Self-Consistent Effects on the Starting Current of Gyrotron Oscillators

Self-consistent effects on the starting current of gyrotron oscillators are examined. Field profiles in the open cavity are shown to be sensitive to the interaction dynamics. This can either significantly raise or lower the oscillation threshold, particularly for the low-Q modes. The transition from resonant-mode oscillations at the low magnetic field to backward-wave oscillations at the high magnetic field is demonstrated.     

Effect of precyclic loading on stress-corrosion-cracking initiation in an X-65 pipeline steel exposed to near-neutral pH soil environment

A study was carried out to understand the effect of precyclic loading on stress-corrosion-crack initiation in an X-65 pipeline steel exposed to a near-neutral-pH soil environment. The test specimens were precyclically loaded before corrosion exposure to represent a service history of up to about 20 years, depending on the severity of pressure fluctuation. Microcracks had initiated on the polished surface of the X-65 pipeline steel after long-time exposure at open-circuit potential (OCP) in a near-neutral-pH synthetic soil solution. These microcracks were mostly initiated from pits at metallurgical discontinuities such as grain boundaries, pearlitic colonies, and banded phases in the steel. Strong preferential dissolution was observed along planes of the banded structures in the steel. The selective corrosion attack at these metallurgical discontinuities is attributed to the galvanic nature of those areas to their neighbors. Cyclic loading prior to corrosion exposure had significant effects on microcrack initiation and propagation during subsequent corrosion exposure. Cyclic loading prior to corrosion exposure either reduced or increased the probability of crack initiation and the rate of crack propagation, depending upon the magnitude of the stress cycles. The largest reduction was seen at a peak cyclic stress of about 0.8 of the yield strength. This cyclic-loading-dependent cracking behavior might be related to the alteration of the substructures and the residual stress in the steel as a result of precyclic loading.     

部分种子成分的特征X射线在等效生物材料中衰减的测定

用Ｓｉ（Ｌｉ）探测器实现了Ｎａ、Ｍｇ、Ｓ、Ｃｌ的特征Ｘ射线在有机膜中的相对衰减以及与Ｏ、Ｋ元素的特征Ｘ射线能量相当的Ｘ射线或轫致辐射在有机膜中的相对衰减，分别得出了它们减的数学描述，并把实验得到不同能量的Ｘ射线在有机膜中的质量吸收系数与Ｂｅｒｋｅｌｅｙ的ＯＣＧ软件计算出的结果相比，相关都小于３０％。     

A multilevel soliton communication system

A multilevel soliton communication system is proposed and assessed. In this system, at the transmitter end each channel transmits its data via fundamental solitons with a pre-specified amplitude (i.e., soliton width). At the receiver end we take advantage of the sensitive relationship between the amount or fundamental soliton self-wavelength shift and the width of the soliton in the subpicosecond region. We first compress the incoming soliton noises to the subpicosecond level and pass them through a short length of fiber at the end of which the pulses have become separated in the wavelength domain since each soliton, corresponding to a data channel, has experienced a different Raman self-wavelength shift. The channels are then easily separated by optical filters. We have derived the design constraint relations for such a system. We have then heuristically designed a 40 Gbs (four channels) system for a 1000 km propagation distance (total data-rate distance product of 40 Tb/km). Numerical simulations and noise analyses have verified the feasibility and practicality of the proposed system with very good design margins. The wavelength jitter is found to be much smaller than the desired filter spacing, and thus its contribution to the bit error rate is negligible. We also argue that the system is more tolerant to Gordon-Haus timing jitter than conventional TDM soliton systems. The system is all fiber and is, therefore very cost effective as it does not require sophisticated electro-optic and microwave circuits for demultiplexing. The system can potentially operate at much higher speeds than those achievable in conventional soliton systems and it can be used in parallel with WDM soliton system     

Synthesis, characteristics and oxygen-sensitive properties of SrMgxTi 1 − xO3 nanocrystals

SrMg_xTi_{1 - x}O₃ nanocrystals (x = 0.1–0.6) were synthesized by the stearic acid gel method. Powder samples were characterized by X-ray diffraction and X-ray photoelectron (XP) spectroscopy. The results showed that the lattice parameter a and the O 1s XP spectrum changed not only with the Mg content x but also with the grain size d of the samples. The conductivity of a thick film specimen fabricated on an aluminium oxide wafer was investigated in a nitrogen—oxygen atmosphere.     

工业汽轮机的清洗

本文介绍了用饱和蒸汽对冷凝式汽轮机进行清洗除垢时主要参数的确定、操作要点及清洗方案，清洗后的汽轮机运行正常。     

传输线衰减常数与柱形谐振器Q值的关系

文中严格地讨论了任意截面形状，任意模式的柱形谐振腔Ｑ值与构成该谐振器的传输线衰减常数间的关系，给出了更一般的公式，推广了Ｄａｖｉｄｓｏｎ和Ｓｉｍ－ｍｏｎｄｓ＾［１］、Ｂａｒｌｏｗ和Ｃｕｌｌｅｎ＾［２］以及Ｙｅｈ和Ｓｈｉｍａｂｕｋｕｒｏ＾［３，４］的结果。     

Patient's self-interpretation of tuberculin skin tests

BACKGROUND: In the outpatient use of tuberculin skin testing (purified protein derivative [PPD]), it is at times inconvenient to have a patient revisit for interpretation. Therefore, we assessed patients' ability to self-interpret these test results. METHODS: In keeping with prior custom, patients were seen by an experienced nurse, who performed skin testing with PPD intermediate strength as well as mumps and Candida anergy control tests in some cases, and explained the procedure. The patients were asked to return 48 to 72 h later, at which time one of the researchers recorded their test interpretations before they were again evaluated by the nurse. RESULTS: Sixty-eight patients were studied, of whom 59 returned at appropriate interval. Eighteen patients had a positive PPD test reaction of 10 to 20 mm induration, which only one patient correctly identified as a positive test result. However, positive anergy control tests were correctly interpreted in 10 of 27 cases. CONCLUSION: The small number of positive PPD test result recognition by these patients may be partially attributed to their lack of education, as well as foreign birth and denial of illness. PPD results should be checked by an experienced professional.     

恢复地层剥蚀厚度方法综述

恢复地层剥蚀厚度是对盆地进行定量研究的重要基础工作。本文综述、评价了目前常用的恢复剥蚀厚度的方法,并对作者曾提出的天然气平衡浓度法作了进一步的阐述。     

淀积条件对GDa—SiNx薄膜电学特性的影响

本文讨论了用辉光放电法制备氮化硅薄膜时衬底温度、射频功率和气体流量比对薄膜的电导率、介电常数和击穿强度的影响。通过优化生长条件，制备了优质非晶氮化硅薄膜，其介电常数为７．５、击穿强度为５．５ＭＶ／ｃｍ、电导率为１０－１３（Ωｃｍ）－１。