双贴合无光焦度校正板在主反射镜前的两镜系统的像差特性

在光学系统中特别是反射系统中经常通过加无光焦度校正板来减少或消除其他元件所产生的像差。讨论了双贴合无光焦度校正板放在主镜前的双反射球面系统，根据像差理论分析了消像差的条件，研究了系统中各种参数的变化对系统高级残余像差的影响。结果表明主镜的相对孔径越大，系统的残余像差增加；正透镜在前的校正板结构优于负透镜在前的结构；选择合适的校正板单透镜的光焦度，可使系统的高级残余像差最小。     

HE-AAC V2编码原理及其应用

在保证优秀的音频质量下,提高音频编码的压缩效率是数字音频技术一直追求的目标,简单介绍目前最先进的音频编码HE-AAC V2的原理及应用,着重介绍其中用到的两种新技术频带复制(SBR)技术和参数立体声(PS)技术.     

New hybrid fuzzy controller for direct torque control induction motor drives

A new hybrid fuzzy controller for direct torque control (DTC) induction motor drives is presented in this paper. The newly developed hybrid fuzzy control law consists of proportional-integral (PI) control at steady state, PI-type fuzzy logic control at transient state, and a simple switching mechanism between steady and transient states, to achieve satisfied performance under steady and transient conditions. The features of the presented new hybrid fuzzy controller are highlighted by comparing the performance of various control approaches, including PI control, PI-type fuzzy logic control (FLC), proportional-derivative (PD) type FLC, and combination of PD-type FLC and I control, for DTC-based induction motor drives. The pros and cons of these controllers are demonstrated by intensive experimental results. It is shown that the presented induction motor drive is with fast tracking capability, less steady state error, and robust to load disturbance while not resorting to complicated control method or adaptive tuning mechanism. Experimental results derived from a test system are presented confirming the above-mentioned claims.     

A new Pd-oxide-Al/sub 0.3/Ga/sub 0.7/As MOS hydrogen sensor

A new and interesting Pd-oxide-Al/sub 0.3/Ga/sub 0.7/As MOS hydrogen sensor has been fabricated and studied. The steady-state and transient responses with different hydrogen concentrations has been measured at various temperatures. Based on the large Schottky barrier height and presence of oxide layer, the studied device exhibits a high hydrogen detection sensitivity and wide temperature operating regime. The studied device exhibits the low-leakage current and obvious current changes when exposed to hydrogen-contained gas. Even at room temperature, a very high hydrogen detection sensitivity of 155.9 is obtained when a 9090 ppm H/sub 2//air gas is introduced. Furthermore, when exposed to hydrogen-contained gas at 95/spl deg/C, both the forward and reverse currents are substantially increased with increased hydrogen concentration. In other words, the studied device can be used as a hydrogen sensor under the applied bidirectional bias. Under the applied voltage of 0.35 V and 9090 ppm H/sub 2//air hydrogen ambient, a fast adsorption response time about 10 s is found. The transient and steady-state characteristics of hydrogen adsorption are also investigated.     

高压25MW背压式汽轮机振动分析与处理

厂内一台B25汽轮机,因振动超差,进行了20个月的分析、计算和试验,最后发现中心孔内有250 g左右的油水化合物,造成转子热弯曲,激发汽轮机出现振动严重超标.     

一种计算机实时控制系统的分析及其DCS实现

简述了计算机实时控制及分布式控制系统(DCS)的一般特点．并以某型水下机器人的控制系统为例，详细介绍了一种小型实时DCS系统的具体实现。     

应用激光活化饵料藻种的研究

应用Nd:YAG激光(波长1.06μm,功率5w,照射时间0.5-3 min)和Ar+激光(波长488nm,功率70mw,照射时间5-15min)对长期保存的不同保存形式的塔胞藻(Pyramidomonassp.)进行辐照处理。研究了不同剂量激光辐照对藻体生长和叶绿素含量的影响。实验结果表明:照射剂量为60s的Nd:YAG激光及剂量为15min的Ar+激光对液体保存形式的藻种有较明显的促长效果,接种后这两种激光处理组的比生长速率分别较对照提高达53.33%和28.89%,叶绿素含量分别增加73.33%和65.69%。两种激光对液体保存藻种的活化效果均好于固体保存种。     

WPAN/WLAN应用环境下基于PER的链路自适应算法

本文重点研究基于包错误率测量的链路自适应算法，分析了包错误率与信道参数的关系，提出了一种有别于固定门限值方案的优化门限值方案。仿真结果表明，优化门限值方案的网络吞吐量要大于固定门限值方案和基于信干比估计的链路自适应算法，最大增幅可达12Mbit/s。在系统引入重传机制后，网络吞吐量将有所损失，但最大不超过1Mbit/s，相比较服务质量的提高是值得的。需指出的是，虽然分析和仿真均以HIPERLAN／2为例，但不失一般性，它们同样适合于WPAN/WLAN等类似系统。     

Preparation, patterning and luminescent properties of nanocrystalline Gd2O3:A (A=Eu, Dy, Sm, Er) phosphor films via Pechini sol–gel soft lithography

Nanocrystalline Gd₂O₃:A (A=Eu³⁺, Dy³⁺, Sm³⁺, Er³⁺) phosphor films and their patterning were fabricated by a Pechini sol–gel process combined with a soft lithography. X-ray diffraction (XRD), atomic force microscopy (AFM), scanning electron microscopy (SEM) and optical microscopy, UV/vis transmission and photoluminescence (PL) spectra as well as lifetimes were used to characterize the resulting films. The results of XRD indicated that the films began to crystallize at 500 °C and that the crystallinity increased with the elevation of annealing temperatures. Uniform and crack free non-patterned phosphor films were obtained by optimizing the composition of the coating sol, which mainly consisted of grains with an average size of 70 nm and a thickness of 550 nm. Using micro-molding in capillaries technique, we obtained homogeneous and defects-free patterned gel and crystalline phosphor films with different stripe widths (5, 10, 20 and 50 μm). Significant shrinkage (50%) was observed in the patterned films during the heat treatment process. The doped rare earth ions (A) showed their characteristic emission in crystalline Gd₂O₃ phosphor films due to an efficient energy transfer from Gd₂O₃ host to them. Both the lifetimes and PL intensity of the rare earth ions increased with increasing the annealing temperature from 500 to 900 °C, and the optimum concentrations for Eu³⁺, Dy³⁺, Sm³⁺, Er³⁺ were determined to be 5, 0.25, 1 and 1.5 mol% of Gd³⁺ in Gd₂O₃ films, respectively.