation of the probability of open and shorting after misalignment and predicate the maximum misalignment tolerance. The results show that the open and shorting probability increase abruptly after misalignment. On the view of pad parameters, the open probability is mainly related to the pad area, while the pads gap is critical to the shorting probability. Large pads gap (small pad width) can reduce the shorting probability obviously. On the other hand, enlarging the pad area by increasing pad length decreases the open probability significantly. So comparing to square shape pad, rectangle shape pad can reduce the failure probability greatly.     

基于PⅢ工控机VI测控系统远程控制研究

虚拟仪器（VI）将计算机采集测试分析引入到电子测量领域，用数字化和软件技术极大地提高了测量的灵活性。而VI远程测控系统是网络技术、通信技术一计算机虚拟技术结合的产物。远程控制技术能够使操作突破地域的限制，已在网络环境下PⅢ工控机上实现。     

A dual-mode multiuser detector for DS-CDMA systems

We introduce a dual-mode multiuser detector that dynamically switches its detection mode between matched-filter and decorrelator operations based on the channel characteristics. This detector significantly reduces the overall computational requirement while maintaining similar performance as that of the decorrelator. The switching mechanism of our dual-mode detector is designed by exploiting the performance-complexity tradeoff between the decorrelator and the matched-filter. Extensions of this idea to other types of multiuser detectors are also proposed     

两段式热脱焦油煤气炉在环形加热炉上的开发应用

介绍了两段式煤气发生炉热脱焦油煤气在无缝钢管环形加热炉上的开发与应用 ,以及两段式煤气发生炉热脱焦油煤气站的设计和采用热脱焦油煤气代替重油所产生的经济效益