Detection of light-absorbing iron oxide particles using a modified single-particle soot photometer

Copyright © 2016 American Association for Aerosol Research     

Efficacy and Mechanisms of Communication Disruption of the Red Clover Casebearer Moth (Coleophora deauratella) with Complete and Partial Pheromone Formulations

The red clover casebearer, Coleophora deauratella Leinig and Zeller (Lepidoptera: Coleophoridae), is a major pest of red clover (Trifolium pratense L.) grown for seed in Canada and parts of Europe. Insecticides are ineffective against C. deauratella, and other control methods, such as pheromone-mediated mating disruption, need to be explored. The efficacy and mechanisms of communication disruption were evaluated in small-plot trials (0.25 ha) with reservoir-type rope dispensers loaded with either the complete pheromone blend [10:1 ratio of (Z)-7-dodecenyl acetate: (Z)-5-dodecenyl acetate] or the major component alone [(Z)-7-dodecenyl acetate]. Both formulations reduced catches of male C. deauratella in pheromone traps (>99.6 %). In pheromone-treated plots, more males were caught on yellow sticky cards near dispensers that released the complete pheromone blend, than on cards near dispensers releasing the major component. In the laboratory, after pre-exposure to either the complete blend or the major component for 1 h, male C. deauratella antennae became adapted, as measured by electroantennograms conducted 5 min. after treatment. Adaptation due to pre-exposure to either formulation resulted in a shift in the pheromone response threshold; antennae from pre-exposed moths responded more strongly to high pheromone dosages (5–50 μg) than did antennae from untreated control moths. Antennae from moths held in clean air for 24 h after pre-exposure recovered and responded similarly to pheromone as antennae from control moths. These results suggest that both formulations have the potential to disrupt pheromone communication in C. Deauratella, but that the disruption mechanisms of the two formulations likely differ.     

Code performance with improved two-group interfacial area concentration correlation for one-dimensional forced convective two-phase flow simulation

In gas–liquid two-phase flow simulation for reactor safety analysis, interfacial momentum transfer in two-fluid model plays an important role in predicting void fraction. Depending on flow conditions, a shape of the two-phase interface complicatedly evolves. One of the proposed approaches is to quantify the gas–liquid interface information using interfacial area transport equation. On the other hand, a more simplified and robust approach is to classify bubbles into two-groups based on their transport characteristics and utilize constitutive equations for interfacial area concentration for each group. In this paper, interfacial drag model based on the two-group interfacial area concentration correlations is implemented into system analysis code, and void fractions were calculated for the evaluation of numerical behaviors. The present analysis includes (1) comparison of one-group and two-group relative velocity models, (2) comparison with separate effect test database, (3) uncertainty evaluation of drag coefficient, (4) numerical stability assessment in flow regime transition, and (5) transient analysis for simulating the prototypic condition. Results showed that utilization of interfacial drag force term using constitutive equations of two-group interfacial area concentration yields satisfactory void fraction calculation results. The proposed solution technique is practical and advantageous in view of reducing the computational cost and simplifying the solution scheme.     

Cytoskeletal Protein 4.1G Is Essential for the Primary Ciliogenesis and Osteoblast Differentiation in Bone Formation

The primary cilium is a hair-like immotile organelle with specific membrane receptors, including the receptor of Hedgehog signaling, smoothened. The cilium organized in preosteoblasts promotes differentiation of the cells into osteoblasts (osteoblast differentiation) by mediating Hedgehog signaling to achieve bone formation. Notably, 4.1G is a plasma membrane-associated cytoskeletal protein that plays essential roles in various tissues, including the peripheral nervous system, testis, and retina. However, its function in the bone remains unexplored. In this study, we identified 4.1G expression in the bone. We found that, in the 4.1G-knockout mice, calcium deposits and primary cilium formation were suppressed in the trabecular bone, which is preosteoblast-rich region of the newborn tibia, indicating that 4.1G is a prerequisite for osteoblast differentiation by organizing the primary cilia in preosteoblasts. Next, we found that the primary cilium was elongated in the differentiating mouse preosteoblast cell line MC3T3-E1, whereas the knockdown of 4.1G suppressed its elongation. Moreover, 4.1G-knockdown suppressed the induction of the cilia-mediated Hedgehog signaling and subsequent osteoblast differentiation. These results demonstrate a new regulatory mechanism of 4.1G in bone formation that promotes the primary ciliogenesis in the differentiating preosteoblasts and induction of cilia-mediated osteoblast differentiation, resulting in bone formation at the newborn stage.     

Wave venation in downward gas-liquid two-phase flow (part I,time-spatial behavior chart of interface and analysis of main wave-vein)

Time-series information on both the cross-sectional mean liquid holdup along a tube axis and the gas-liquid phase distribution along a tube diameter was obtained by means of supermultiple cross-sectional mean liquid holdup probes (S-CHOP) and semi-supermultiple point-electrode probes (SS-PEP) for vertical downward gas-liquid two-phase flow. Typical time-spatial behavior charts of interface and gas-liquid interfacial profiles are presented. Close inspection of these results reveals that a huge wave and a disturbance wave appear in downward two-phase flow as well as upward flow. It was clarified that the huge wave flow region covers a wide range of superficial gas velocities. Wave velocity, wave width and maximum liquid holdup of individual waves were examined by wave-vein analysis. Histograms of these flow parameters were also studied. It was found that there exist distinct differences in wave width between the huge wave and the disturbance wave. © 1997 Scripta Technica, Inc. Heat Trans Jpn Res, 25(8): 499–510, 1996     

Characteristics of interfacial profiles in upward and downward gas-liquid two-phase plug flow

Gas-liquid interfacial profiles in plug flow for both upward and downward flows were obtained using semi-supermultiple point-electrode probes, comprising 67 sensing tips arranged on a tube diameter. Typical interfacial profiles are demonstrated for both flows. Close inspection of the profiles reveals that four zones exist in a pair of gas and liquid slugs for upward plug flow and a high slip velocity region in downward plug flow. The lengths of the swelling liquid front zone and the wake zone were determined. The length of the wake zone strongly depends on the relative velocity between the liquid film around the gas slug and the liquid phase in the liquid slug. Characteristic distributions of bubbles within liquid slugs were found, i.e., three types of radial distributions of void fraction, namely saddle-shaped, trapezoidal and bullet-shaped distributions, exist for upward flow. The two types for downward flow exclude the saddle-shaped distribution. © 1997 Scripta Technica, Inc. Heat Trans Jpn Res, 25 (8): 568–579, 1996     

Morphology‐dependent electrocatalytic activity of nanostructured Pt/C particles from hybrid aerosol–colloid process

An optimum nanostructure and pore size of catalyst supports is very important in achieving high catalytic performances. In this instance, we evaluated the effects of various carbon nanostructures on the catalytic performances of carbon‐supported platinum (Pt/C) electrocatalysts experimentally and numerically. The Pt/C catalysts were prepared using a hybrid method involving the preparation of dense, hollow, and porous nanostructured carbon particle via aerosol spray pyrolysis followed by microwave‐assisted Pt deposition. Electrochemical characterization of the catalysts showed that the porous Pt/C catalyst gave the best performance; its electrochemical surface area was much higher, more than twice than those of hollow or dense Pt/C. The effects of pore size on electrocatalysis were also studied. The results showed the importance of a balance between mesopores and macropores for effective catalysis with a high charge transfer rate. A fluid flow model showed that good oxygen transport contributed to the catalytic activity. © 2015 American Institute of Chemical Engineers AIChE J, 62: 440–450, 2016     

Fabrication of Translucent Magnesium Aluminum Spinel Ceramics

A precursor for magnesium aluminum spinel powder, composed of crystalline ammonium dawsonite hydrate (NH₄Al(OH)₂CO₃·H₂O) and hydrotalcite (Mg₆Al₂(CO₃)(OH)₁₆·4H₂O) phases, was synthesized via precipitation, using ammonium bicarbonate as the precipitant. The precursor was characterized by differential thermal analysis/thermogravimetry, X-ray diffractometry, and scanning electron microscopy. Reactive spinel powder, which could be densified to translucency under vacuum at 1750°C in 2 h without additives, was obtained by calcining the precursor at 1100°C for 2 h.     

Male pheromone of swift moth,Hepialus hecta L. (Lepidoptera: Hepialidae)

(R)-6-Ethyl-2-methyl-2,3-dihydro-4H-pyran-4-one, (1R,3S,5R)-3-ethyl-1,8-dimethyl-2,9-dioxabicyclo[3.3. 1]non-7-ene, and (1R,3S,5R)-3-ethyl-1,8-dimethyl-2,9-dioxabicyclo[3.3.1]non-7-en-6-one represent the main components in the male pheromone of the swift moth,Hepialus hecta. The amounts of the three components were 40, 5, and 5 g per male, respectively. Structure elucidation of the compounds was based on spectroscopic data as compared to synthetic reference samples. The absolute configurations were determined by gas chromatography on chiral stationary phases; optically active samples served as reference compounds. Electrophysiological and behavioral experiments with natural material and synthetic samples clearly showed the three heterocyclic compounds to act as pheromones. (E, E)--Farnesene represents the main component of the scent secretion of maleHepialus humuli.