Effects of V content on hydrogen storage properties of V–Ti–Cr alloys with high desorption pressure

Hydrogen storage is one of the most important issues to realize hydrogen society especially for on-board usage. Recently, high-pressure metal hydride (MH) tank attracts many attentions due to its high volumetric hydrogen storage density and relatively easy heat management. To emphasize its merits, further improvements of properties of MH, such as capacity, hydrogen desorption capability at low temperature and durability, are required. In this paper, V–Ti–Cr alloys of V-rich compositions were investigated with perspective of increasing of hydrogen desorption pressure and durability. In both of 60at%V–Ti–Cr and 80at%V–Ti–Cr alloys, good relationship between hydrogen desorption pressure and Ti content was observed. In comparing with 60at%V–Ti–Cr alloys, 80at%V–Ti–Cr alloys showed good durability. It is quite notable that relationship between limitation line (upper substitution limit of Ti by Cr without degradation of hydrogen capacity) and desorption pressure for V–Ti–Cr ternary system with V-rich composition is clarified. And also, it is revealed that in the case of V–Ti–Cr ternary system, not only Ti/Cr ratio but also V content is important factor to obtain alloys with high hydrogen desorption pressure. 75at%V–5at%Ti–Cr as-cast sample showed good durability, hydrogen desorption capability at low temperature and relatively high effective hydrogen capacity simultaneously.     

Ion beam induced luminescence of polyethylene terephthalate foils under MeV H and He ion bombardment

The evolution of the ion beam induced luminescence (IBIL) of the polyethylene terephthalate (PET) foils was studied under the irradiation of H and He ions of MeV energy. The optical and chemical changes of the samples were also examined by photo-stimulated luminescence and optical absorption measurements after the irradiation. A prominent broad emission peak of IBIL appeared at around 380 nm, and its intensity monotonically decreased during the ion irradiation. The decay curves of the emission intensity were quantitatively explained as a function of the electronic energy deposition of the incident H and He ions. On the contrary, to the decrease of the main emission peak, a growth of new peaks was observed in the wavelengths between 500 and 600 nm.     

Sweep‐out flow of film condensation on vertical plates with horizontal grooves

We have investigated fluid flow characteristics of film‐wise condensation on vertical plates with horizontal periodic grooves. Condensate stays at the edge of the grooves due to the surface tension. The condensate starts to flow, however, when the balance between the surface tension and the condensate's own weight is broken. It is found that the condensate flows downward successively and periodically from the top part of the plate as a group. In addition, we have obtained the relation between the frequencies of the periodic flow and the degree of sub‐cooling for two different pitches of the grooves. © 2009 Wiley Periodicals, Inc. Heat Trans Asian Res; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.20249     

Molecular structures of gellan gum imaged with atomic force microscopy (AFM) in relation to the rheological behavior in aqueous systems in the presence of sodium chloride

Aqueous solutions of gellan gum with comparable molecular mass but with different acyl contents were investigated by atomic force microscopy and rheological measurements in the presence of sodium chloride (NaCl). Results obtained were discussed in relation to our previous report using potassium chloride (KCl) as an added salt. For a low-acyl sample, continuous fibrous network structures were identified microscopically as in the case of KCl. The network structures were more heterogeneous than those formed with KCl in terms of the height distribution of molecular assemblies. Rheological thermal hysteresis between sol–gel transitions was detected as in the case of KCl. The storage modulus (G′) of the gelled system was ca. 15% of the corresponding data with KCl at 20 °C. For a high-acyl sample, no continuous network structures were identified but branches with observable ends were identified as in the case of KCl. The hysteresis was less evident than the corresponding data with KCl and for the low-acyl sample with NaCl. Also, G′ values at 20 °C were ca. 30% and 20% of the corresponding data with KCl and for the low-acyl sample with NaCl, respectively. Continuousness and homogeneity of network structures related to the hysteresis and elasticity of the system, respectively.     

Parity induced edge-current saturation and current distribution in zigzag-edged graphene nano-ribbon devices

We show computationally that the current-voltage characteristics of the zigzag-edged graphene nanoribbon (ZGNR) with the even width exhibit remarkable current saturation behavior in spite of the absence of the bandgap. Mechanism of such current-saturation behavior can be understood to be originated from the symmetries of the wavefunctions corresponding to the edge states in ZGNR. We further demonstrate that the current-voltage characteristics of ZGNR can be drastically changed even by the presence of a single lattice vacancy, with the strong dependence on the position of the vacancy. The origin of such properties is intuitively understood by analyzing the transmission probabilities through such systems.     

A method to determine direct‐ and quadrature‐axis inductances of permanent magnet synchronous motors

The equivalent circuit constants of permanent magnet synchronous motors are needed in the calculation of operation characteristics, construction of a control system, etc. These constants can be computed from the data on structural form and materials. However, measurements are necessary to obtain highly precise values. Methods for measurement of the d‐ and q‐axis inductances can be roughly divided into rotational and standstill methods. The standstill methods have the advantage that they are easy to carry out. However, it is difficult to consider magnetic saturation and distortion of the change in the armature winding inductance. The accuracy of the standstill method can be improved if these effects can be readily taken into account. This paper describes a standstill method for measuring accurate d‐ and q‐axis synchronous inductances of permanent magnet synchronous motors. By utilizing the fact that the EMF interference terms in the motor voltage equation considering the distortion of the inductance change are equal to zero when the rotor is in a specific position, the proposed method determines the inductances considering both magnetic saturation and inductance distortion effects from simple off‐line standstill testing. In addition, this method is capable of taking cross‐magnetic saturation into account when used with the necessary testing equipment. The proposed method was implemented on a 0.4‐kW interior permanent magnet synchronous motor with concentrated stator winding. The validity of the proposed method was demonstrated by comparing the measured and calculated results of the no‐load and on‐load characteristics. © 2010 Wiley Periodicals, Inc. Electr Eng Jpn, 171(3): 41–50, 2010; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20969     

Cloning and characterization of a β-N-acetylglucosaminidase (BmFDL) from silkworm Bombyx mori

In insects, β-N-acetylglucosaminidase (GlcNAcase) participates in critical physiological processes such as fertilization, metamorphosis, and glycoconjugate degradation. Insects produce glycoproteins carrying paucimannosidic-type N-glycans, the terminal GlcNAc residue of which is cleaved by a GlcNAc-linkage specific GlcNAcase, also known as the fused lobes (FDL) protein. To obtain information on the structure of GlcNAcases and insight into their contribution to physiological processes, we cloned Bombyx mori FDL (BmFDL) from silkworm larvae. The full-length cDNA (1.9 kb) encoded a protein of 633 amino acids with 42% amino acid sequence identity to Drosophila melanogaster FDL (DmFDL). Recombinant BmFDL cleaved only β-1,2-linked GlcNAc residues from the α-1,3 branch of biantennary N-glycan. This substrate specificity was similar to that of DmFDL. Microsomal FDL activity was inhibited by anti-BmFDL antibodies. Taken together, our results suggest that BmFDL is a N-glycan-processing GlcNAcase in B. mori.     

Template-free hydrothermal synthesis of hollow hematite microspheres

Hollow hematite (α-Fe₂O₃) microspheres with an average diameter of 3-4 μm and a shell thickness of approximate 150 nm was synthesized by a simple hydrothermal route using FeCl₃·6H₂O solution and acetic acid without using any templates. The hollow microspheres were composed of α-Fe₂O₃ nanoparticles with the diameter range from 20 to 40 nm. The effects of reaction parameters such as reaction time, temperature, concentration of FeCl₃·6H₂O solution, and initial pH on the morphology of the final products were investigated. A possible formation mechanism of hollow α-Fe₂O₃ microspheres was also proposed, where the acetic acid played a role of etching in the formation of hollow structure.     

Involvement of cytochrome P450 in hydroxylation of propylbenzene by Fusarium moniliforme strain MS31

Fusarium moniliforme strain MS31 can oxidize propylbenzene to (R)-1-phenylpropanol with what may be a cytochrome P450. Hydroxylation of propylbenzene needed molecular oxygen, and NADPH as a coenzyme gave a higher yield than NADH. The hydroxylation proceeded further when FAD and FMN were added than in their absence, suggesting that the enzyme was a flavo-protein. Carbon monoxide inhibited the hydroxylation, as did other cytochrome P450 inhibitors such as SKF 525A and miconazole. These characteristics matched those of a microsomal cytochrome P450 monooxygenase system that contained NADPH-cytochrome P450 reductase.     

Updated data dissemination methods for updating old replicas in ad hoc networks

In this paper, we propose two updated data dissemination methods to not only reduce the number of accesses to old replicas, but also to improve the data accessibility in ad hoc networks where data items are updated regularly. In the first method, when a mobile host updates a data item, it disseminates the updated data item after the flooding of with invalidation reports. In the second method, two newly connected mobile hosts disseminate updated data items with each other after the flooding with invalidation reports.