桐油改性酚醛树脂的结构及固化过程的研究

通过桐油与苯酚在酸性催化剂存在下反应，然后再在碱性催化剂存在与甲醛反应制得了一种热固性桐油改性酚醛树脂。利用红外光谱，差示扫描量热法分析技术对改性树脂的结构及固化反应过程进行了研究。     

In—situ Composite Based on Poly （ethylene terephthalate）,Polyamide and Polyethylene with Microfibres Formed through Extrusion and Hot Stretching

In-situ composites based on dispersed poly (ethylene terephthalate) (PET) or polyamide (PA),and continuous Polyethylene (PE) were prepared through a single screw extruder of Haake rheometer system with a rod-die relatively small in diameter.The extrudate was drawn at a drawing ratio of 3.1,and then quickly cooled in cold water.The specimens were obtained by injection molding at processing temperatures less than 190℃，far below the melting temperature of PET (265℃) and PA (230℃),which can maintain the solid state of PET and PA microfiber phase in the composites.Morphological observation with scanning electron microscopy (SEM) indicated that PET and PA can more or less form in-situ microfibers at compositions studied (0-20 wt pct PET or PA),and especially,PET and PA were almost deformed into fibers at the concentration of 15wt pct.Eensile strength and especially.PET and PA were almost deformed into fibers at the concentration of 15wt pct.Tensile strength and modulus of the blends reinforced by PET or PA microfibers showed to be increased from the tensile test results.The most noticeable improvement of the tensile properties occurred at 15wt pct of PET in PET/PE system,corresponding to the highest microfiber content,where the tensile strength reached 32.5 MPa,whereas only 19.5 MPa for the pure PE.     

纳米氧化铝的制备及应用

介绍了高科技产品纳米氧化铝的 3大制备方法 :固相法、气相法、液相法的优缺点 ,以及纳米氧化铝的应用与发展前景     

Transmission loss allocation based on a new quadratic loss expression

This paper presents a derivation of a new quadratic expression for the transmission loss in a power system. The main advantage of this expression is the improvement in accuracy over the other existing approximations. Furthermore, this improved quadratic form allows the transmission loss to be expressed in terms of nodal power injections. This paper builds on the derived loss expression and proposes a bus-loss matrix. This matrix is useful in quantifying the interactions among different bus power injections and establishing a loss allocation scheme for individual buses. Numerical examples are used to illustrate the accuracy of the derived quadratic form and its use in loss allocation.     

光学全交叉网络与SW榕树（F＝S＝2）网络拓扑等价的多样性

本文对有关互连网络拓扑等价的分析方法作了简单评述。并采用互连网络拓扑等价的图分析法分析了自由空间光学互连全交叉网络与ＳＷ榕树网络的拓扑等价及其多样性，拓展了全交叉网络在数字光计算、光子交换及多处理机系统的潜在应用。     

The putative tumor suppressor gene on chromosome 5q for hepatocellular carcinoma is distinct from the MCC and APC genes

We have previously shown that the tumor suppressor gene for hepatocellular carcinoma (HCC) without cirrhosis may be located on chromosome 5q35-qter. In this study, we analyzed nine cases of primary HCC without cirrhosis using probes from the MCC and APC genes, which are in the region 5q21-22. None of the informative cases had allele loss detected by these probes, whereas the probe lambda MS8 for the region 5q35-qter showed allele loss in six out of six informative cases. The results confirm that the putative tumor suppressor gene for HCC without cirrhosis on chromosome 5q is distinct from the MCC and APC genes.     

金刚石薄膜制备和评价

采用平直钨丝作热解源,并借助钨丝支架的弹性恢复力,较好地解决了热丝热解化学气相沉积法(HFCVD)合成金刚石过程中热解丝的变形问题.样品独立加热,基片温度、钨丝温度、钨丝与样品基片距离均可独立调节.装置改进后,在Si(100)上合成了面积大约45mm×25mm的比较均匀的金刚石膜.用扫描电子显微镜(SEM)、Raman光谱和X射线衍射仪对制备的金刚石膜进行了分析.     

转变观念是润滑技术现代化的必要途径

探讨了国内润滑工作存在的问题，分析了近20年来润滑技术的发展状况，介绍了国内先进单位合理用油取得的效益和经验，提出用油现代化的看法。     

低相噪,低杂波数字锁相环路滤波器的设计

较详细地分析数字锁相频率合成器的相位噪声，着重用控制论方法对低相噪、低杂波锁相环的环路滤波器进行设计，并用某Ｓ波段频率合成器的实验结果进行了验证。