化学复合镀层激光处理研究

研究了激光处理对Ni-P -SiC化学复合镀层的影响。借助于扫描电镜、能谱仪、X射线衍射、显微硬度计等设备对激光处理后复合镀层的表面形貌、组织结构及性能进行了综合分析。结果表明 ,对复合镀层进行激光处理可以获得与炉内加热同样的镀层硬度 ,且当激光功率 4 0 0W ,扫描速度 1.5m /min时 ,镀层硬度高于炉内加热的硬度     

Characteristics of low-leakage deep-trench diode for ESD protection design in 0.18-/spl mu/m SiGe BiCMOS process

This paper proposes a novel low-leakage BiCMOS deep-trench (DT) diode in a 0.18-/spl mu/m silicon germanium (SiGe) BiCMOS process. By means of the DT and an n/sup +/ buried layer in the SiGe BiCMOS process, a parasitic vertical p-n-p bipolar transistor with an open-base configuration is formed in the BiCMOS DT diode. Based on the two-dimensional (2-D) simulation and measured results, the BiCMOS DT diode indeed has the lowest substrate leakage current as compared to the conventional p/sup +//n-well diode even at high temperature conditions, which mainly results from the existence of the parasitic open-base bipolar transistor. Considering the applications of the diode string in electrostatic discharge (ESD) protection circuit designs, the BiCMOS DT diode string also provides a good ESD performance. Owing to the characteristics of the low leakage current and high ESD robustness, it is very convenient for circuit designers to use the BiCMOS DT diode string in their IC designs.     

单元串联式多电平高压变频器的起源、现状和展望

本文对单元串联式多电平高压变频器的起源和现状进行了总结,同时从无速度传感器矢量控制、大容量化、冗余设计等方面对该技术未来的发展趋势进行了展望。     

热管传热性能对小型热管换热器散热效能影响

在零重力辅助下,小热管热阻是小型热管换热器散热效能的重要影响因素之一。基于集总参数法对于换热器系统数值计算的高效性思想,建立了热管、热管换热器的集总参数模型。对同一热管换热器选用不同传热性能的热管,在不同传热温差和流体质量流速下,就其散热效能进行了数值计算。计算结果表明,在零重力辅助下,热管换热器管内热阻存在一临界值Rcri。当热阻RHP≤Rcri时,管外热阻起主导作用,热管换热器的散热效能εh几乎不随热管管内热阻的值而变化。     

运营商内部数据通信网的VPN技术

针对电信运营商在构建内部数据通信网(DCN)时遇到的各应用系统的隔离问题，详细介绍了目前几种主流的虚拟专用网(VPN)技术，并进行分析比较，最后提出了运营商内部数据通信网的VPN解决方案。     

An intelligent web-page classifier with fair feature-subset selection

The explosion of on-line information has given rise to many manually constructed topic hierarchies (such as Yahoo!!). But with the current growth rate in the amount of information, manual classification in topic hierarchies results in an immense information bottleneck. Therefore, developing an automatic classifier is an urgent need. However, classifiers suffer from enormous dimensionality, since the dimensionality is determined by the number of distinct keywords in a document corpus. More seriously, most classifiers are either working slowly or they are constructed subjectively without any learning ability. In this paper, we address these problems with a fair feature-subset selection (FFSS) algorithm and an adaptive fuzzy learning network (AFLN) for classification. The FFSS algorithm is used to reduce the enormous dimensionality. It not only gives fair treatment to each category but also has ability to identify useful features, including both positive and negative features. On the other hand, the AFLN provides extremely fast learning ability to model the uncertain behavior for classification so as to correct the fuzzy matrix automatically. Experimental results show that both FFSS algorithm and the AFLN lead to a significant improvement in document classification, compared to alternative approaches.     

SMA沥青混合料在皖北地区高速公路中的应用

皖北地区夏季高温多雨,冬季严寒,气候较为恶劣,在该地区宜推广应用SMA混合料铺筑表面层。在进行SMA配合比设计时,必须严格控制原材料的质量,经过精心设计、精心施工,才能修建出一条成功的SMA路面。     

A novel InP/InGaAs TEBT for ultralow current operations

A novel InP/InGaAs tunneling emitter bipolar transistor (TEBT) is fabricated and demonstrated. The studied device exhibits a very small collector-emitter offset voltage of 40 mV and an extremely wide operation regime. The operation region is larger than 11 decades in magnitude of collector current (10/sup -12/ to 10/sup -1/A). A current gain of 3 is obtained even if the device is operated at an ultralow collector current of 3.9 /spl times/ 10/sup -12/A (1.56 /spl times/ 10/sup -7/A/cm/sup 2/). Furthermore, the common-emitter breakdown voltage of the studied device is higher than 2 V. Consequently, the studied device shows a promise for low supply voltage, and low-power consumption circuit applications.     

Al、Mo含量对铸造钛合金力学性能的影响

运用正交实验 ,考察了Al、Mo含量对Ti Al Mo 1Zr系铸造钛合金力学性能的影响。试验结果表明 :随Al、Mo含量提高 ,铸造合金的强度增加 ,塑性和冲击韧性降低 ,但Al、Mo的交互作用却使合金塑性提高 ,强度和冲击韧性降低