Large magnetic-field-induced strains in rare earth polycrystalline Ni-Mn-Ga

The magnetic-field-induced strains (MFIS) of polycrystalline Ni50Mn29Ga21 alloys containing Tb were studied. A large MFIS of-1.10% was obtained under compressive prestress conditions. The addition of Tb can fine the crystal grains, enhance the bending strength obviously, and make MFIS increase further, indicating that a moderate amount of Tb does not hinder twin boundary motion and it conversely makes the material more practical.     

氩弧焊未熔合缺陷的定位分析

氩弧焊在压力容器制造行业运用越来越广泛.正确检出氩弧焊焊接缺陷的位置,不仅能保证设备的安全运行,而且可以节约人力、材料、能源和缩短工期.当采用射线方法检测氩弧焊焊缝质量时,可通过X光底片判断缺陷的埋藏深度.……     

AN APPROACH TO THE ACTIVATION PROCESS OF LaNi_5

本文研究了LaNi_5在不同温度和压力下的活化过程。结果表明,LaNi_5的活化可分为三个阶段,即孕育期;吸氢速度随时间增加而增加的第一阶段和吸氢速度随时间增加而减少的第二阶段。讨论了每一阶段的特征,并给出了吸氢速度的近似表达式。     

机械零件刚度的模糊可靠性设计

介绍了机械零件刚度模糊可靠性设计变形分布参数和刚度隶属函数的确定,导出了零件刚度模糊可靠度的计算公式,并通过机床主轴模糊可靠性设计实例说明机械零件模糊可靠性的计算方法.     

含Cl^-溶液中SO4^2-对316不锈钢临界点蚀温度的影响

采用外加恒电位下腐蚀电流-温度扫描方法研究了在0．5％Cl^-溶液中，SO4^2-浓度对316不锈钢点腐蚀行为的影响．结果表明，随着SO4^2-浓度的增加，钝化电流增加，开路电位降低．当SO4^2-浓度低于0．42％时，316不锈钢的临界点蚀温度比不存在SO4^2-时的临界点蚀温度低；当SO4^2-浓度大于0．42％时，临界点蚀温度比不存在SO4^2-时的临界点蚀温度高．从离子竞争吸附的角度进行分析，对SO4^2-加速与抑制点蚀两种作用规律的形成原因进行了解释．     

Influence of electroplating conditions on magnetic properties of Fe-36wt.% Ni alloy film

A Fe-Ni soft magnetic film was prepared in sulphate solution by electroplating. The influences of the molar ratio of n [Fe2+ ]/ n [Ni2+ ], current density, bath temperature, pH and L-ascorbic acid concentration on magnetic properties of Fe-Ni alloy film were investigated. The results show that the saturated flux density(BS) of the film increases initially and decreases after it reaches the specific value with the increase of n [Fe2+ ]/ n [Ni2+ ] molar ratio, current density, bath temperature and pH. However, the relationship between L-ascorbic acid concentration and B S keeps linear. It is observed that the coercive force( Hc) is enhanced with the increase of n [Fe2+ ]/ n [Ni2+ ] molar ratio, current density and pH. By comparison, when the bath temperature increases, Hc always decreases. With the increase of L-ascorbic acid concentration, the coercive force increases initially and then decreases.     

Effect of grain size on high-temperature oxidation behavior of Cu-80Ni alloy

1　INTRODUCTIONTheoxidationofunalloyedcopperandnickelhasalreadybeenstudiedindetail.Whilethehigh tem peratureoxidationofCu Nialloys ,alsostudiedanumberoftimestodate[13] ,isanexampleofarela tivelysimpleclassofscalingofbinaryalloysbyasin gleoxidant,becausethemetalsformacontinuousse riesofsolidsolutions ,whiletheiroxides ,CuO ,Cu2 OandNiO ,exhibitsmallmutualsolubilitiesandshowsignificantdifferencesinthethermodynamicstabilityandparabolicgrowthrates .Thus ,copper richalloysformexternalscales…     

Effect of surface modification of metal hydride electrode on performance of MH/Ni batteries

A novel method was applied to the surface modification of the metal hydride(MH)electrode of MH/Ni batteries.Both sides of the electrode were plated with a thin silver film about 0.1μm thick using vacuum evaporation plating technology,and the effect of the electrode on the performance of MH/Ni batteries was examined.It is found that the surface modification can enhance the electrode conductivity and decrease the battery ohimic resistance.After surface modification,the discharge capacity at 5C(7.5A)is increased by 212 mA.h and the discharge voltage is increased by 0.11 V,the resistance of the batteries is also decreased by 32%.The batteries with modified electrode exhibit satisfactory durability.The remaining capacity of the modified batteries is 89%of the initial capacity even after 500 cycles.The inner pressure of the batteries during overcharging is lowered and the charging efficiency of the batteries is improved.     

ZL114铝合金激光--龟弧的复合焊接

设计了一种激光-电弧复合热源焊接ZL114合金的新工艺，并对焊后的试件进行了X光检测、抗拉强度和全相组织等实验。结果表明，该种新工艺对铝合全有良好的适应性和可行性，是焊接领域的一个趋势。     

高线粗中轧机"浮动"检测结构设计及故障排除

为克服轧制中因机架锁紧功能降低而产生的机架沿轨座轴向移动的"浮动"现象,对其产生原因进行了分析,并通过改进锁紧装置结构及相关部件,使"浮动"故障得到预防和有效控制并及时排除。