Connecting the second exhaust-heat boiler to the operating first one under the conditions of flow circuits of combined-cycle plants with two gas-turbine units and one steam turbine

Problems arising with connecting the second exhaust-heat boiler to the first exhaust-heat boiler under load in the case of flow circuits of combined-cycle plants of type PGU-450 are considered. Similar problems exist for two-boiler single-turbine units of type PGU-325 and for two-boiler single-turbine units of traditional steampower plants with an output of 200–300 MW upon connection of the second furnace of a two-furnace boiler to the operating first furnace. Analysis of the temperature-induced stressed state and of the cyclic strength of thick-walled elements of the steam-water conduit of PGU-450 and of two-furnace boilers of two-boiler single-turbine units with an output of 200–300 MW (the check valve, the inlet header of the water economizer) is used for determining the steam temperature differences in the high-pressure conduits to the steam turbine and the order of connection of the second exhaust-heat boiler to the operating fist one. Modes of enabling a two-boiler single-turbine unit of a combined-cycle plant, which are most “rigid” from the standpoint of thermal strength, are determined. __________ Translated from élektricheskie Stantsii, No. 2, February 2006, pp. 11–17.     

Hydrogen degradation of steels in gas mains after long periods of operation

We study the degradation of the mechanical and corrosion properties of 17G1S steel in gas mains as a result of operation for 28–40 yr. We reveal the simultaneous decrease in its strength and hardness, on the one hand, and impact toughness and crack resistance, on the other hand. The indicated parameters prove to be most sensitive to the in-service degradation of the metal. The degradation of steel leads to the increase in the strain-hardening coefficient and the appearance of the yield plateau in the tensile stress-strain diagram and causes the appearance of sensitivity to hydrogen embrittlement increasing in the process of operation. We analyze the role of absorbed hydrogen affecting the mechanism of strain aging and responsible for the appearance of defects. It is shown that the polarization resistance can be used not only for monitoring of the corrosion state of gas pipelines but also for the prediction of changes in their mechanical properties in the process of operation. __________ Translated from Fizyko-Khimichna Mekhanika Materialiv, Vol. 43, No. 5, pp. 97–104, September–October, 2007.     

One-dimensional diffuser based on a thick layer of dichromated gelatin

A new diffuser capable of scattering light in one direction (one-dimensional diffuser) has been developed and experimentally tested. The diffuser is formed in a thick layer of dichromated gelatin. The scattering indicatrices of the diffuser measured in two mutually perpendicular directions are presented. It is demonstrated that the indicatrix width in one direction is significantly greater than that in the perpendicular direc-tion. However, no zero-order diffraction has been observed. The proposed one-dimensional diffuser exhibits close scattering indicatrices for reading at a wavelength of 0.44 and 0.63 μm.     

On Convergence of a Stochastic Quasigradient Algorithm of Quantile Optimization

For the nonantagonistic two-person game which is equivalent to the problem of minimizing the quantile function, a modification of the stochastic quasigradient algorithm to seek the Nash point was proposed. The Nash point defines both the optimal strategy minimizing the quantile function and the minimum value of this function. Convergence of the algorithm with the probability 1 was proved. The question of choosing the starting point was discussed.     

A Modified Variational-Gradient Method for Quasilinear Equations

A modified variational-gradient method is proposed and substantiated for quasilinear operator equations in a Hilbert space.     

Fabrication of Strain-Relaxed Si<Subscript>1 − <Emphasis Type="Italic">x</Emphasis></Subscript>Ge<Subscript>x</Subscript>/Si(001) Buffer Layers of Low Surface Roughness

The results are presented of the fabrication of strain-relaxed graded Si_{1 − x} Ge_x/Si(001) buffer layers with a maximum Ge fraction of about 0.25 that have a low density of threading dislocations (<10⁶ cm⁻²) and low surface roughness. The buffer layers are grown by atmospheric-pressure hydride CVD. It is found that chemical mechanical polishing can reduce their surface roughness to a level comparable with that of the original Si(001) substrates. It is shown that the polished buffer layers can serve as substrates for MBE-grown SiGe/Si heterostructures.__________Translated from Mikroelektronika, Vol. 34, No. 4, 2005, pp. 243–250.Original Russian Text Copyright © 2005 by Vostokov, Drozdov, Krasil’nik, Kuznetsov, Novikov, Perevoshchikov, Shaleev.     

催化裂化汽油脱硫助剂TS-01的工业试验

中国石油化工股份有限公司九江分公司在I套催化裂化装置进行了TS—0l催化裂化汽油脱硫双功能助剂的工业应用。结果表明：TS—0l剂对催化裂化汽油有较好的脱硫效果。当TS—0l剂注入原料中的量为70μg／g时，对催化裂化汽油的硫脱除率约为20％；注入量为120μg／g时，硫脱除率可达到25％-30％。汽油中脱除的硫主要以硫化氢形态转移至于气、液化气中。TS—01剂对产品分布及产品其它质量无明显影响，该剂亦有良好的金属钝化效果。     

Etching behavior of CVD zinc selenide in inorganic acid solutions

Chemical interaction between polished surfaces of polycrystalline zinc selenide and inorganic acid solutions of various concentrations has been studied.     

中子寿命测井在评价管外窜槽中的应用

管外窜槽已成为制约中原油田注水开发的障碍，并造成了严重的经济损失。文中分析了管外窜槽的形成机理，重点介绍了注硼中子寿命测井技术用于管外窜槽监测的原理、工艺及解释方法。结合中原油田的应用实例，论证了中子寿命测井评价管外窜槽的有效性，为油藏动态监测提供了有效手段。