Comparative study of the elimination of toluene vapours in twin biotrickling filters using two microorganisms Bacillus cereus S1 and S2

BACKGROUND: To investigate the microbial degradation performance of organic pollutants in the atmosphere using a biotrickling filter, two microorganism strains, Bacillus cereus S1 and Bacillus cereus S2, were selected, identified and inoculated into a twin biotrickling filter for comparison. RESULTS: Both strains showed good performance towards the degradation of model organic pollutants when gas flow rates ranged from 100 to 600 L h⁻¹. For S1, the total maximum removal efficiency (RE) of toluene was maintained nearly 100% not only at gas flow rates of 100 L h⁻¹ corresponding to empty bed residence time (EBRT) 199.44 s, but also at gas flow rates of 200 L h⁻¹ (EBRT = 99.72 s) and 300 L h⁻¹ (EBRT = 66.48 s). However, S2 had a much lower degradation capability; near 100% removal efficiency was obtained only at the gas flow rate of 100 L h⁻¹ although both bacteria belong to the same Bacillus cereus. With further increase in gas flow rate, the total REs for both S1 and S2 decreased slightly at first and then dropped sharply to 46% and 35%, respectively, at an EBRT of 33.24 s, corresponding to a gas flow rate of 600 L h⁻¹. Starvation for between 2 and 10 days resulted in the re‐acclimation times of both strains ranging between 1.0 and 15.5 h. CONCLUSION: Strain S1 would be a better choice for inoculation into a biotrickling filter than strain S2, because of its much higher toluene removal capacity and rapid recovery to full performance. Copyright © 2008 Society of Chemical Industry     

Electrochemical determination of estradiol using a poly(l-serine) film-modified electrode

A thin film of poly(l-serine) was prepared via electropolymerization for the determination of trace levels of estradiol. In pH 5.0 phosphate buffer, l-serine was oxidized during the cyclic potential sweeps between −0.60 and 2.0 V, forming a thin film at the electrode surface. The electrochemical behavior of estradiol was investigated. The oxidation peak potential of estradiol shifts negatively at the poly(l-serine) film-coated glassy carbon electrode (GCE) compared with that at the bare GCE. Otherwise, the oxidation peak current greatly increases at the poly(l-serine) film-modified GCE. These phenomena suggest that the poly(l-serine) film exhibits catalytic activity towards the electrochemical oxidation of estradiol. Based on this, a sensitive, rapid and simple electrochemical method was proposed for the determination of estradiol. The limit of detection is evaluated to be 2.0 × 10⁻⁸ mol L⁻¹. Finally, this method was successfully used to determine estradiol in blood serum.     

Synthesis and structural characterization of methacrylic acid/octadecyl acrylate‐graft‐poly(methylhydrosiloxane) by hydrosilylation

Methylmethacrylate (MMA) and octadecyl acrylate (OA) were grafted to poly(methylhydrosiloxane) (PMHS) by hydrosilylation, respectively, with hexachloroplatinic acid as catalyst, and the former was further hydrolyzed to prepare methacrylic acid (MAA)‐graft‐PMHS under the alkaline condition. Through orthogonal experiment, main factors affecting the graft reaction between OA and PMHS were discussed and arranged in a decreasing order according to their abilities of the effect on the hydrosilylation of OA with PMHS: catalyst dosage, reaction temperature, reaction time, material ratio, and solvent dosage. It was found that the hydrosilylation of OA with PMHS was easier to that of MMA with PMHS. Under optimal conditions, the grafting ratios of MMA with PMHS and OA with PMHS reached about 90 and 95%, respectively. FTIR and ¹H NMR spectra indicated that the hydrosilylation reactions followed the Markovnikov's rule and played a strong preference toward β‐1,2‐addition. The test of contact angle indicated that surface energy of a system was mainly dependent on the polar groups. The surface energy of OA‐graft‐PMHS (35.07 mN/m) was similar to those of PMHS (35.62 mN/m) and polyoctadecyl acrylate (36.57 mN/m), and lower than that of MAA‐graft‐PMHS (43.50 mN/m). © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

Survey of nitrate and nitrite contents of vegetables grown in Korea.

A scientific basis for the evaluation of the risk to public health arising from excessive dietary intake of nitrate in Korea is provided. The nitrate () and nitrite () contents of various vegetables (Chinese cabbage, radish, lettuce, spinach, soybean sprouts, onion, pumpkin, green onion, cucumber, potato, carrot, garlic, green pepper, cabbage and Allium tuberosum Roth known as Crown daisy) are reported. Six hundred samples of 15 vegetables cultivated during different seasons were analysed for nitrate and nitrite by ion chromatography and ultraviolet spectrophotometry, respectively. No significant variance in nitrate levels was found for most vegetables cultivated during the summer and winter harvests. The mean nitrates level was higher in A. tuberosum Roth (5150 mg kg(-1)) and spinach (4259 mg kg(-1)), intermediate in radish (1878 mg kg(-1)) and Chinese cabbage (1740 mg kg(-1)), and lower in onion (23 mg kg(-1)), soybean sprouts (56 mg kg(-1)) and green pepper (76 mg kg(-1)) compared with those in other vegetables. The average nitrite contents in various vegetables were about 0.6 mg kg(-1), and the values were not significantly different among most vegetables. It was observed that nitrate contents in vegetables varied depending on the type of vegetables and were similar to those in vegetables grown in other countries. From the results of our studies and other information from foreign sources, it can be concluded that it is not necessary to establish limits of nitrates contents of vegetables cultivated in Korea due to the co-presence of beneficial elements such as ascorbic acid and alpha-tocopherol which are known to inhibit the formation of nitrosamine.     

Piezoelectric Nanogenerators for Self-Powered Nanodevices

A novel approach converts nanoscale mechanical energy into electric energy for self-powering nanodevices.In our own work, we've used piezoelectric zinc-oxide nanowire (ZnO NW) arrays to demonstrate a novel approach for converting nanoscale mechanical energy into electric energy. Here, we review the fundamental principle behind the nanogenerator, present an approach for improving its performance, and discuss some of the challenges we face in pushing this technology to reach its potential.     

Studies of substrate specificities of lipases from different sources

Although lipases are widely applied in a wide variety of reactions, available information on the factors that are responsible for the substrate specificities of lipases from different sources is scarce. In this paper, nine lipase‐producing microorganism strains were isolated from oil‐containing samples. The properties of these enzymes, including pH optima, temperature optima, thermal stability, and pH stability, vary significantly with the different sources from which these lipases were isolated. The substrate specificities of the nine lipases, including fatty acid and positional specificities, were also studied. The fatty acid specificities of the nine lipases were observably different toward 15 substrates with different carbon chain lengths, different saturation degrees and different side chains. The lipases from S₃ Penicillium citrinum (PCL), MJ₁ Aspergillus niger (ANL), MJ₂ Aspergillus oryzae (AOL), YM Bacillus coughing (BCL), S₉ Geotrichum candidum (GCL), and S₁₁ Candida lypolytica (CLL) showed the strongest specificities to short‐chain esters, and the other lipases showed strong selectivity for medium‐ or long‐chain and branched esters. The positional specificities were examined by analyzing the hydrolytic products of triolein catalyzed by the nine lipases, using TLC. The lipases can be mainly classified into two groups by their specificities for the ester bond at position 2 of triglycerides; one group can selectively hydrolyze the ester bond at position 2 of the triglycerides, the other group cannot. All these nine lipases were divided into four groups by hierarchical clustering analysis on the basis of the results of fatty acid and positional specificities.     

Porosity distribution in highly compressible cake: Experimental and theoretical verification of the dense skin

The rate of filtration and the water content of cake are influenced by the existence of a dense skin in a highly compressible cake. The phenomenon of the dense skin has been rarely studied, and its existence has not been verified experimentally. In this study, the porosity variation in a very compressible cake is measured by using a new experimental apparatus, and with this the existence of dense skin has been established experimentally. ‘Unified theory on solid-liquid separation’, a recently developed theory, is utilized for calculating the porosity variation in a very compressible cake.     

浸胶工艺对Nomex蜂窝性能的影响

本文研究了浸胶工艺对Ｎｏｍｅｘ蜂窝性能的影响，分析探讨了提高Ｎｏｍｅｘ蜂窝性能及外观质量的途径。研究结果表明：采取新的浸胶工艺制作的Ｎｏｍｅｘ蜂窝，各项性能全面达到法国宇航材料标准。