CAN总线在细纱机控制系统中的应用

分析了CAN总线在细纱机控制系统中的可行性,介绍了基于ColdFire MCF52235的细纱机控制系统的构成和PLC编程,并给出了单锭CAN节点的软件设计方案。     

Electrochemical properties of some cobalt antimonides as anode materi-als for lithium- ion batteries

Some cobalt antimonides have been prepared and studied as the candidate anode materials for lithium ion batter-ies. Reversible capacities of 424,423 and 546 mA·h·g-1 were measured at the first cycle for as-solidified CoSb2, CoSb3 and annealed CoSb3 respectively. A low lithium ions diffusion coefficient in the order of 10-16 m2·s-1 was estimated from the coulometric titration measurements in the annealed CoSb3 electrode. It was found that the electrochemical properties of fine powders are significantly better than coarse powders. However the SEM picture shows that the nano-sized CoSb3 powders gathered to larger granules, which worsens somewhat the capacity retention of the nano-sized materials, although the volume capacities of the annealed and ball milled CoSb3 remain near twice of that of graphite after 50 cycles.     

Preparation and characterization of GaN films grown on Ga-diffused Si （111） substrates

Hexagonal GaN films were prepared by nitriding Ga2O3 films with flowing ammonia. Ga2O3 films were deposited on Ga-diffused Si (111) substrates by radio frequency (r.f.) magnetron sputtering. This paper have investigated the change of structural properties of GaN films nitrided in NH3 atmosphere at the temperatures of 850, 900, and 950℃ for 15 min and nitrided at the temperature of 900℃ for 10, 15, and 20 rain, respectively. X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and X-ray photoelectron spectroscopy (XPS) were used to analyze the structure, surface morphology and composition of synthesized samples. The results reveal that the as-grown films are polycrystalline GaN with hexagonal wurtzite structure and GaN films with the highest crystal quality can be obtained when nitrided at 900℃ for 15 min.     

钼磷系缓蚀阻垢剂SK-107的缓蚀、阻垢性能研究

通过大量缓蚀、阻垢实验,着重介绍了钼磷系缓蚀阻垢剂SK-107在高碱度水且局部漏氨的合成氨循环水系统中的缓蚀、阻垢性能。     

新型冷轧(拔)无缝钢管高分子润滑工艺研究

提出了冷轧(拔)无缝钢管高分子润滑工艺。研究了该工艺的PL膜各种特性。介绍了工业实验情况。实验证明,高分子润滑工艺完全满足冷轧(拔)钢管工艺要求,并具有操作简便、环境污染小等优点,完全可以代替传统的磷化-皂化润滑工艺。     

移动定位技术的现状与发展趋势

基于位置服务为人们的日常生活带来了极大的方便,同时也推动了移动定位技术行业的快速发展。针对移动定位技术发展状况,分析目前主流定位技术的优劣,并对取得的突破作简单的总结归纳。     

基于漏磁原理的钢丝绳探伤仪影响因素研究

介绍了钢丝绳探伤仪漏磁检测原理,并使用有限元分析方法分析了传感器零件的材料、钢丝绳的提离距离及断丝根数等对基于漏磁原理的钢丝绳探伤仪检测结果的影响。分析结果表明,提离距离、断丝根数等因素对探伤仪检测结果影响较大,断丝角度、深度等因素影响较小。     

用于腺苷检测的基于级联扩增核酸适体电化学传感界面的构建研究

该文报道了一种基于酶级联扩增的电化学核酸适体检测腺苷的新方法。当腺苷存在时,滚环扩增的引物通过E.coli DNA连接酶的作用与通过巯基组装在金电极上的固定探针连接。在pHi29 DNA聚合酶的作用下,滚环扩增反应进行并产生一条与环形探针完全互补的长的单链,然后将大量金纳米粒子标记的核酸探针与滚环扩增的产物杂交。该传感界面电化学行为的结果表明,通过酶级联扩增的方法提高了检测腺苷的阻抗响应灵敏度,且选择性和重现性良好。用于腺苷的检测时,其线性范围为2.0μmol/L~100μmol/L,最低检测浓度为2.0μmol/L,表明该传感界面的设计可作为一种通用方法而有望用于其它目标物的检测。     

Treatment of linear alkylbenzene sulfonate (LAS) wastewater by internal electrolysis--biological contact oxidation process

Surfactant wastewater is usually difficult to treat due to its toxicity and poor biodegradability. A separate physico-chemical or biochemical treatment method achieves a satisfactory effect with difficulty. In this study, treatment of the wastewater collected from a daily chemical plant by the combination processes of Fe/C internal electrolysis and biological contact oxidation was investigated. For the internal electrolysis process, the optimal conditions were: pH = 4-5, Fe/C = (10-15):1, air-water ratio = (10-20):1 and hydraulic retention time (HRT)= 2 h. For the biological contact oxidation process, the optimal conditions were: HRT = 12 h, DO = 4.0-5.0 mg/L. Treated by the above combined processes, the effluent could meet the I-grade criteria specified in Integrated Wastewater Discharge Standard of China (GB 8978-1996). The results provide valuable information for full-scale linear alkylbenzene sulfonate wastewater treatment.