Insulation characteristics and its evaluation method of N2 gas for nonstandard lightning impulse waveforms

Until recently, SF₆ gas has widely been used as the best insulating medium in substation equipment. However, SF₆ gas was specified to be a greenhouse gas at COP3 in 1997 because of its high global warming potential (GWP), and alternative insulation gases to SF₆ have been sought for a long time. Alternatives using the natural gases are considered to be suitable, but none of them show better properties for insulation as well as good environmental compatibility. Therefore, it is necessary to rationalize the equipment insulation level and reduce the test voltage of electric power apparatus to as low a level as possible. The actual lightning surge waveform (so‐called nonstandard lightning impulse waveform) occurring in the actual field is different from the standard lightning impulse waveform (1.2/50 μs). There are many cases in which the actual lightning surge waveform has a steep rise and large decay of overvoltage, and the insulation requirements are not as severe as those for the standard lightning impulse waveform. In this paper, we focused our research on N₂ gas as an SF₆ substitute and investigated the insulation characteristics of N₂ gas for a single‐frequency oscillatory waveform with various frequencies from 2.7 to 20.0 MHz and damping ratios. Based on the experimental results, it might be possible to reduce the test voltage of N₂ gas insulation by evaluating the crest value of the actual lightning surge waveform that has been converted into an equivalent standard lightning impulse waveform. © 2009 Wiley Periodicals, Inc. Electr Eng Jpn, 167(2): 10–20, 2009; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20754     

Moving pick‐up‐type contactless power transfer systems and their efficiency using series and parallel resonant capacitors

The equivalent circuit, the efficiency, and the important characteristics of moving pick‐up type contactless power transfer systems are described. If the primary series capacitor and the secondary parallel capacitors are chosen correctly and the winding resistances are ignored, the equivalent circuit of the transformer with these capacitors becomes the same as an ideal transformer at the resonant frequency. This simple approximation helps to understand the phenomena occurring with load changes. Because the circuit analysis becomes simple, the approximate value of the power transfer efficiency can be derived. This paper describes the determination of the capacitor values, the derivation of the equivalent circuit and the efficiency, and test results. © 2010 Wiley Periodicals, Inc. Electr Eng Jpn, 172(2): 47–54, 2010; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20970     

Effects of extraction solvents,cooking procedures and storage conditions on the contents of ergothioneine and phenolic compounds and antioxidative capacity of the cultivated mushroom Flammulina velutipes

Edible mushrooms contain considerable amounts of the potent natural antioxidant 2‐thiol‐l ‐histidine‐betaine (l ‐ergothioneine, ESH). The objective of this study was to evaluate the effects of extraction solvents, common cooking methods and storage conditions on the ESH content, total phenols (TPs) and antioxidant capacity of the edible mushroom Flammulina velutipes fruiting body and its hot water extract that had been stored at different temperatures. Regarding cooking procedures, boiling in water resulted in the highest losses of antioxidant activity of both ESH and TPs. Most of the losses of ESH and TPs were detected in the cooking water. The ESH contents in the raw mushroom fruiting bodies significantly decreased after 8 days of refrigerated storage under both dark and fluorescent lighting conditions. However, the TP content in the raw mushroom stored under fluorescent lighting significantly increased during 10 days of refrigeration. In contrast, the ESH and TP contents as well as DPPH radical scavenging ability of the fruiting bodies remained unchanged for up to 15 days of frozen storage at ?18 °C. The same behaviour was obtained with the mushroom extract packed in plastic tubes. The correlation between DPPH radical scavenging activity and ESH contents was higher than that for TP compounds.     

Quantum Effects on Hydrogen Isotopes Adsorption in Nanopores

We have investigated the applicability of simulations and theoretical techniques for exploring the selectivities of hydrogen isotopes. We have simulated the adsorption isotherms of H₂ in an idealized carbon slit pore at 77 K by using the grand canonical Monte Carlo simulations with the Feynman-Hibbs effective potential (FH-GCMC) and the rigorous path integral method (PI-GCMC), and we obtained good agreement between the isotherms from both simulations. This suggests that FH-GCMC, which uses the approximative Feynman-Hibbs treatment, is as useful as PI-GCMC for exploring H₂ adsorption at 77 K. Moreover, we show that the ideal adsorption solution theory (IAST) can predict the selectivity of D₂ over H₂ in the interstices of single-wall carbon nanotube (SWNT) bundles at 77 K (below 0.1 MPa) very well by comparing the obtained results with the mixture adsorption FH-GCMC simulations. This indicates that IAST is also applicable to the estimation of the selectivity of D₂ over H₂ at moderate pressures and at 77 K from experimental single-component adsorption isotherms. We also demonstrate that the FH-GCMC simulation can reproduce the experimental adsorption isotherms of H₂ and D₂ in aluminophosphate AlPO₄-5 at 77 K. Finally, we analyze the selectivity of D₂ over H₂ by IAST with the experimental single-component adsorption isotherms of H₂ and D₂ at 77 K for a variety of adsorbents: AlPO₄-5, activated carbon fibers (ACFs), HiPco SWNT, and SWNHs. The selectivities predicted by the experimental adsorption data based on the results from the FH-GCMC simulations are presented and discussed.     

Optical sensing of materials movements occurring at a plant surface with a probe beam

Optical sensing of materials movements across a plant surface with a probe beam is reported. It is based on monitoring of deflection of a probe beam passing through a vicinity of the plant surface. The deflection of the probe beam was caused by concentration gradients of chemical species involved in the materials moments in physiological activities of the plant. Typha angustifolia L. was used as a model plant. The beam deflection at different locations of both leaves and roots in respiration process were monitored and compared. It is found that deflection signals changed with time and locations. Experimental results showed that the beam deflection method could be used for noninvasive sensing and monitoring of materials movements across the plant surface.     

A novel ferromagnetic thermo-stent for plaque stabilization that self-regulates the temperature

The purpose of this study is to investigate the vascular wall with a thermally self-regulating, cylindrical stent made of a low Curie temperature ferromagnetic alloy. Physiologic saline was circulated in the silicone model vessel implanted with the stent. The stent-temperature remained nearly constant for variable saline flows, saline temperatures, and magnetic flux densities. Stent implants of this type in human blood vessels could potentially enable thermotherapy and temperature determination without catheterization.     

Electrochemical removal of p-nonylphenol from dilute solutions using a carbon fiber anode

p-Nonylphenol, which is widely used as raw material in industrial activities has been regarded as an environmental endocrine disrupter. In an effort to develop a new treatment method for p-nonylphenol, we initially investigated the electrochemical behavior of p-nonylphenol by voltammetric techniques. The electrochemical oxidation of p-nonylphenol led to the formation of electropolymerized film on the glassy carbon electrode surface. The fouling on the electrode surface by the electropolymerized film was evaluated by monitoring the electrode response of ferrocyanide ions as the redox marker. The electrochemical removal of p-nonylphenol based on the formation of the electropolymerized film on an anode surface was performed using a carbon fiber (CF) with a very large surface area. The high removal efficiency for p-nonylphenol was obtained by applying a potential at 0.7 V. The maximum surface coverage of electropolymerized p-nonylphenol on the CF was about 5 x 10(-9) mol/cm2. The presence of humic acid hardly inhibited the removal of p-nonylphenol. Furthermore, the application to the removal of phenol, o-chlorophenol, p-chlorophenol, 2,4-dichlorophenol, and 2,4,5-trichlorophenol was attempted by using this method.     

Application of nonlinear fitting and selection of the most fitted equation by AIC in stability test of pharmaceutical ingredients

We proposed a method for objectively selecting the most fitted rate equation among candidate rate equations based on chemical kinetics by both nonlinear regression analysis and Akaike's information criterion (AIC), to express the decrease of pharmaceutical ingredient as an appropriate equation. Pseudo-zero, first, and second-order rate equations were prepared as candidates beforehand, and AIC was introduced for selecting the most fitted rate equation among the candidates. We compared the proposed method to the Weibull method that expressed any decrease patterns as a single equation.

We quantified the contents of thiamine nitrate (VB1) and taurine after storage for one, three, and six months under 40°C-75% relative humidity by high-pressure liquid chromatography. Decrease patterns of each sample were most fitted to one of the candidate rate equations, that is, pseudo-zero, first, and second-order rate equations, respectively, and the degree of fit in the most fitted equation was superior to that of the Weibull method, except for the pseudo-first-order rate equation.

Moreover, we confirmed that the proposed method was considerably precise for estimating the stability of pharmaceuticals by comparing estimated residual rates and confidence intervals to experimental data.