Study of drive system for linear induction motor using magnetic energy recovery switch

This paper proposes a power supply suitable for driving linear induction motors. The power supply consists of a voltage source inverter (VSI) and a magnetic energy recovery switch (MERS). Circuit configuration and operation principles of the power supply are described. Power factor correction by MERS can increase the output power. Technical advantages of using MERS compared with increasing the rated voltage of VSI are discussed. Some experiments with a linear induction motor were conducted. The results confirm that MERS can reduce the capacity of the VSI or increase the output with the same VSI capacity. The number of devices and magnitude of losses are evaluated on a large‐scale drive system. A half‐bridge type of MERS is provided and discussed. The half‐bridge MERS mitigates disadvantages of using MERS. © 2009 Wiley Periodicals, Inc. Electr Eng Jpn, 169(4): 65–74, 2009; Published online in Wiley InterScience ( www.interscience. wiley.com ). DOI 10.1002/eej.20832     

Free primary alcohols in oils and waxes from germs,kernels and other components of nuts,seeds, fruits and cereals

The composition of free primary alcohols in oils and waxes obtained from the germ, kernel, seed coat, shell and skin (peel) of various nuts, seeds, fruits and cereals and from the chrysalis of silkworm was examined. These alcohols are usually present in small amounts, along with large quantities of hydrocarbons, esters and glycerides in oils and waxes. Thus, it is necessary to remove hydrocarbons, esters and glycerides to analyze the alcohols. We found that preparative reverse-phase thin-layer chromatography (TLC) was the best way to isolate alcohols from oils and waxes. Gas liquid chromatography (GLC) then detected hexacosanol, octacosanol and triacontanol in the oils and waxes. Octacosanol usually was the predominant alcohol. Relationships between the organs from nuts, seeds, fruits and cereals and the contents of octacosanol are suggested. For example, degermed kernels contained two times more octacosanol than the germ, and the skin coat and shell contained one-half and one-fortieth the octacosanol of the germ, respectively.     

Effect of Pore–Grain-Boundary Interactions on Discontinuous Grain Growth

Pore behavior as influenced by migration of an abnormal grain boundary was studied. The pore behavior during the discontinuous growth of hot-pressed spinel (MgAl₂O₄) — whether the pore can move attached to the grain boundary — is particularly governed by the pore size and the matrix grain size. These phenomena can be understood from the interaction between the pore and the abnormal grain boundary.     

Temperature Dependence of the Raman Spectrum in Lithium Oxide Single Crystal

Temperature dependence of the Raman spectrum of lithium oxide single crystal has been measured over a temperature range of 80 to 1073 K. The frequency shift and the line width of the Raman spectrum in lithium oxide were about 531 and 4.5 cm^-1 at 80 K, respectively. At 1073 K, the frequency shift and the line width attained the values of 464 and 112 cm^-1, respectively. The strong temperature dependence of the frequency shift and line width was compared with data from some crystals with a fluorite structure.     

EFFECT OF BAFFLE ON TRAY UNDER OSCILLATING CONDITION

Effect of baffle on a tray under oscillating conditions has been examined experimentally. To reduce the degree of liquid mixing and liquid channeling under oscillating conditions, it is necessary to install the baffles on tray.

Experiments were conducted with the air-water system, ft was found that the pressure drop change can be expressed as a sinusoidal function and the period coincides with tray oscillation. The degree of liquid mixing decreases when the baffles are installed on tray and it also decreases with the increase of liquid flow rate. The pressure drop increases with the installation of baffle on tray.

The suitable baffle number on tray is from 4 to 8 and in this region, the degree of liquid mixing reaches minimum and the liquid holdup takes a maximum value. @KEYWORDS: Tray, Oscillating, Liquid mixing, Baffle, Pressure drop, Liquid holdup.     

The characterization of low energy molecular hydrogen ion—induced defects in synthetic diamond by optical absorption

The results of optical absorption analysis of the synthetic diamonds(type Ib) which were implanted with 40 keV molecular hydrogen ions at doses of 10^15-10^17H/cm^2(at 100K),showed that the increase of optical density(OD) of modified layer(-140nm) in UV-VIS region was dependent upon the damage level caused by ion implantation process.The range of relative optical band gap(Er.opt) around 2.0eV suggested that an amorphous carbon network structure like a-C film,which probably contains some localized subtetrabedral-coordinated clusters embedded in the fourflod(sp^3) sites.was tentatively found in this layer,basing on the optical gap of carbon materials.The evolution of Er,opt with ion fluence indicated that no more hydrogenated carbon compositions were produced in as -implanted samples,while the increase of Er,opt with annealing temperature was very similar to that of hydrogen content dependence of Eopt in hydrogenately amorphous carbon(a-C:H):In addition the optical inhomogeneity of type Ib diamond has been revealed by a 2-dimension topograph in transmission mode at λ=430nm。     

The indirect hemagglutination test for onchocerciasis performed with blood collected on filter paper

In Guatemala, an indirect hemagglutination (IHA) test for onchocerciasis, performed with a crude saline extract of Onchocerca volvulus and blood samples taken on filter paper, showed a high level of sensitivity and specificity. IHA titers of blood samples from the ear lobe taken on filter paper and of sera obtained by venipuncture showed a high correlation.     

Optimal discrete-time control system with cost for observation

The problem of how to select the total number and the spacings of the observations optimally when a constant cost is incurred for each observation taken is discussed. Approximate expressions for the criterion function with a fixed number of observations are obtained and are used to determine the optimal total number of observations. For a class of multidimensional systems with a dominant eigenvalue, the problem is shown to reduce to that for scalar systems. Detailed discussion is then carded out for scalar systems including some sensitivity study.