Evidence for biotic control of Australian reservoir phytoplankton communities and the potential for applied biomanipulation

Although some concerns have been expressed with respect to the applicability of biomanipulation to Australian reservoirs and other inland waters, no major obstacles were found in this review. The previous doubts stimulated research, which has provided evidence for unexpected mechanisms of food web interactions, such as positive effects of small copepods on planktonic algae, higher than usual grazing potential of cladoceran communities, and direct positive effects of planktivores on phytoplankton. Further research into zooplankton-cyanobacteria interactions should indicate how widespread is the previously reported ability of some southern hemisphere crustaceans to benefit at a population level from feeding on cyanobacteria. Quantitative fisheries acoustics, which has not been widely used in biomanipulation trials before, is a promising new tool in the assessment of the biomass of planktivorous fish in the pelagic zone of reservoirs.     

Comment on “The minimization of the back scattering of acylinder by central loading”

K.M. Chen and V. Liepa (IEEE Trans. Antennas Propag., p.576-82, September 1964) described the broadside backscatter of a thin dipole. The model is summarized by various. These work very well at all frequencies specified by those authors, except for one-physical resonance. This is the wavelength at which the antenna's total length is half a wavelength. The present author develops an alternate set of equations which are valid at resonance     

为手持产品选择电源管理方案

便携式设备,如PDA、智能电话和数码相机等在使用电池供电时具有特殊的电源管理要求,效率指标固然重要,而来自尺寸和价格方面的压力也要通过不同的设计加以平衡,这些实际要求都不同于笔记本电脑等电池供电设备的设计.除了对尺寸和重量的限制外,手持产品还需解决散热问题.这些产品中不可能安装风扇,也不可能容忍较高的温度,如果这些问题得不到解决,对元件尺寸的苛刻要求很难使其达到适当的效率,同时,小型电池需要严格的电源管理,上述因素都是当电源集成在系统内部时所要考虑的.     

Parameters affecting the frequencies of transformation and co-transformation with synthetic oligonucleotides in yeast.

Factors influencing the direct transformation of the yeast Saccharomyces cerevisiae with synthetic oligonucleotides were investigated by selecting for cyc1 transformants that contained at least partially functional iso-1-cytochrome c. Approximately 3 x 10(4) transformants, constituting 0.1% of the cells, were obtained by using 1 mg of oligonucleotide in the reaction mixture. Carrier, such as heterogeneous oligonucleotides, enhanced transformation frequencies. Transformation frequencies were dramatically reduced if the oligonucleotides had a large number of mismatches or had terminally located mismatches. Transformation with oligonucleotides, but not with linearized double-strand plasmid, was efficient in a rad52- strain, suggesting that the pathway for transformation with oligonucleotides is different from that with linearized double-strand plasmid. We describe a procedure of co-transformation with two oligonucleotides, one correcting the cyc1 defect of the target allele in the host strain, and the other producing a desired amino acid alteration elsewhere in the iso-1-cytochrome c molecule; approximately 20% of the transformants obtained by co-transformation contained these desired second alterations.     

Effect of Dilution and Porosity on Self-Propagating High-Temperature Synthesis of Silicon Nitride

Self-propagating high-temperature synthesis is a very easy and low-cost method to synthesize Si₃N₄. The nitriding of silicon powder takes place in a self-sustained regime under high pressures of nitrogen with dilution of silicon by Si₃N₄. In this work effects of dilution and green-mixture porosity on combustion velocity and phase content of reaction products are studied. Results are compared with previous work of other authors and different behaviors are found. An explanation of these behaviors is given.     

Phase Composition of Oxide Scales during Reheating in Hot Rolling of Low Carbon Steel

Low carbon steel was oxidized over the temperature range 1000‐1250°C in O₂‐CO₂‐H₂O‐N₂, O₂‐H₂O‐N₂, and O₂‐CO₂‐N₂ gas mixtures. Oxidation times were 12‐120 min. and the scales were 50‐2000 μm thick. The variations of these parameters were chosen to elucidate the phase composition of oxide scales under conditions similar to those of reheating furnaces in hot strip mills, using either thin slab casting or conventional casting and rolling technology. Two types of scales have been observed which are influenced by the furnace atmosphere, oxidation time, and temperature. The first type is a crystalline scale with an irregular outer surface, composed mostly of wustite (FeO), and a negligible amount of magnetite (Fe₃O₄). The second type is the classical three‐layer scale, composed of wustite (FeO), magnetite (Fe₃O₄), and hematite (Fe₂O₃). In general, the experiments showed that an increase in oxidation time decreased the percentage of wustite while the percentages of magnetite and hematite increased. A rise in oxygen concentration in the gas mixture increased the percentages of magnetite and hematite, confirming earlier experimental findings. In water vapour‐free atmospheres O₂‐CO₂‐N₂, the oxide scales had a low percentage of wustite, and high percentage of magnetite and hematite. Carbon dioxide showed a small influence at 1100°C, and a negligible one at 1250°C.     

Effects of Nitrogen Deficiency on the Kinetics and Mechanism of Electrolytic ZrN x Oxidation

Use has been made of potentiodynamic polarization curves, XRD, and scanning electron microscopy (SEM) in the electrolytic oxidation in 3% NaCl solution for specimens of nitrogen-deficient zirconium nitride (ZrN_0.67, ZrN_0.77, ZrN_0.87, and ZrN_0.97), as well as pure zirconium. In all cases, the anodic polarization curves have several stages which characterize during oxidation both active dissolution of ZrN _x and Zr in the electrolyte as well as the formation of surface layers of ZrOCl₂, ZrN _x O _y , and α‐ZrO₂ of monoclinic form. The corrosion resistance of single-phase ZrN _x specimens in 3% NaCl solution decreases in the sequence ZrN_0.97 → ZrN_0.87 → ZrN_0.77, and the initial stages of interaction between the specimen surface and the electrolyte largely determine the subsequent behavior of specimens. It is found that ZrN _x containing a large number of nitrogen atom vacancies, in particular ZrN_0.77, is closer in corrosion behavior to metallic zirconium than it is to stoichiometric ZrN (the reduction in the corrosion resistance is undoubtedly due to the reduction in the ionic-covalent components of the bonds in ZrN _x ).     

Consideration of measurement of electrostriction in quartz usingBragg reflection of X-rays

Calculation shows that the linear piezoelectric effect should be readily demonstrated in X-cut quartz by Bragg reflection of X-rays, equipment for which is available in every crystal finishing room. Electrostriction should also be observable and measurable in X-cut, Y-cut and Z-cut quartz, and in other cuts having their major surfaces parallel to X-ray diffracting planes of the crystal. Mechanical compression of the quartz due to the charge on the electrodes must be considered     

Neocortical ectopias in BXSB mice: effects upon reference and working memory systems

BXSB mice have an approximately 40-60% incidence of neocortical ectopias in layer I of the prefrontal/motor cortex. Prior studies have found major behavioral differences between those with ectopias and their non-ectopic littermates. Some of these findings indicate that the two groups differ with respect to spatial reference and working memory. The purpose of this study was to measure reference and working memory in the same animals to test the hypothesis that the ectopics would have better reference memory but less effective working memory. The Lashley III maze has cul-de-sacs which must be eliminated, and T-choices where the animal has to decide whether to go left or right. Ectopic and non-ectopic mice were equally able to learn the maze and did not differ on cul-entry or T-choice errors. Then the maze was inverted and the animals were retested. Turning the maze upside down did not change the relative status of the blind alleys. Therefore, the reference memory knowledge from the prior week's training could be used to avoid entering the culs. However, inverting the maze caused a left-right mirror image reversal of the T-choices. Therefore, prior reference memory information would interfere with learning the new path through the maze, whereas working memory would enable the mouse to eliminate T-choice errors. Ectopic mice made less cul-entry errors and more T-choice errors than their non-ectopic littermates, as predicted.     

Oxidation of methane in a wide range of pressures and effect of inert gases

The analysis of methane oxidation in a wide range of pressures (0.05–10 atm) demonstrates that the efficiency of CH₃ radicals recombination is of great importance for high selectivity of C₂ hydrocarbons formation. The relative efficiency of different “colliders” assisting the stabilization of exited C₂H*₆ molecules increases in the series: solid surface> Ar> He. The increase of the overall reaction rate upon increasing pressure of the inert gases in the case of catalysts having a higher surface area and more developed pore structure is likely due to the contribution of the surface-induced chain reaction in the volume of pores.