Influences of artificial pre-stressing on ply stresses and tensile properties of Vinylon fibre-reinforced aluminium laminates (VIRALL)

A simple micromechanical model based primarily upon the rule-of-mixtures is developed which allows prediction of the effects of fibre preload on the ply stresses (i.e., the initial residual stresses of fibre, adhesive and matrix) induced within VIRALL laminates, and the tensile stress-strain curves and mechanical properties of VIRALL laminates. The analysis of the ply stresses of VIRALL laminates indicates that pre-stressing will dramatically influence the ply stresses. The predicted tensile stress-strain curves of VIRALL laminates are in good agreement with the experimental curves and the results show that the stress-strain curves of VIRALL laminates move upwards when the prestress increases. The predicted tensile mechanical properties of VIRALL laminates at room temperature show good agreement with those obtained experimentally; both show that prestress can improve the tensile properties (i.e., elastic limit strength, 0.2% yield strength and failure strength) of VIRALL laminates.     

The relationship between serum lipids, apolipoproteins level and bile lipids level, chemical type of stone

To pick up serum high risk lithogenic factors predisposing one to gallstone formation and protective factors against gallstone formation in gallbladder. We compared serum lipid and apolipoprotein level of patients with gallbladder stone (stone group) with that of patients without gallbladder stone (control group). The correlation between serum lipid, apolipoprotein level and bile lipid level, cholesterol saturated index (CSI), characteristics of lipidemia in different kinds of gallbladder stones were studied. The results showed that the increase of serum Apo A1, C2 and E level in the stone group was more significant than in the control group. But there was no statistical significance in TC, TG, LDL-C, HDL-C, Apo A2, B, C3 level between the stone and control groups. These results suggested that serum apolipoproteins perhaps are more sensitive parameters than serum lipids in distinguishing patients with stones from those without stones. There were different profiles of serum lipid and apolipoproteins in different chemical types of gallbladder stones. Increased level in serum LDL-C, Apo B and ratio of LDL-C/HDL-C were characterized by an index for cholesterol stone, otherwise that in serum TG and Apo C2 an index for pigment stones. There was a positive correlation between serum total cholesterol (TC) or Apo B, C2, C3 and cholesterol amount or CSI in gallbladder bile. Therefore, TC, Apo B, C2, C3 could be considered as high risk lithogenic factors. A positive correlation existed between serum HDL-C and lecithin in gallbladder or common bile duct (CBD) bile as well as between HDL-C and bile acids in CBD bile. Thus, HDL-C might be a protective factor against gallstone formation in gallbladder.     

Low-temperature growth of silicon-boron layer as solid diffusionsource for polysilicon contacted p+-n shallow junction

A new material, Si-B, is proposed as a solid diffusion source for fabrication of poly-Si contacted p⁺-n shallow junctions. The junction depth of the Si-B source diode has been measured and compared with that of a BF₂⁺-implanted poly-Si source diode. It was found that the Si-B source diode had a much shallower junction and was less sensitive to thermal budget than the BF₂⁺ source diode. This was attributed to the smaller surface concentration and diffusivity of boron in the silicon in Si-B source diodes. Regarding electrical characteristics of diodes with a junction depth over 500 Å, a forward ideality factor of better than 1.01 over 8 decades and a reverse-current density lower than 0.5 nA/cm² at -5 V were obtained. As the junction depth shrank to 300 Å, the ideality factor and reverse current density of diodes increased slightly to 1.05 and 1.16 nA/cm², respectively. These results demonstrated that a uniform ultrashallow p⁺-n junction can be obtained by using a thin Si-B layer as a diffusion source     

集群移动通信系统的组网设计

本文对集群移动通信系统在组网设计时应考虑的问题进行了分析，并提出了具体步骤和方法，可供集群系统组网设计时参考。     

着色型珠光颜料涂布纸的研制

本文论述了着色型珠光颜料涂布纸的研制工作，并对影响珠光涂料制备的几个因素进行探讨．优化结果表明，瓷土０～３０％，珠光颜料７０％～１００％，胶粘剂２５％～３０％，固含量２３％～２５％，涂布量１０～１５ｇ／ｍ２时，其纸面呈现强烈的珠光光泽，适用于胶印．     

A comprehensive approach to the solution of direct-coupledmultislice model of skewed rotor induction motors using time-steppingeddy-current finite element method

Normally a complicated three-dimensional (3-D) approach is needed to study the field pattern of induction machines with skewed rotor bars. In this paper, a time-stepping two-dimensional (2-D) eddy-current finite element method, based on multislice technique, is described to study the steady-state operation and the starting process of skewed rotor induction machines. The fields of the multislices are being solved en bloc simultaneously, and thus, the effects of the eddy current and saturation can be taken into account directly. New forms of the governing equations for the multislice model are derived, which allow the meshes of multislices to be taken as one 2-D mesh so that the algorithm is very similar to that of general 2-D problems. Special techniques required for the mesh generation in the multislice model and the salient structures of the software are also described. The results obtained by using the program being developed have very good correlation with test data     

防止减速器“跑,冒,漏”油的几种新方法

介绍了防止减速器“跑，冒，漏”油的几种新方法。     

浅谈土坝测压管的分析论证

通过对几座典型水库大坝原型观测设施的分析论证，总结了土坝测压管观测设备分析论证的步骤和方法，从观测设施的考证及全面性、合理性、可靠性等方面进行分析，以确定各测压管的可操作性，从而为观测资料的准确性以及整编分析提供可靠的保证。     

联合法制备VBL萤光增白剂－砍两头新工艺

将ＤＳＤ酸生产中还原反应并经中和过滤后的清液直接用于ＶＢＬ萤光增白剂生产，获得满意的效果。