Enhancing encoding capacity of combinational test stimulus decompressors

While scan-based compression is widely utilized in order to alleviate the test time and data volume problems,the overall compression level is dictated not only by the chain to channel ratio but also the ratio of encodable patterns.Aggressively increasing the number of scan chains in an effort to raise the compression levels may reduce the ratio of encodable patterns,degrading the overall compression level.In this paper,we present various methods to improve the ratio of encodable patterns.These methods are b...     

Thermodynamic studies on the complete phase diagram of aqueous two phase system containing polyethylene glycol dimethyl ether 2000 and di-potassium hydrogen phosphate at different temperatures

The liquid-liquid equilibrium of polyethylene glycol dimethyl ether 2000 (PEGDME₂₀₀₀)+K₂HPO₄+H₂O system has been determined experimentally at T=(298.15,303.15,308.15 and 318.15) K. The liquid-solid and complete phase diagram of this system was also obtained at T=(298.15 and 308.15) K. A nonlinear temperature dependent equation was successfully used for the correlation of the experimental binodal data. Furthermore, a temperature dependent Setschenow-type equation was successfully used for the correlation of the tie-lines of the studied system. Moreover, the effect of temperature on the binodal curves and the tie-lines for the investigated aqueous two-phase system have been studied. Also, the free energies of cloud points for this system and some previously studied systems containing PEGDME₂₀₀₀ were calculated from which it was concluded that the increase of the entropy is the driving force for formation of aqueous two-phase systems. Additionally, the calculated free energies for phase separation of the studied systems were used to investigate the salting-out ability of the salts having different anions. Furthermore, the complete phase diagram of the investigated system was compared with the corresponding phase diagrams of previously studied systems, in which the PEGDME₂₀₀₀ has been used, in order to obtain some information regarding the phase behavior of these PEGDME₂₀₀₀+salt+water systems.     

Neural network based controller for Cr–Fe batch reduction process

An automated pilot plant has been designed and commissioned to carry out online/real-time data acquisition and control for the Cr⁶⁺–Fe²⁺ reduction process. Simulated data from the Cr⁶⁺–Fe²⁺ model derived are validated with online data and laboratory analysis using ICP-AES analysis method. The distinctive trend or patterns exhibited in the ORP profiles for the non-equilibrium model derived have been utilized to train neural network-based controllers for the process. The implementation of this process control is to ensure sufficient Fe²⁺ solution is dosed into the wastewater sample in order to reduce all Cr⁶⁺–Cr³⁺. The neural network controller has been utilized to compare the capability of set-point tracking with a PID controller in this process. For this process neural network-based controller dosed in less Fe²⁺ solution compared to the PID controller which hence reduces wastage of chemicals. Industrial Cr⁶⁺ wastewater samples obtained from an electro-plating factory has also been tested on the pilot plant using the neural network-based controller to determine its effectiveness to control the reduction process for a real plant. The results indicate the proposed controller is capable of fully reducing the Cr⁶⁺–Cr³⁺ in the batch treatment process with minimal dosage of Fe²⁺.     

Selective determination of urea using urease immobilized on ZnO nanowires

Well-aligned zinc oxide (ZnO) nanowire arrays were fabricated on gold-coated plastic substrates using a low-temperature aqueous chemical growth (ACG) method. The ZnO nanowire arrays with 50–130 nm diameters and ∼1 μm in lengths were used in an enzyme-based urea sensor through immobilization of the enzyme urease that was found to be sensitive to urea concentrations from 0.1 mM to 100 mM. Two linear sensitivity regions were observed when the electrochemical responses (EMF) of the sensors were plotted vs. the logarithmic concentration range of urea from 0.1 mM to 100 mM. The proposed sensor showed a sensitivity of 52.8 mV/decade for 0.1–40 mM urea and a fast response time less than 4 s was achieved with good selectivity, reproducibility and negligible response to common interferents such as ascorbic acid and uric acid, glucose, K⁺ and Na⁺ ions.     

Power quality diagnosis using time frequency analysis and rule based techniques

Diagnosing a power quality disturbance means identifying the type and cause of the disturbance. Fast diagnosis of power quality disturbances is important so as to assist network operators in performing counter measures and implementing suitable power quality mitigation actions. In this study a novel method for performing power quality diagnosis is presented by using the S-transform and rule based classification techniques. The proposed power quality diagnosis method was evaluated for its functionality in detecting the type of short duration voltage disturbances and identifying the cause of the disturbances which may be due to permanent or non permanent faults. Based on the results, this new method has the potential to be used in the existing real time power quality monitoring system in Malaysia to expedite the diagnosis on the recorded voltage disturbances.     

Using cross-layer metrics to improve the performance of end-to-end handover mechanisms

Network centric handover solutions for all IP wireless networks usually require modifications to network infrastructure which can stifle any potential rollout. This has led researchers to begin looking at alternative approaches. Endpoint centric handover solutions do not require network infrastructure modification, thereby alleviating a large barrier to deployment. Current endpoint centric solutions capable of meeting the delay requirements of Voice over Internet Protocol (VoIP) fail to consider the Quality of Service (QoS) that will be achieved after handoff. The main contribution of this paper is to demonstrate that QoS aware handover mechanisms which do not require network support are possible. This work proposes a Stream Control Transmission Protocol (SCTP) based handover solution for VoIP called Endpoint Centric Handover (ECHO). ECHO incorporates cross-layer metrics and the ITU-T E-Model for voice quality assessment to accurately estimate the QoS of candidate handover networks, thus facilitating a more intelligent handoff decision. An experimental testbed was developed to analyse the performance of the ECHO scheme. Results are presented showing both the accuracy of ECHO at estimating the QoS and that the addition of the QoS capabilities significantly improves the handover decisions that are made.     

Short-term and long-term memory analysis of learning using 2D and 3D educational contents

ABSTRACT

The effect of 2D and 3D educational content learning on memory has been studied using electroencephalography (EEG) brain signal. A hypothesis is set that the 3D materials are better than the 2D materials for learning and memory recall. To test the hypothesis, we proposed a classification system that will predict true or false recall for short-term memory (STM) and long-term memory (LTM) after learning by either 2D or 3D educational contents. For this purpose, EEG brain signals are recorded during learning and testing; the signals are then analysed in the time domain using different types of features in various frequency bands. The features are then fed into a support vector machine (SVM)-based classifier. The experimental results indicate that the learning and memory recall using 2D and 3D contents do not have significant differences for both the STM and the LTM.     

A survey on search results diversification techniques

The quantity of information placed on the web has been greater than before and is increasing rapidly day by day. Searching through the huge amount of data and finding the most relevant and useful result set involves searching, ranking, and presenting the results. Most of the users probe into the top few results and neglect the rest. In order to increase user’s satisfaction, the presented result set should not only be relevant to the search topic, but should also present a variety of perspectives, that is, the results should be different from one another. The effectiveness of web search and the satisfaction of users can be enhanced through providing various results of a search query in a certain order of relevance and concern. The technique used to avoid presenting similar, though relevant, results to the user is known as a diversification of search results. This article presents a survey of the approaches used for search result diversification. To this end, this article not only provides a technical survey of existing diversification techniques, but also presents a taxonomy of diversification algorithms with respect to the types of search queries.     

Crystal dislocation in SEM with image processing

Image processing algorithm is implemented to detect the grain boundary of the crystal using (SEM) Scanning Electron Microscopy. This paper presents a method for edge-detection in color image based on Sobel, Canny operator’s algorithm and discrete wavelet transform. The performance of these methods is effective and faster. Filtering is another approach to clear the noise of an image. Scanning Electron Microscopy (SEM) used to inspect semiconductor materials and devices for several decades, continues to increase in importance. Removal of noise is an important step in the image restoration process, but de-noising of the image has remained a challenging problem in recent research associated with image process. De-noising is used to remove the noise from corrupted images, while retaining the edges and other detailed features too are an essential part of de-noising.