Methane generation from Miocene lacustrine coals and organic-rich sedimentary rocks containing different types of organic matter

Ten selected samples with varying types and amounts of organic matter from two Miocene lacustrine basins in northwestern Turkey were analyzed by programmed-temperature open-system pyrolysis to determine methane generation potential and reaction kinetics. Open-system pyrolysis was performed at heating rates 0.1, 0.7 and 5.0 K/min, where generated gases were measured using an on-line gas chromatograph. Frequency factors and activation energy distributions of reaction kinetics for methane generation from the investigated lacustrine coals and sedimentary rocks indicated that type of kerogen controls the sequential order of methane generation. Methane from Type-III kerogen is generated at lower temperatures, which will be followed by methane from Type-II and Type-I kerogen. Methane generation potentials in the range 14-35 mg CH₄/g TOC correlates also with type of organic matter. For Type-III kerogen up to 28% of the total hydrocarbon generation potential belongs to methane. The respective value is only 2% for a Type-I kerogen.     

Synergistic Sex Pheromone Components of White-Spotted Tussock Moth, Orgyia thyellina

In 1996, the exotic white-spotted tussock moth (WSTM), Orgyia thyellina (Lepidoptera: Lymantriidae), was discovered in Auckland, New Zealand. Because establishment of WSTM would threaten New Zealand's orchard industry and international trade, eradication of WSTM with microbial insecticide was initiated. To monitor and complement eradication of WSTM by capture of male moths in pheromone-baited traps, pheromone components of female WSTM needed to be identified. Coupled gas chromatographic–electroantennographic detection analysis of pheromone gland extract revealed several compounds that elicited responses from male moth antennae. Mass spectra of the two most EAD-active compounds suggested, and comparative GC-MS of authentic standards confirmed, that they were (Z)-6-heneicosen-11-one (Z6–11-one) and (Z)-6-heneicosen-9-one, the latter termed here thyellinone. In field experiments in Japan, Z6–11-one plus thyellinone at a 100:5 ratio attracted WSTM males, whereas either ketone alone failed to attract a single male moth. Addition of further candidate pheromone components did not enhance attractiveness of the binary blend. Through the 1997–1998 summer, 45,000 commercial trap lures baited with 2000 g of Z6–11-one and 100 g of thyellinone were deployed in Auckland towards eradication of the residual WSTM population.Dedicated to my dear mother in honor of her 75th birthday     

(<Emphasis Type="Italic">Z,Z</Emphasis>)-6,9-Heneicosadien-11-One: Major Sex Pheromone Component Of Painted Apple Moth, <Emphasis Type="Italic">Teia anartoides</Emphasis>

(Z, Z)-6,9-Heneicosadien-11-one (Z6Z9-11-one-21Hy) was identified as the major sex pheromone component of the painted apple moth (PAM), Teia anartoides (Lepidoptera: Lymantriidae), on the basis of (1) comparative gas chromatographic-electroantennographic detection (GC-EAD) analyses, GC-mass spectrometry (MS), high-performance liquid chromatography (HPLC)-MS, and HPLC-UV/visible spectroscopy of pheromone gland extracts and authentic standards; (2) GC-EAD analyses of effluvia of calling females; and (3) wind tunnel and field trapping experiments with a synthetic standard. In field experiments in Australia, synthetic Z6Z9-11-one-21Hy as a single component attracted male moths. Wind tunnel experiments suggested that a 4-component blend consisting of Z6Z9-11-one-21Hy, (6Z,9R,10S)-cis-9,10-epoxy-heneicosene (Z6-9R10S-epo-21Hy), (E, E)-7,9-heneicosadien-6,11-dione (E7E9-6,11-dione-21Hy), and 6-hydroxy-(E, E)-7,9-heneicosadien-11-one (E7E9-6-ol-11-one-21Hy) (all present in pheromone gland extracts) might induce more males to orient toward, approach, and contact the source than did Z6Z9-11-one-21Hy as a single component. Additional experiments are needed to determine conclusively whether or not Z6-9R10S-epo-21Hy, E7E9-6,11-dione-21Hy, and E7E9-6-ol-11-one-21Hy might be minor sex pheromone components of PAM. Moreover, attractiveness of synthetic pheromone and virgin PAM females needs to be compared to determine whether synthetic pheromone could replace PAM females as trap baits in the program to monitor eradication of exotic PAM in New Zealand.     

Polymerization Catalysis in Liquid Propylene: High Activities and Molecular Weights in Propylene/CO Copolymerization Reactions

Summary: The dicationic [(dppp)Pd(NCCH₃)₂](BF₄)₂ catalyst (dppp = 1,3‐bis(diphenylphosphino)propane) was applied in a liquid monomer, two phase process for the CO/propene copolymerization reaction. For the first time it was possible to synthesize propene/CO copolymers with an activity up to 7 500 g/(mol · h) and molecular weights of 500 000 g/mol. Activities up to 40 000 g/(mol · h) could be obtained with the use of the unsymmetric catalyst [(CF₃‐dppp)Pd(NCCH₃)](BF₄)₂ (CF₃‐dppp = 1‐diphenylphosphino‐3‐bis[3,5‐di(trifluormethyl)phenyl]phosphinopropane) in homogeneous liquid propene solution.

Granules found after copolymerization.     

Surface-state electrons on a hydrogen film. 1. Annealing of the film

We have investigated the surface of thin films (thickness 2 µm) of solid H₂ between 1.5 and 4.2 K by measuring the ac conductivity of surface-state electrons (SSE). The films were prepared on a glass substrate by quench condensation at 1.5 K and were therefore initially strongly disordered. In fact the surface of the virgin films before any heat treatment was so rough that no current due to SSE could be observed. Annealing the films decreased the surface roughness and gave rise to a thermal-activation-type temperature dependence of the SSE conductivity. By proper heat treatment up to 8 K the activation energy could be reduced to 10k _B.On leave from the Hyogo University of Teacher Education, Shimokume 942-1, Yashiro, 673-14, Japan.     

A New Research Infrastructure for Investigating Flow Hydraulics and Process Equipment at Critical Fluid Properties

An optimized equipment design for natural gas processing and liquefaction plants becomes increasingly difficult with changing process conditions: Particularly low values of surface tension create rising challenges on the design of phase separators and column internals. The TERESA test rig at HZDR was designed to allow the investigation of multiphase thermohydraulics and phase separator performance under critical fluid properties in industrial dimensions. A versatile pipe test section is available in DN200 and equipment internals may be tested in a sectional DN300/DN500 test separator. The applied test fluid shows a high vapor-liquid density difference between 1470 and 940 kg m⁻³, viscosity as low as 0.12 mm²s⁻¹, and surface tension down to 1.3 mN m⁻¹. Volumetric liquid and vapor flow rates may be varied up to 9 and 530 m³h⁻¹ in the test rig, respectively.     

A Hybrid Color Quantization Algorithm Incorporating a Human Visual Perception Model

Color quantization is a common image processing technique where full color images are to be displayed using a limited palette of colors. The choice of a good palette is crucial as it directly determines the quality of the resulting image. Standard quantization approaches aim to minimize the mean squared error (MSE) between the original and the quantized image, which does not correspond well to how humans perceive the image differences. In this article, we introduce a color quantization algorithm that hybridizes an optimization scheme based with an image quality metric that mimics the human visual system. Rather than minimizing the MSE, its objective is to maximize the image fidelity as evaluated by S‐CIELAB, an image quality metric that has been shown to work well for various image processing tasks. In particular, we employ a variant of simulated annealing with the objective function describing the S‐CIELAB image quality of the quantized image compared with its original. Experimental results based on a set of standard images demonstrate the superiority of our approach in terms of achieved image quality.     

Online Bi-Objective Scheduling for IaaS Clouds Ensuring Quality of Service

This paper focuses on a bi-objective experimental evaluation of online scheduling in the Infrastructure as a Service model of Cloud computing regarding income and power consumption objectives. In this model, customers have the choice between different service levels. Each service level is associated with a price per unit of job execution time, and a slack factor that determines the maximal time span to deliver the requested amount of computing resources. The system, via the scheduling algorithms, is responsible to guarantee the corresponding quality of service for all accepted jobs. Since we do not consider any optimistic scheduling approach, a job cannot be accepted if its service guarantee will not be observed assuming that all accepted jobs receive the requested resources. In this article, we analyze several scheduling algorithms with different cloud configurations and workloads, considering the maximization of the provider income and minimization of the total power consumption of a schedule. We distinguish algorithms depending on the type and amount of information they require: knowledge free, energy-aware, and speed-aware. First, to provide effective guidance in choosing a good strategy, we present a joint analysis of two conflicting goals based on the degradation in performance. The study addresses the behavior of each strategy under each metric. We assess the performance of different scheduling algorithms by determining a set of non-dominated solutions that approximate the Pareto optimal set. We use a set coverage metric to compare the scheduling algorithms in terms of Pareto dominance. We claim that a rather simple scheduling approach can provide the best energy and income trade-offs. This scheduling algorithm performs well in different scenarios with a variety of workloads and cloud configurations.     

Are My Neighbours Ageing Yet? Local Dimensions of Demographic Change in German Cities

Among the highly developed countries, demographic ageing is particularly advanced in Germany. Accentuated by migration, there is great regional variation in the progress of demographic change. Within urban areas, residential neighbourhoods differ considerably in their demographic composition and perspectives. Based on municipal data, this paper examines regional variability in the diversity and pace of neighbourhood-level ageing. Focusing on the Rhine-Ruhr conurbation in North Rhine-Westphalia, the analysis outlines at what pace ageing proceeds in a variety of neighbourhoods, which attract no constant influx of working-age migrants. After decades of suburbanisation, in the period from 1998 to 2008 regional migration concentrated on the central districts of large cities. More profoundly in the most prosperous cities growing in population than in other cities, childless working-age adults separate from other age groups and family types in selected central city quarters. The findings suggest that spatial differentials in ageing are likely to affect future location decisions and, thereby, regional and local prosperity.     

Shaping stable periodic motions of inertia wheel pendulum: theory and experiment

We consider an underactuated two‐link robot called the inertia wheel pendulum. The system consists of a free planar rotational pendulum and a symmetric disk attached to its end, which is directly controlled by a DC‐motor. The goal is to create stable oscillations of the pendulum, which is not directly actuated. We exploit a recently proposed feedback‐control design strategy based on motion planning via virtual holonomic constraints. This strategy is shown to be useful for design of regulators for achieving orbitally exponentially stable oscillatory motions. The main contribution is a step‐by‐step procedure on how to achieve oscillations with pre‐specified amplitude from a given range and an arbitrary independently chosen period. The theoretical results are verified via experiments with a real hardware setup. Copyright © 2009 John Wiley and Sons Asia Pte Ltd and Chinese Automatic Control Society