Aroused problems in the deposition of diamond-like carbon films by using the liquid phase electrodeposition technique

Hydrogenated diamond-like carbon (DLC) films were prepared by using liquid phase electrodeposition technique. The effects of the applied potential and the carbon sources on the deposition process and film structures were studied. It has been found that the organic liquids with high dielectric constants, small viscosities and the methyl group bonding to the polar group are appropriate carbon sources. The increasing of potential improves the formation of sp³ carbon during the deposition process. In a high electric field, organic molecules are polarized and reacted on the surface of the electrode, turning out DLC and other products. It is believed that the reaction follows a polarization-reaction mechanism.     

LaNiO3薄膜热稳定性的研究

LaNiO3导电金属氧化物薄膜在现代应用科学研究中作为电极和过渡阻挡层倍受青睐，它具有很好的导电特性和稳定性。该文采用射频溅射法制备了具有(100)择优取向的赝立方结构LaNiO3-x薄膜，并进行了原位热处理。实验结果表明，在265℃的处理条件下，LaNiO3薄膜表现出不稳定性，晶格中的氧在2h内失去了2.7％。氧的损失对品格结构没有明显影响，但薄膜的导电性能明显下降，折射率和消光系数也具有相同幅度的下降。对薄膜的应用具有一定的影响。该文从LaNiO3薄膜的导电机理方面对实验现象给出了分析和解释。     

单晶高温合金DD3亚结构超细化定向凝固工艺研究EI

利用ＺＭ定向凝固装置研究了镍基单晶高温合金ＤＤ３在高温度梯度（７００～１２００Ｋ／ｃｍ）定向凝固条件下的微观组织演化特征及其对工艺参数的响应函数，结果表明：该合金在高界面温度梯度条件下，柱晶生长速度范围向高速区扩展，从而使单晶亚结构细化成为可能。所得单晶棒中亚结构一次间距可比传统ＨＲＳ法定向凝固籽晶中相应尺度减小５～１０倍。本文还对其组织演化机制进行了分析。     

B－ISDN中的拥塞控制技术

Ｂ－ＩＳＤＮ是现代电信网的发展方向，拥塞控制技术则是其中的一个重要问题。由于Ｂ－ＩＳＤＮ采用新的信息传递方式──ＡＴＭ，使传统的拥塞控制方法不再适用。本文依据ＩＴＵ－Ｔ有关建议的最新内容对Ｂ－ＩＳＤＮ拥塞控制的基本思想、工作机制以及其中的主要功能作了较为详细的分析讨论，并提出了一些Ｂ－ＩＳＤＮ拥塞控制技术中尚需进一步研究的问题。     

SiH4激光等离子体内H谱线的线型研究

本文利用OMA-Ⅲ系统测量了脉冲TEA CO_2激光诱发的SiH_4等离子体发光谱内H巴耳末系的H_α、H_β和H_γ线的线型及线宽。通过理论及实验分析,认为这些谱线的主要加宽机制为Stark加宽。由实验线型和理论线型的拟合得到等离子体的电子温度T≈40000K和电子密度N≈10~(17)cm~(-3)。     

川东地区长兴组缝洞型储层的识别

本文针对四川东部地区上二叠统长兴组(P_2~2)缝洞型储层的低孔、低渗及非均质性等特点,分析了影响这类储层识别的主要因素,提出了利用现有的地球物理测井手段定性识别储层的指标和定量综合识别储层的方法,这可望提高测试成功率。     

�¸�������в������Ȼ�����꾮�ٶȵ�;��

本文针对天然气井提高钻井速度问题,总结分析了盆地中部井身结构,水力、机械参数,聚合物钻井液,正注反挤固井等工艺技术对该地区钻速的影响。指出提高天然气井钻井速度,必须搞好系统工程,形成配套技术。     

^60Coγ射线对刚地弓形虫缓殖子感染性的影响

应用不同剂量的~(60)Coγ射线照射含NT株弓形虫包囊的鼠脑匀浆后,以0.4％胰蛋白酶液消化,使弓形虫缓殖子从包囊中释放出来,并用生理盐水作连续10倍稀释,使成为含不同数量缓殖子的悬液,将此悬液接种小鼠,用生物检测方法确定其感染性。另设未经照射处理的缓殖子悬液感染小鼠的对照组。结果表明,γ射线0.55kGy剂量为控制鼠脑中NT株弓形虫感染性的最小有效剂量。γ射线0.1kGy剂量对弓形虫缓殖子感染性无明显影响,而0.45kGy照射后,其感染性较前者下降了10~4倍。     

激光微焊接质量的模糊识别技术研究

讨论了激光微焊点焊接质量的模糊识别的概念，数学模型及其应用方法，并介绍了系统的硬件组成。     

Influences of artificial pre-stressing on ply stresses and tensile properties of Vinylon fibre-reinforced aluminium laminates (VIRALL)

A simple micromechanical model based primarily upon the rule-of-mixtures is developed which allows prediction of the effects of fibre preload on the ply stresses (i.e., the initial residual stresses of fibre, adhesive and matrix) induced within VIRALL laminates, and the tensile stress-strain curves and mechanical properties of VIRALL laminates. The analysis of the ply stresses of VIRALL laminates indicates that pre-stressing will dramatically influence the ply stresses. The predicted tensile stress-strain curves of VIRALL laminates are in good agreement with the experimental curves and the results show that the stress-strain curves of VIRALL laminates move upwards when the prestress increases. The predicted tensile mechanical properties of VIRALL laminates at room temperature show good agreement with those obtained experimentally; both show that prestress can improve the tensile properties (i.e., elastic limit strength, 0.2% yield strength and failure strength) of VIRALL laminates.