Comparison of Non-Equilibrium Green’s Function and Quantum-Corrected Monte Carlo Approaches in Nano MOS Simulation

In this paper, we present a comparative study between non-equilibrium Green’s function and quantum-corrected Monte Carlo approaches for an ultra-short channel MOSFET. As a result, we have found that the both models are equivalent in the simulation of quantum transport in a nano-scale MOSFET. We will also demonstrate that impurity scattering in the source region and plasmon scattering at the drain-end of the channel especially influence the drain current based on the quantum-corrected Monte Carlo approach.     

Performance of nanofiber/microfiber hybrid air filter prepared by wet paper processing

High-performance air filters composed of a hybrid structure of nanofiber/microfiber were fabricated using wet paper processing. Two types of nanofibers (NF) with average diameters of 180 and 234?nm were mixed with a suspension of microfibers (11.5 and 11.7?µm) in various mixing fractions. Then, the suspension was filtered to fabricate hybridized fiber sheets with a known nanofiber/microfiber composition. The effects of NF diameter and mixing fraction on the performance of the hybrid filters were experimentally investigated. With increasing NF fraction, both the particle collection efficiency and the pressure drop increased. The quality factor (Q_f) was used to evaluate the performance of the prepared filters. As predicted by the single fiber filtration theory, the experimentally obtained Q_f was almost independent of the mixing fraction of the NF. The collection efficiency and pressure drop of the hybrid filters could be controlled by the NF fraction at the same Q_f. Moreover, the inhomogeneity factor of fiber packing (δ) did not significantly affect Q_f over the δ range from 3 to 23 for our filters. This implies that the lower particle capturing efficiency due to heterogeneous packing could be compensated by a decrease in the pressure drop, resulting in the same Q_f value. Therefore, Q_f for particles smaller than 100?nm, which are in the diffusion-controlled regime, can be increased by reducing the NF diameter.

Copyright © 2019 American Association for Aerosol Research     

High-Temperature Phase Transition of Y4Al2O9

Reversible thermal phase transition was observed for Y₄Al₂O₉ at 1377°C with a hysteresis width of 78°C using differential scanning calorimetry. The enthalpy of the transition (Δ H ) was about 300 cal/mol. Powder X-ray diffraction peaks of the high-temperature phase, as well as the peaks of the low-temperature phase, were characterized with a monoclinic unit cell. Thermal hysteresis was also confirmed by the temperature dependence of the lattice parameter. The unit cell volume of the high-temperature phase was 0.5% smaller than that of the low-temperature phase at 1400°C.     

A method for generating a standard magnetic field in a circularwaveguide

In order to minimize the effect of electromagnetic interference and the surrounding conductive materials in the calibration of small loop antennas used above HF frequencies, a novel method for generating a standard magnetic field in a circular waveguide is proposed. A method for obtaining the average magnetic-field strength incident on a receiving loop by placing the radiating and receiving circular loop antennas within a circular waveguide operated below the cutoff frequency region is described. The differences between the theoretical and experimental values of the field strength are within 0.1 dB between 10 and 150 MHz for the radiating and receiving loops with radii of 1.0 cm and within 0.15 dB between 10 and 110 MHz for radiating and receiving loops with a radii of 1.5 cm     

Design considerations on surface acoustic wave resonators with significant internal reflection in interdigital transducers

This paper discusses, both qualitatively and quantitatively, the operation and the design principle of current surface acoustic wave (SAW) resonators in which the internal reflection within interdigital transducers (IDTs) is not negligible and lower capacitance ratio is necessary. For the purpose, the p-matrix expression is used with the help of the coupling-of-modes theory. The internal reflection causes: deformation of the IDT passband shape, frequency dependence of the effective SAW velocity within IDTs, and suppression of higher-order resonances. It is shown that these features can be effectively used to enhance performances of both one-port SAW resonators and two-port double-mode SAW (DMS) filters. In addition, under proper designs accounting for the internal reflection, most of all structural discontinuities can be removed, and is most preferable for the reduced scattering loss at the discontinuity. Design criteria also are presented for DMS filters of wide bandwidth, and it is demonstrated how device performances are improved by proper design accounting for the criteria.     

A matched filter approximation for SC/MMSE iterative equalizers

This letter proposes a new iterative ISI equalization algorithm that offers low computational complexity: order L² with channel memory length L. The proposed algorithm is an extension of Reynolds and Wang's SC/MMSE (soft canceler followed by MMSE filter) equalizer: approximations are used properly to reduce the computational complexity. It is shown that the approximations used in the proposed algorithm do not cause any serious performance degradations from the trellis-based iterative equalization algorithms     

Consolidation of Eutectic Powder of Al2O3–GdAlO3

A eutectic solid of Al₂O₃–GdAlO₃ was prepared by arc discharge and crushed to a eutectic powder of 3–125 μm. The powder was consolidated by the spark plasma system (SPS). The consolidated powder duplicated the eutectic structure: Al₂O₃ and GdAlO₃ were joined to each crystal. There were no flaws such as cracks or pores in the eutectic composite. The bending strength was half that of the eutectic composite prepared by unidirectional solidification.     

A laser probe based on a Sagnac interferometer with fast mechanical scan for RF surface and bulk acoustic wave devices

This paper describes the development of a phasesensitive laser probe with fast mechanical scan for RF surface and bulk acoustic wave (SAW/BAW) devices. The Sagnac interferometer composed of micro-optic elements was introduced for the selective detection of RF vertical motion associated with RF SAW/BAW propagation and vibration. A high-pass characteristic of the interferometer makes the measurement very insensitive to low-frequency vibration. This feature allows us to apply the fast mechanical scan to the interferometric measurement without badly sacrificing its SNR and spatial resolution. The system was applied to the visualization of a field pattern on the vibrating surface of an RF BAW resonator operating in the 2 GHz range. The field pattern was obtained in 17 min as a 2-D image (500 × 750 pixel with 0.4 μm resolution and SNR of 40 dB). The system was also applied to the characterization of an RF SAW resonator operating in the 1 GHz range, and the applicability of the system was demonstrated.     

Hydrodynamic interaction between two red blood cells in simple shear flow: its impact on the rheology of a semi-dilute suspension

Blood is a suspension of red blood cells (RBCs) and its rheology is important when discussing the physiology of the cardiovascular system. In this study, we performed a numerical investigation of the rheological properties of an RBC suspension from the dilute to semi-dilute regime. RBCs were modelled as a capsule with a two-dimensional hyperelastic membrane. Large deformation of the thin membrane was calculated by a finite element method. Due to the small size of the RBC, fluid motion around the RBC was assumed to follow Stokes flow and was solved by a boundary element method. In the dilute limit, cell–cell interactions were omitted and the bulk stress of the suspension was calculated by the stresslet generated on a single RBC. Interestingly, the effective shear viscosity of the dilute suspension decreased with increasing viscosity of the internal liquid. In the semi-dilute regime, cells can be considered as showing pairwise interactions. The effective shear viscosity of the semi-dilute suspension shows a quadratic increase with respect to the volume fraction. These findings are important for understanding the complex phenomena of blood rheology.     

Phosphorylation of 25-kDa synaptosome-associated protein. Possible involvement in protein kinase C-mediated regulation of neurotransmitter release

Protein kinase C-mediated phosphorylation of a 25-kDa synaptosome-associated protein (SNAP-25) was examined in living PC12 cells. Phorbol 12-myristate 13-acetate treatment enhanced high potassium-induced [3H]-norepinephrine release, and a 28-kDa protein recognized by an anti-SNAP-25 antibody was phosphorylated on Ser residues. The molecular size of the phosphorylated band decreased slightly following treatment with Clostridium botulinum type A neurotoxin, whereas the band disappeared after treatment with botulinum type E neurotoxin, indicating that the 28-kDa protein was SNAP-25. A phosphorylation is likely to occur at Ser187, as this is the only Ser residue located between the cleavage sites of botulinum type A and E neurotoxins. SNAP-25 of PC12 cells was phosphorylated by purified protein kinase C in vitro, and the amount of syntaxin co-immunoprecipitated with SNAP-25 was decreased by phosphorylation. These results suggest that the phosphorylation of SNAP-25 may be involved in protein kinase C-mediated regulation of catecholamine release from PC12 cells.