A far-infrared spectroscopic study of low temperature soft phonon mode in Tris-Sarcosine Calcium Chloride(TSCC)

Temperature dependences of the soft phonon frequency and the damping constant in Tris-Sarcosine Calcium Chloride (TSCC) single crystal have been investigated between 5K and 100K by using a Fourier-transform far-infrared spectrometer. It has been observed that the soft phonon frequency decreases gradually and the damping constant increases as the transition temperature is approached from below The damping constant varies from 7cm^-1 a 90K to less than 0.5cm^-1 at 5K. It has been found that the damping constant is approximately proportional to temperature below about 60K.     

Influence of Metal Ions on the Order-Disorder Transition Temperature of the Ba-M-O (M: La, Y, In, or Ga) System

Preparation of BaLa₂O₄, B_a3,Y₄O₉, B_a,In₂O₅, and Ba₃Ga₂O₆ powders and their sintering were investigated in Ar or air. These sintered bodies with perovskite-related structure were synthesized by reaction sintering, using mixed powders in the atomic ratios of Ba/La = 1, Ba/Y = 0.75, Ba/In = 1, and Ba/Ga = 1.5. The order-disorder transition temperatures of the BaLa₂O₄, Ba₃Y₄O₉, Ba₂In₂O₅, and Ba₃Ga₂O₆ sintered bodies were 270°, 350°, 880°, and 123O^oC, respectively. It was found that the temperatures were influenced by the ionic radius of cations in B sites, and the transition temperatures decreased with increasing ionic radius.     

Improvement in Thermoelectric Characteristics of n-type Iron Disilicide by Local Composition Modification

High thermoelectric figure of merit semiconducting ceramics of n -type iron disilicide with modified local compositions have been developed. Sintering and annealing of the composite powder composed of iron disilicide and precipitated cobalt (II) hydroxide resulted in the dissolution of excess Co and oxygen into the iron disilicide phase. Excess Co segregated to the grain boundary region, while interstitially incorporated oxygen was distributed homogeneously in the microstructure. The maximum figure of merit achieved was 5.2 × 10⁻⁴/K at 673 K.     

Prostaglandin-like substances formed during autoxidation of methyl linolenate

Prostaglandin-like substances other than 3-(2-ethyl-5-hydroxy-3-oxo)-cyclopentanyl-2-propenal (compound I), which upon reacting with amino acids form reddish pigments, were purified, and their chemical structures were determined. Three red pigment-forming substances (RPS) in autoxidized methyl linolenate were purified successively by gel chromatography on Sephadex LH-20, column chromatography and thin layer chromatography on Silica Gel 60, and by high performance liquid chromatography on μ-Porasil. IR spectra of the RPS showed the absorption of an ester group (νC=O 1730 cm⁻¹ in CHCl₃) and of a longer branched chain (νC-H 2800–3100 cm⁻¹), in addition to the absorption bands observed in compound I. Electron impact mass spectra of the trimethylsilyl ethers obtained after reduction with NaBH₄ and NaBD₄ were analyzed in detail and compared with those of compound I. The structures of the RPS were identified as stereoisomeric methyl 8-[2-(2-formylvinyl)-3-hydroxy-5-oxo-cyclopentanyl]-octanoates derived from methyl 12-hydroperoxy-linolenate. Presented at the general meeting of the Japanese Society of Scientific Fisheries, held at Tohoku University, Sendai, Japan, October 1984.     

Preparation of Aluminum Nitride Powder from Aluminum Polynuclear Complexes

AIN powder was synthesized from aluminum polynuclear complexes. Basic aluminum chloride and basic aluminum lactate were used as the aluminum polynuclear complexes. These starting materials and glucose were dissolved in water and mixed homogeneously. AIN powder was obtained by calcining after drying and precalcining at 800°C under nitrogen gas flow. Then excess carbon was removed by firing in air. Nitridation in the system was investigated and compared with that in the alumina–carbon black system. It was found that in our reaction system nitridation began and proceeded at lower calcination temperatures above 1200°C than in the alumina–carbon black system. Using aluminum polynuclear complexes, AIN was synthesized through the nitridation of γ-alumina and produced in a very fine and sharp particle size distribution.     

Low-Temperature Synthesis of ZrC Powder by Cyclic Reaction of Mg in ZrO2–Mg–CH4

We investigated the conditions for low-temperature synthesis of ZrC fine powder from ZrO₂–Mg–CH₄. The synthesis utilizes a thermite-type reaction, with Mg as the reducing agent, and a reaction between Mg and CH₄ gas as a carbon source. The Mg/ZrO₂ molar ratio as well as the heating rate were varied. Because C can be continuously fed into the reaction group by the cyclic reaction of Mg through the formation and decomposition of Mg₂C₃ (2Mg + 3CH₄→ Mg₂C₃+ 6H₂→ 2Mg + 3C), a molar ratio of 2.2 for Mg/ZrO₂ was sufficient for the synthesis of single-phase ZrC. ZrC powders were synthesized under the following conditions: Mg/ZrO₂ molar ratio = 2.2, heating rate = 20°C/min, and temperature maintained at 750°C for 30 min. The amount of reaction heat produced in the reduction reaction of ZrO₂ by Mg depended on the Mg/ZrO₂ molar ratio, specifically, the amount of ZrO₂ contained. Moreover, the cyclic reaction of Mg-Mg₂C₃–Mg was influenced by the amount of reaction heat described above and by the heating rate. The ZrC fine powder showed little aggregation and high dispersibility.     

Hydrophobic effects on protein/nucleic acid interaction: enhancement of substrate binding by mutating tyrosine 45 to tryptophan in ribonuclease Tl

Hydrophobic effects on binding of ribonuclease Tl to guaninebases of several ribonucleotides have been proved by mutatinga hydrophobic residue at the recognition site and by measuringthe effect on binding. Mutation of a hydrophobic surface residueto a more hydrophobic residue (Tyr45 – Trp) enhances thebinding to ribonucleotides, including mononucleotide inhibitorand product, and a synthetic substrate-analog trinudeotide aswell as the binding to dinucleotide substrates and RNA. Enhancementson binding to non-substrate ribonucleotides by the mutationhave been observed with free energy changes ranging from –2.2 to – 3 .9 kJ/mol. These changes are in good agreementwith that of substrate binding, –2.3 kJ/mol, which iscalculated from Michaelis constants obtained from kinetic studies.It is shown, by comparing the observed and calculated changesin binding free energy with differences in the observed transferfree energy changes of the amino acid side chains from organicsolvents to water, that the enhancement observed on guaninebinding comes from the difference in the hydrophobic effectsof the side chains of tyrosine and tryptophan. Furthermore,a linear relationship between nucleolytic activities and hydrophobicityof the residues (Ala, Phe, Tyr, Trp) at position 45 is observed.The mutation could not change substantially the base specificityof RNase Tl, which exhibits a prime requirement for guaninebases of substrates.     

The oxidative coupling of methane on alkali- and alkaline earth-phosphate catalysts

The oxidative coupling of methane has been tested over alkali- and alkaline earth-phosphate catalysts at 700 and 775 °C with and without the introduction of a small quantity of tetrachloromethane (TCM) to the feedstream. In general, the conversion of methane was enhanced by the addition of TCM but the effect on selectivity was dependent on the catalyst being examined. The selectivity to C₂ and higher hydrocarbons and that to oxidation products have been shown to have a dependence on the cation radius/charge ratio.     

A low wall-loading DEMO reactor design with high priority for early and reliable realization of a tokamak fusion reactor over the cost performance

Based on scientific databases adopted for designing ITER plasmas and on the advancement of fusion nuclear technology from the recent R&D program, a low wall-loading DEMO fusion reactor has been designed, where high priority has been given to the early and reliable realization of a tokamak fusion plasma over the cost performance. Since the major radius of this DEMO reactor is chosen to be 10 m, plasma ignition is achievable with a low fusion power of 0.8 GW and an operation period of 4–5 hours is available only with inductive current drive. The low ignition power makes it possible to adopt a first wall with an austenitic stainless steel, for which significant databases and operating experience exists, due to its use in the presence of neutron irradiation in fission reactors. In step with development of advanced materials, a step-wise increase of the fusion power seems to be feasible and realistic, because this DEMO reactor has the potential to produce a fusion power of 5 GW.     

On the possible patterns of inputs for block sorting in the Burrows-Wheeler transformation

Block sorting in the Burrows-Wheeler transformation is to sort all of the n circular shifts of a string of length n lexicographically. We introduce a notion called the width of a sequence of n strings of length n and show that the values of widths are very different between the two types of sequences of strings; (1) a sequence of n randomly generated strings of length n, and (2) the sequence of n circular shifts of a randomly generated string of length n.