Hydroxyapatite crystal growth on calcium hydroxyapatite ceramics

Calcium hydroxyapatite (Ca-HAP) ceramics containing tricalcium phosphate (TCP) were soaked in three solutions: phosphate buffer, tris buffer, and simulated body fluid (SBF). Petal-like crystals of Ca-HAP were deposited on the Ca-HAP ceramics when (i) Ca-HAP ceramics contained -TCP, (ii) the soaking solution contained phosphate ion and (iii) the pH of soaking solution was higher than 7.3. These conditions facilitate the presence of HPO ₄ ^2– and Ca²⁺ ions, the latter from dissolution of -TCP. A well-defined X-ray diffraction pattern for the deposited Ca-HAP crystals indicates preferred growth of {002} planes. Slower crystal growth of Ca-HAP was found for SBF (pH=7.5) than in the phosphate buffer, due possibly to the lower phosphate ion content in SBF.     

Crystallization of potassium titanate from the amorphous phase

By using amorphous potassium titanates as the starting materials, a sintered body of K₂Ti₄O₉ or K₂Ti₆O₁₃ with porous and fibrous textures was prepared. K₂Ti₂O₅ and a new phase, K₆Ti₄O₁₁ were synthesized by the thermal reaction of KNO₃ with TiO₂ at 1000° C for 10 to 20 h. On leaching in water to expel excess of potassium ions, both phases became amorphous. After mixing and moulding these amorphous materials in the desired proportion, a sintered body containing fibrous crystals of K₂Ti₄O₉ was readily fabricated by heating at 1000° C for 12 h. When 5 wt % B₂O₃ was added to the amorphous phases, single phase K₂Ti₆O₁₃, with a fibrous texture grew well on heating at 1000° C for 12 h. Addition of PVA polymer to the amorphous phases was responsible for controlling the porosity of the sintered body, e.g. about 52% theoretical density at 20 wt% PVA polymer. The optimum conditions for preparing the amorphous phases were systematically examined and the effect of the chemical reaction environments, such as different crucible materials on the calcination of KNO₃ and TiO₂ were also discussed.     

Thermophysical properties data on molten semiconductors

Thermophysical properties of molten semiconductors are reviewed. Published data for viscosity, thermal conductivity, surface tension, and other properties are presented. Several measurement methods often used for molten semiconductors are described. Recommended values of thermophysical properties are tabulated for Si, Ge, GaAs, InP, InSb, GaSb, and other compounds. This review shows that further measurements of thermophysical properties of GaAs and InP in the molten state are required. It is also indicated that a very limited amount of data on emissivity is available. Space experiments relating to thermophysical property measurements are described briefly.Nomenclature Density - C _p Specific heat - Kinematic viscosity - Dynamic viscosity= - Thermal diffusivity - Thermal conductivity=C_p - Volumetric thermal expansion coefficient - Surface tension - d/dT Temperature coefficient of surface tension - g Gravitational acceleration - T Temperature - T Temperature difference - L Characteristic dimension     

Co-crosslinking blend of incompatible polymers VI: Poly(vinyl chloride) toughened with polyethylene via a co-crosslinking technique

A binary blend which consists of two incompatible polymers such as poly(vinyl chloride) and polyethylene has been performed through a partial co-crosslinking reaction with peroxide to give a co-crosslinked blend with a uniform dispersion of small polyethylene particles and with an improved mechanical property. The results are obtained through the formation of a co-crosslinked product which acts as a potential solid phase dispersant as well as a well-bonded reinforcing interlayer on polyethylene particles uniformly dispersed in poly(vinyl chloride) matrix. The resulting blends (PVC/PE=10/90 wt) give carbon spherules of 0.5 to 1m diameter through pressure-carbonization at 650° C for 1 h.     

Formation of monodispersed Ta2O5 powders

The Ta₂O₅ powders synthesized by the hydrolysis of tantalum pentaethoxide, Ta(OC₂H₅)₅ in alcoholic solution were monodispersed fine oxide particles, which were a uniform, spherical shape, non-agglomerate, and had a narrow size distribution. They grew to 1.2m after ageing for 1 h after hydrolysis. Powder X-ray diffraction and differential thermal analysisthermogravimetric analysis showed the particles were amorphous and hydrated. These particles lost the water at 290° C and gave well-crystalline Ta₂O at 740° C. Throughout these thermal processes, the particle morphology was kept almost the same.     

Pulsed NMR study in nuclear ordered solid3He

The nuclear spin dynamics in nuclear spin ordered solid³He in low magnetic fields on the melting curve has been studied by pulsed NMR down to 0.6 mK. The free induction decay signals (FID) were measured in single crystals of solid³He at three operating frequencies of 920, 1380, and 1840 kHz. The FIDs were nonexponential and dependent on the rf pulse strength _p H ₁ t _w , where is the gyromagnetic ratio,H ₁ is the rf field strength, andt _w is the pulse width. At small _p they decayed almost linearly in time with a small exponential tail at the end. When _p was further increased they became shorter and neither exponential nor linear in time. At large _p they decayed very rapidly and sometimes could not be observed at all because of the dead time of the NMR detection system. Such behavior of the FID was observed in many different single crystals in the given temperature range at 920 kHz. Tsubota and Tsuneto have shown by solving the nonlinear equations of motion numerically that the motion of the nuclear spin becomes chaotic when the tipping angle exceeds a critical value. Comparing their result with our experimental results, we concluded that some of the results of the rapid decay of the FID at large _p might be attributed to the onset of the chaotic motion. At 1840 kHz it is expected that the nonlinear effects in the equations of motion become less effective than that at 920 kHz. In fact, at this operating frequency the FIDs even at large _p and the tipping angle-dependent frequency shift could be observed. These frequency shifts were in rather good agreement with Namaizawa's theory provided an effective tipping angle was taken into account.     

Possibility of superconductivity with highT c in La-Sr-Nb-O system

We prepared La-Sr-Nb-O system samples both in bulk form and as a film, with sharp resistive transitions at temperatures of 228–323 K, depending on the annealing conditions. The sharp resistive transitions might be attributable to superconductivity. Magnetic ordering was observed over a narrow temperature range around 40 K for some of the samples.     

Chemical Modification of Phage-Displayed Helix-Loop-Helix Peptides to Construct Kinase-Focused Libraries

Conformationally constrained peptides hold promise as molecular tools in chemical biology and as a new modality in drug discovery. The construction and screening of a target-focused library could be a promising approach for the generation of de novo ligands or inhibitors against target proteins. Here, we have prepared a protein kinase-focused library by chemically modifying helix-loop-helix (HLH) peptides displayed on phage and subsequently tethered to adenosine. The library was screened against aurora kinase A (AurA). The selected HLH peptide Bip - 3 retained the α-helical structure and bound to AurA with a K_D value of 13.7 μM. Bip - 3 and the adenosine-tethered peptide Bip - 3 - Adc provided IC₅₀ values of 103 μM and 7.7 μM, respectively, suggesting that Bip - 3 - Adc bivalently inhibited AurA. In addition, the selectivity of Bip - 3 - Adc to several protein kinases was tested, and was highest against AurA. These results demonstrate that chemical modification can enable the construction of a kinase-focused library of phage-displayed HLH peptides.     

Study on triazine thiols. IV. Action of triazine thiols and their metal salts to peroxide

Decomposition of t-butylhydroperoxide was retarded by triazine thiols and their zinc salts, but accelerated by the copper salts of triazine thiols as well as sulfur compounds such as dithiocarbamates and mercaptobenzothiazolates. Triazine thiols and their zine salts are effective antioxidants for polyethylene crosslinked with peroxide and containing copper, and for protecting epichlorohydrin vulcanizates against attack by “sour” or hydroperoxide-containing gasoline.     

Studies on syntheses and permeabilities of special polymer membranes. XVI. Permeation and separation characteristics of aqueous polymer solutions for acrylonitrile-styrene copolymer membranes

The permeation and separation characteristics of aqueous polymer solutions using acrylonitrile-styrene copolymer membranes were investigated under various conditions. The membranes obtained from dimethyl sulfoxide solution of acrylonitrile-styrene copolymer have not a sufficient reproducibility and stability of permeation. These lacks were improved by adding ethylene glycol or glycerol to the casting solution and treating the membranes with pressure. The permeation and separation characteristics were influenced significantly by the additional amount of above additives, the heat treatment temperature, and the operating pressure. It was found that the concentration polarization of poly(vinyl alcohol) molecules onto the surface of the acrylonitrile-styrene copolymer membranes is smaller than that onto hydrophilic polymer membranes such as membranes of cellulose acetate, cellulose nitrate, and nylon 12, etc. Moreover, the acrylonitrile-styrene copolymer membranes show better performance for separation and concentrating of aqueous polymer solutions than hydrophilic membranes.