一种基于bit位的运动补偿方法

本文讨论了等离子体显示屏所特有的在显示运动画面时出现的伪轮廓线现象，对产生的原因进行了分析并给出了软件模拟的结果。在此基础上，提出了一种基于bit位的运动补偿方法来改善运动图像的画面质量，同时根据人眼的视觉特征对补偿方法做了进一步的优化。最后对基于bit位的运动补偿方法进行了比较和验证，结果表明基于bit位的运动补偿方法可以基本消除运动画面的伪轮廓线现象。     

基于滑窗结构的软输出维特比算法的实现

文章在对软输出维特比算法(SOVA)进行推导的基础上，分析了软信息的提取过程。同时从硬件实现的角度考虑，提出了一种基于滑动窗1：3结构的SOVA算法实现方案，该算法大大降低了算法实现复杂度和译码延迟，同时通过调整滑窗参数，可以取得与非滑窗SOVA算法几乎相同的性能。     

Effect of Heat Treatment on Luminescent Properties of White Organic Light Emitting Device

The white organic light emitting device (OLED) with single-structure using a polymer blend as the light emitting layer is fabricated. Heat treatment is used to control the ratio between the intensities of main electroluminescent spectral peaks. The electroluminescent spectrum of our device is quite similar to that of white inorganic LED produced by Nichia Corporation after being annealed, and its turn-on voltage can be decreased by 1V.     

Analysis and Simulation of S-shaped Waveguide in Silicon-on-insulator

The simulation and analysis of S-shaped waveguide bend are presented.Bend radius larger than 30 mm assures less than 0.5 dB radiation loss for a 4-μm-wide silicon-on-insulator waveguide bend with 2-μm etch depth.Intersection angle greater than 20° provides negligible crosstalk (<-30 dB) and very low insertion loss.Any reduction in bend radius and intersection angle is at the cost of the degradation of characteristics of bent waveguide and intersecting waveguide, respectively.     

Distributed Optical Fiber Sensor for Multi-point Temperature Measurement

The distributed optical fiber sensing technology is overviewed, which is based on Raman scattering light theory. Basic operation principle, structure, system characteristics and signal processing are discussed. This structure and method of the signal processing possess of certain spatial resolution, hence will ensure the practicability of system.     

Experimental Research on Erbium-doped Superfluorescent Fiber Source

The effects of the variations in fiber length, fiber mirror reflectance on efficiency and output power are experimentally investigated for erbium-doped double pass backward superfluorescent fiber sources (SFSs). The influence of fiber length on mean wavelength stability (MWS) has also been demonstrated. By incorporating a short section of un-pumped erbium-doped fiber (EDF) at the output port, the pump power dependent on MWS becomes independent of pumped EDF length. This is a novel phenomenon that hasn‘t been reported up to now,and should be helpful to SFS fabrication and theory analysis. By using a fiber Michelson interferometer as spectrum slicing component,a multi-wavelength fiber source (MWFS) with ～20 channels (from 1542nm to 1559nm) is got. The MWFS has a channel spacing of ～0. 8 nm which satisfies ITUstandard. The intensity fluctuation among channels is less than 0.5dB,and the extinction ratio of all channels is above 14dB. This kind of MWFS should be useful to wavelength division multiplexing systems.     

抗窄带干扰宽带中频数字接收机的设计与实现

讨论了存在强干扰条件下MSK中频数字接收机的频域窄带干扰抑制、伪码快速捕获、MSK相干解调等实现方法。具体实现中提出了基于功率估计的码捕获门限实时调整方案，解决了动态干扰条件下的快速码捕获问题。基于FPGA DSP硬件设计和软件可编程数字信号处理算法，接收机具有较强的适应性和稳定性。     

高可靠性烧结金属丝网防爆元件的应用研究

烧结金属多孔元件作为隔爆元件的应用，很好地满足了火焰过滤元件的性能要求，进一步拓宽了烧结金属多孔元件的应用领域，章在论述其性能特点、结构类型的同时，对其在微孔结构设计上的差异也进行了描述。     

IF板与08Al板的成形性能研究

通过模拟成形性试验，对新型超深冲用IF钢板和传统冲压用08Al钢板的冲压成形性能进行了研究．结果表明：IF板的拉深性能、扩孔性能、胀形性能以及“拉深-胀形”复合性能等均优于08Al板，其中，扩孔性能和平面各向异性的改善最为显著；各项试验中，IF板的成形力普遍小于08Al板。     

煤代油方式的经济性分析

对两种煤代油方式——水煤浆和煤制混合煤气进行了燃料价格、设备投资及运行费用的分析对比。结果表明，两种代油方法均有可观的经济效益，燃料费用可分别节约52．4％和45．2％。如果原燃油工业炉窑由于工艺需要已装有除尘设备而又可用产生的蒸汽做雾化剂时，则水煤浆代油更具有经济优势。