A new region aware invisible robust blind watermarking approach

Multimedia Tools and Applications - The multimedia revolution has made a strong impact on our society. The explosive growth of Internet access to this digital information has generated new...     

Artificial neural network based system identification and model predictive control of a flotation column

The paper describes the design of a neural network based model predictive controller for controlling the interface level in a flotation column. For the system identification, the tailings valve opening is subjected to a pseudo-random ternary signal and response of the interface level is recorded over a period of time. The data so generated is used to develop a dynamic feed forward neural network model. The model uses two past values and one present value of the tailings valve opening as well as interface level as inputs and predicts the future interface level. This model is used for the design of a model predictive controller to control the interface level. The controller was tested both for liquid–gas system as well as liquid–gas–solid system and was found to perform very satisfactorily. The performance of the controller was compared with that of a conventional PI controller for a two-phase system and was found to be better.     

Variability-aware architecture level optimization techniques for robust nanoscale chip design

The design space for nanoscale CMOS circuits is vast, with multiple dimensions corresponding to process variability, leakage, power, thermal, reliability, security, and yield considerations. These design issues in the form of either objectives or constraints can be handled at various levels of digital design abstraction, such as architectural, logic and transistor. At the architectural level (a.k.a. Register-Transfer Level, RTL), there is a balanced degree of freedom for fast design exploration by exploring various values of design parameters. Correct design decisions at an early phase of the design cycle ensure that design errors are not propagated to lower levels of circuit abstraction, where it is costly to correct them. Moreover, design optimization at higher levels of abstraction provides a convenient way to deal with design complexity, facilitates design verification, and increases design reuse through intellectual property (IP) cores.     

A particle swarm approach for multi-objective optimization of electrical discharge machining process

This paper proposes an experimental investigation and optimization of various machining parameters for the die-sinking electrical discharge machining (EDM) process using a multi-objective particle swarm (MOPSO) algorithm. A Box–Behnken design of response surface methodology has been adopted to estimate the effect of machining parameters on the responses. The responses used in the analysis are material removal rate, electrode wear ratio, surface roughness and radial overcut. The machining parameters considered in the study are open circuit voltage, discharge current, pulse-on-time, duty factor, flushing pressure and tool material. Fifty four experimental runs are conducted using Inconel 718 super alloy as work piece material and the influence of parameters on each response is analysed. It is observed that tool material, discharge current and pulse-on-time have significant effect on machinability characteristics of Inconel 718. Finally, a novel MOPSO algorithm has been proposed for simultaneous optimization of multiple responses. Mutation operator, predominantly used in genetic algorithm, has been introduced in the MOPSO algorithm to avoid premature convergence. The Pareto-optimal solutions obtained through MOPSO have been ranked by the composite scores obtained through maximum deviation theory to avoid subjectiveness and impreciseness in the decision making. The analysis offers useful information for controlling the machining parameters to improve the accuracy of the EDMed components.     

Critical fluidization velocities and maximum bed pressure drops of homogeneous binary mixture of irregular particles in gas-solid tapered fluidized beds

Recently, tapered fluidized bed has become more attractive because of the problems associated with conventional (cylindrical) beds like fluidization of widely distributed particles, entrainment of particles and limitation of fluidization velocity. There have been some investigations on hydrodynamics of uniform single size particles but there have been no detailed studies of homogeneous binary mixture of particles of different sizes and different particles in tapered beds. In the present work, an attempt has been made to study the hydrodynamic characteristics of homogeneous binary mixture of irregular particles in tapered beds having different tapered angles. Correlations have been developed for important characteristics, especially critical fluidization velocities and maximum bed pressure drops of homogeneous binary mixture of irregular particles in gas-solid tapered fluidized beds. Experimental values of critical fluidization velocities and maximum bed pressure drops have been compared with the developed correlations.