Speciation of iodine in solid environmental samples by iodine K-edge XANES: application to soils and ferromanganese oxides

A method was developed for speciation of iodine in solid materials using X-ray absorption near-edge structure (XANES). This method was used to identify the iodine species (mainly inorganic iodine) in environmental samples. It was shown that the XANES spectra of iodide and iodate sorbed within solid materials can be simulated by the linear combination of the spectra of iodide and iodate ions in water. The distribution coefficient (Kd) between soil and water was obtained independently for iodide and iodate, based on iodine speciation both in the solid phase, by XANES, and in the aqueous phase, by HPLC-ICP-MS. It was found that the Kd of iodate is larger than that of iodide by a factor of more than six, showing the more soluble nature of iodide. It was suggested that iodate can form in soil even when iodide is injected into the soil-water system under conditions within the iodide-stable field of the Eh-pH diagram of iodine. This is caused by the much higher affinity of iodate for solid surfaces than iodide. In soil samples under various water saturation conditions, or various Eh conditions, the iodide fraction in water increases with decreasing Eh, which results in an increase in the dissolved total iodine fraction in soil water. The speciation method using XANES was also applied to iodine in a natural soil sample and marine ferromanganese oxides. It is suggested that iodine K-edge XANES is a promising tool for determining the iodide/iodate ratio in natural solid samples, which contributes to better understanding of the behavior of iodine at the Earth's surface.     

Sol–gel and rf sputtered AZO thin films: analysis of oxidation kinetics in harsh environment

Al-doped ZnO (AZO) thin film, which possess the advantages of low cost, low sheet resistance and high transmittance, are one of the most promising candidates to replace indium tin oxide films as the transparent electrode. However, oxidation causes a substantial increase in the sheet resistance of AZO film after exposing in ambient and especially, damp heat environment. In this work, we compare structural, optical, electrical properties and environmental stability between films prepared by two different methods: sol–gel and rf sputtering. Experimental results indicate that the properties of film can be affected by different deposition method. From the X-ray diffraction analysis, all films have hexagonal wurtzite crystal structure with different preferable orientation in two different methods. Optical transmittance spectra of the AZO films exhibited transparency higher than about 80 % within the visible wavelength region and the optical band gap (E_g) of these films was increased in sputtered film, probably due to the increase of carrier concentration. The better environmental stability was found in AZO film prepared by sputtering method. Improved surface morphology and enhancement of crystal orientation (110) was considered for this improvement.     

Carbon-supported growth of cross-linked platinum nanowires by surfactant templating and their elecrochemical characterization

Platinum/carbon (Pt/C) composite materials were prepared by the hydrazine reduction of H2PtCl6 confined to a mixed surfactant lytropic liquid crystal (LC)/C mixture with varying amounts of water. The reaction at relatively low water contents successfully yielded cross-linked Pt nanowires with wire-widths of 2-5 nm. The novel Pt nanostructure is believed to be from poorly hydrated hexagonal domains formed together with layered domains by the phase separation of the precursory LC mixture in the presence of carbon. Electrochemical measurements using cyclic volutammetry and membrane electrode assemblies revealed that the cross-linked nanowired Pt/C composite exhibits fairly high electrocatalytic activity for oxygen reduction reaction, as well as a high performance as the cathode material for polymer electrolyte fuel cells.     

Deep-ultraviolet Raman microspectroscopy: characterization of wide-gap semiconductors

We have developed a high-throughput deep-ultraviolet (DUV) Raman microspectrometer with excitation from a continuous wave (cw) laser operated at 244 nm that enables us to characterize thin surface layers of wide-gap semiconductors. This spectrometer system consists of a filter spectrometer for the rejection of stray light and a high-dispersion spectrograph combined with a liquid nitrogen cooled charge-coupled device (CCD) detector and extends the low-frequency limit of the observable spectral range down to 170 cm(-1). In the microscope we use a Cassegrain reflective objective for the collection of the scattered light and an off-axis mirror for introduction of the excitation laser light. DUV Raman spectroscopy has been applied for studying wide-gap semiconductors including SiC and AlGaN epitaxial films and shallow implanted layers of these materials. Raman spectra of various crystals have also been measured for examining the performance of this system. Resonance enhancement of Raman bands has been observed for several semiconductors, and the results are discussed.     

Measurement of the whole-body 137Cs in residents around the Chernobyl nuclear power plant

To understand the current situation of internal radiation exposure in the population around the Chernobyl Nuclear Power Plant (CNPP), we examined the 137Cs body burden in six residents of Belarus, Ukraine and Russia in 2002 and 2004 using the whole-body counter (WBC) at Nagasaki University (Japan). The data were compared with those of our previous study performed in 1993-1994 using the same method. In 2002 and 2004, peaks of 137Cs were detected in two residents from Gomel, which was heavily contaminated by the CNPP accident, one from Minsk (Belarus) and one from Kiev (Ukraine), but another resident from Minsk showed no 137Cs peaks. The results of the present study suggests that residents around the CNPP are still exposed to chronic 137Cs internal irradiation, probably due to the daily consumption of contaminated domestic foods, but the risk of any disease by the irradiation is quite low. Long-term follow-up of WBC around the CNPP is useful and may contribute to radiation safety regulation together with a reduction of unnecessary radiophobia for the residents.     

Requirement of CD28-CD86 co-stimulation in the interaction between antigen-primed T helper type 2 and B cells

The interaction between CD28 and its ligands, CD80 and CD86, is crucial for an optimal activation of antigen-specific T cells. However, the requirement of CD80 or CD86 co-stimulation in Th2 cell differentiation and activation is controversial. Freshly isolated murine CD4+ and CD8+ T cells were incubated with P815 transfectants expressing a similar level of either CD80 or CD86 in the presence of anti-CD3 mAb. Both CD80 and CD86 co-stimulated the proliferation of CD4+ and CD8+ T cells at comparable time-kinetics and magnitude, but CD86 alone was able to co-stimulate IL-4 and especially IL-10 production in CD4+ T cells. In typical Th2-dependent immune responses elicited by Nippostrongylus brasillensis infection, the anti-CD86 mAb treatment but not the anti-CD80 mAb treatment efficiently inhibited antigen-specific IgE and IgG1 production, which was accompanied with the reduced IL-4 production. Our results suggest that CD86 co-stimulation plays a dominant role not only in the primary activation of Th2 cells but also in the secondary interaction between antigen-primed Th2 cells and B cells.