Phase Assemblages of Pr α-sialon Derived from SHS-ed Powders and TEM Study on the Nucleation of Pr α-sialon

The Pr α-sialon powders prepared by self-propagating high-temperature synthesis (SHS), consisting of 55 wt% Pr α-sialon and 45 wt% of β-sialon (abbreviated as α' and β'), were hot-pressed at 1800°C for 1 h. The results showed that Pr α' phase would transfer to β' with the appearance of JEM phase (Pr(Si_{6− z} Al _z )(N_{10− z} O _z )) after sintering, thus resulting in the increase of β' phase to 86 wt%. The addition of Y₂O₃ into SHS-ed Pr α' powders as the starting materials restrains the transformation of α' to β' and prevents the formation of JEM phase as well. The nucleation mechanism of Pr α' grain during hot-pressing was investigated in terms of transmission electron microscope and energy-dispersive spectrometer analysis. Two nucleation modes of Pr α' grains were found, i.e., nucleating on the undissolved Pr α' grains and on the nuclei of (Pr, Y) α' grains precipitated from liquid phase.     

对煤磨MDC89-7袋式除尘器的节能环保改造

0 前言 湖南韶峰水泥集团有限公司规格为φ2.5 m×3.9 m的风扫式煤磨配套的MDC89-7袋式除尘器于1993年投用,经十多年的生产应用,其导流板及风道损坏达80%左右;外壳、主风道因烧袋和腐蚀,严重变形且花板变得很薄;反吹风道变形穿孔,提升阀密封不严,导致清灰时风量流失严重,运行阻力增加,系统产量降低,且系统中含氧量增加,带来安全隐患;除尘效率下降、污染严重,粉尘排放浓度高达1 g/m3;系统能耗高,且维修强度大(每个滤袋重50kg,每次换袋需12人)且费用高.为此,该公司于2004年4月对该煤磨除尘器进行技术改造,取得了明显的效果.     

广角摄像机在机器人视觉定位中的应用

为了保证广角摄像机在现代机器人视觉定位应用中的准确性,以广角摄像机像素坐标的反畸变过程为研究对象,提出一种在畸变对应表的基础上使用中心迭代法以及区域插值法确定物体实际位置的方法。通过实验证明了该方法能够测量物体的位置,其精度能够满足工业使用要求。     

A two‐station embossing process for rapid fabrication of surface microstructures on thermoplastic polymers

An embossing strategy involving a hot station and a cold station for sequentially heating and cooling the embossing tool was investigated to reduce cycle times in hot embossing polymer microstructures. Experimental studies showed that aluminum stamps with a thickness of 1.4 mm can be rapidly heated from room temperature to 200°C in 3 s using contact heating against a hot station at 250°C. Microchannels and microlenses were successfully embossed onto high‐density polyethylene and acrylonitrile–butadiene–styrene substrates using a heating time less than 3 s and a total cycle time around 10 s. The two‐station embossing process for the microlens was also numerically studied. The simulated filling behavior agreed with the experimental observation and the predicted thermal and deformation history of the polymer offered a good explanation on the experimentally observed process characteristics. POLYM. ENG. SCI., 47:530–539, 2007. © 2007 Society of Plastics Engineers.     

纳米稀土复合固体超强酸催化合成乙酸苄酯

采用共沉淀法制备了纳米稀土复合固体超强酸SO4^2-／ZrO2-2％Nd2O3催化剂，电镜分析表明，催化剂颗粒直径在25nm左右，比表面积测定：71．03m^2／g。酸强度-12．70〈Ho〈-11．99。并对合成乙酸苄酯的最佳反应条件进行了研究。研究表明：当苯甲醇与乙酸的物质的量比为1：2，反应时间为5h，反应温度为120℃，催化剂用量为6％苯甲醇的质量时，酯化率可达92．04％。研究发现，该催化剂可重复使用并可活化再生。     

MACD与K线图技术在证券投机中的实证研究

利用MACD趋势指标与K线形态图进行相互验证技术,改进一般的基于MACD的证券买卖准则。实证结果表明,基于改进后的MACD买卖准则进行证券投机,几乎能使投机者捕捉到每一波段行情,从而获取较高收益。     

A novel shaft-less double suction mini pump

A novel double suction shaft-less mini pump was developed for heat control of small energy systems in this study.The mini pump impeller with an exit diameter of 40 mm was combined with the motor rotor supported by the hybrid dynamic bearing.The specific speed of the pump was 125 min-1 m3 min-1 m.The hydraulic performance of the pump was investigated experimen-tally under four rotational speeds.From the test results,it was recognized that the pump could provide a flow discharge of 5 L/min and head of 1.5 m,w...     

新农村建设规划过程中的问题与对策探析——以都昌县新农村建设为例

建设社会主义新农村,要坚持规划先行,在当前新农村建设的过程中,合理地进行村庄建设规划具有重要的意义。本文就都昌县目前农村建设的现状及新农村建设规划过程中出现的相关问题进行探析,并对都昌县新农村建设提出了可行性的对策。     

无线射频识别技术（RFID）及其在物联网中的应用

随着物联网知识的普及,以及其技术的广泛推广应用,物联网被越来越多的人所关注。本文介绍了物联网及其关键技术RFID,并结合RFID在物联网的实际应用,并对其未来的发展作出了展望。