高等植物氨基酸生物效应的研究进展

本文对氨基酸营养条件下植物体内硝酸盐含量变化及其机理,土施植物激素前体色氨酸和蛋氨酸对高等植物生长和化学组成的影响。氨基酸和氨基酸肥料对植物产量和品质的影响作了综述。     

柳钢35t转炉方坯连铸机系统优化措施

介绍柳钢35t转炉方坯连铸机系统优化措施，通过优化使生产稳定性提高，铸坯质量得到改善，提高各项经济技术指标。     

Synthesis and characterization of a novel proton‐exchange membrane for fuel cells operating at high temperatures and low humidities

The synthesis of a p‐toluidine/formaldehyde (PTF) resin was performed, and the effects of the molar ratio of the individual monomers and the polymerization conditions on the structure of the PTF resin were studied. Fourier transform infrared and ¹³C‐NMR spectra were used to characterize the PTF. Wide‐angle X‐ray diffraction patterns revealed the crystalline structures of various PTFs. Polarized optical microscopy revealed that the molar ratio of the monomers had a strong effect on the crystalline morphologies. A longer polymerization time turned out a polymer with a higher intrinsic viscosity and molecular weight, which led to differences in the proton conductivity. All of the PTFs showed a higher proton conductivity than a commercial Nafion membrane at 90–100°C and 0% relative humidity. The proton conductivity of the PTF series could be improved by sulfonation with sulfuric acid and could be maintained after blending with polyurethane. Pure methanol could be used as a fuel source because of the insolubility and nonwetting properties of PTF in methanol to increase the output current density for a PTF membrane electrode assembly. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

Influence of post‐treatments on the properties of porous poly(vinyl alcohol) membranes

Porous poly(vinyl alcohol) (PVA) membranes were prepared by a phase‐inversion method. The influence of chemical crosslinking and heat treatments on the swelling degree, resistance to compaction, mechanical strength, and morphology of porous PVA membranes was extensively studied. The crosslinking degree and crystallinity of the membranes, calculated from IR spectra, increased with the treatment time. The porosity, calculated on the basis of swelling experiments, showed a decreasing trend for heat‐treated membranes but remained almost at a constant value for crosslinked membranes. Such a change was further proved with scanning electron microscopy pictures. The behavior was explained by the rearrangement of PVA chains during the heat‐treatment process, which led to morphological changes in the membranes. The mechanical properties of the porous membranes in dry and wet states were measured, and a great difference was observed between crosslinked and heat‐treated membranes in the dry and wet states. The crosslinked membranes showed good mechanical properties in the dry state but became fragile in the wet state. On the contrary, the heat‐treated membranes were more flexible in the wet state than in the dry state. This change was explained by the turnaround of inner stress in the systems during the swelling process. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Accelerated wear testing with a microfabricated surface to evaluate the lubrication ability of biomolecules on polyethylene

Wear of ultrahigh‐molecular‐weight polyethylene (UHMWPE) and wear‐particle‐induced osteolysis and bone resorption are the major factors causing the failure of total joint replacements. It is feasible to improve the lubrication and reduce the wear of artificial joints. We need further understanding of the lubrication mechanism of the synovial fluid. The objective of this study is to evaluate the lubricating ability of three major components in the synovial fluid: albumin, globulin, and phospholipids. An accelerated wear testing procedure in which UHMWPE is rubbed against a microfabricated surface with controlled asperities has been developed to evaluate the lubrication behavior. An analysis of the wear particle dimensions and wear amount of the tests has provided insights for comparing their lubrication performance. It is concluded that the presence of biomolecules at the articulating interface may reduce friction. A higher concentration of a biological lubricant leads to a decrease in the wear particle width. In addition, in combination with the wear results and mechanical analysis, the roles of individual biomolecules contributing to friction and wear at the articulating interface are discussed. These results can help us to identify the role of the biomolecules in the boundary lubrication of artificial joints, and further development of lubricating additives for artificial joints may be feasible. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

橡胶Mooney—Rivlin模型材料系数对轴向刚度影响分析

在橡胶小变形范围内，采用理论推断的方法，得到在相同硬度下橡胶Mooney—Rivlin模型材料系数由C2／C1决定的关系式。并采用ABAQUS有限元软件分析的方法，结合橡胶轴向刚度常规解，分析了C2／C1不同值对橡胶轴向刚度的影响进行，结果显示其影响呈现一定规律性。     

Stability analysis of regional and national voting schemes by a continuous model

The previous discrete-model-based stability analysis of regional and national voting has been extended to a continuous-model-based analysis in the simultaneous presence of white and concentrated components of noise, reconfirming the previous conclusion that regional voting with smaller sized regions always demonstrates an improved stability over those with larger sized regions, including the national voting in its limiting case in particular. The conclusion remains valid as long as the weak distribution assumption is valid.     

Stability of Mixtoxantrone Hydrochloride in Solution

A stability-indicating reversed-phase high performance liquid chromatographic method was developed for the detection of mitoxantrone HC1 and its degradation products under accelerated degradation conditions. The degradation kinetics of mitoxantrone HC1 in aqueous solution over a pH range of 1.18 to 7.20 and its stability in propylene glycol-or polyethylene glycol 400-based solutions were investigated. The observed rate constants were shown to follow apparent first-order kinetics in all cases. The pH-rate profile shows that maximum stability of mitoxantrone HC1 was obtained at pH 4.01. No general acid or base catalysis from acetate or phosphate buffer species was observed. The catalysis rate constants on the protonated mitoxantrone imposed by hydrogen ion water and hydroxy ion were determined to be 3.72 × 10 min^-1 5.64 × 10-min^-1 and 1.108 × 10^-2min^-1, respectively. The degradation rate constants of mitoxantrone affected by different ionic strength systems. Irradiation with 254 nm UV light at 25±0.5°C was found when canpared with the light-protected controls. Incorporation of nonaqueous propylene glycol or polyethylene glycol in the pH 4.01 mitoxantrone solution shows an increase in its stability at 502±0.5°C.     

Responsiveness of self-reported and objective measures of disease severity in carpal tunnel syndrome

Responsiveness, the ability to detect meaningful clinical change, is a critical attribute of instruments used to evaluate outcomes of treatments. The authors hypothesized that self-administered symptom severity and functional status questionnaires are more responsive to clinical improvement after carpal tunnel release than traditional physical examination measures of strength and sensibility. Data were obtained from a randomized clinical trial of endoscopic versus open carpal tunnel release conducted in four university medical centers. Patients were evaluated before surgery and 3 months after surgery. Seventy-four patients indicating that they were more than 80% satisfied with the results of surgery were assumed to have clinically meaningful improvement and were the focus of the analysis. Evaluations included questionnaires assessing symptom severity, functional status, and activities of daily living as well as measurement of grip, pinch, and abductor pollicus brevis strength, and 2-point discrimination and Semmes-Weinstein pressure sensibility. Responsiveness was calculated with the standardized response mean (mean change/standard deviation of change) as well as the effect size (mean change/standard deviation of baseline values). The symptom severity scale was four times as responsive, and the functional status and activities of daily living scales were twice as responsive, as the measures of strength and sensibility. Self-administered symptom severity and functional status scales are much more responsive to clinical improvement than measures of neuromuscular impairment and should severe as primary outcomes in clinical studies of therapy for carpal tunnel syndrome.