井下乳化/水热催化裂解复合降黏开采稠油技术研究

实验考察了胜利孤东稠油井下催化水热裂解和乳化/催化水热裂解降黏效果。所用催化剂为水溶性铁镍钒体系,Fe3+∶Ni2+∶VO4+=5∶1∶1,100 g稠油与30 g 0.5%催化剂水溶液在240℃反应24小时。原始黏度(50℃)11.0和8.36 Pa.s的两种稠油裂解并静置除水后,黏度降低76.2%和75.6%,室温放置60天后降黏率下降小于3个百分点,气相色谱显示裂解后轻组分明显增加,红外光谱显示稠油组分发生脱羧反应且芳环数减少。讨论了稠油催化水热裂解反应机理。所用化学助剂JN-A在油水中均可溶,耐温达250℃,耐矿化度达50 g/L,其水溶液以30∶100的质量比与稠油混合时形成低黏度的O/W乳状液。当水相含1.0%JN-A和0.5%催化剂时,两种稠油水热裂解后的反应混合物为O/W乳状液,黏度仅为319和309 mPa.s,静置除水后的稠油降黏率增加到86.5%和87.3%,其中的轻组分含量进一步增加。该井下乳化/催化水热裂解复合降黏法成功地用于孤东两口蒸汽吞吐井,稠油井作业后初期采出的原油黏度由~9 Pa.s降低到1 Pa.s左右,随采油时间延长而逐渐升高,约50天后超过4Pa.s。图2表6参5。     

Gamma-irradiation-induced Ag/SiO2 composite films and their optical absorption properties

Small Ag particles or clusters dispersed mesoporous SiO₂ composite films were prepared by a new method: First the matrix SiO₂ films were prepared by sol-gel process combined with the dip-coating technique, then they were soaked in AgNO₃ solutions followed by irradiation of γ-ray at room temperature and in ambient pressure. The structures of these films were examined by X-ray diffraction (XRD), high-resolution transmission electron microscope (HRTEM), and optical absorption spectroscopy. It has been shown that the Ag particles grown within the porous SiO₂ films are very small, and they are isolated and dispersed from each other with very narrow size distributions. With increasing the soaking concentration and an additional annealing, an opposite peakshift effect of the surface plasmon resonance (SPR) was observed in the optical absorption measurements.     

数值试井在白6-2井测试资料分析评价中的应用

数值试井是在近来发展的一项新的试井解释技术，具有处理非均质，复杂边界油气藏问题的优点，弥补了常规解析试井技术的不足。运用数值试井解释技术，结合动、静态资料，通过对白6-1断块白6-2井测试资料的综合分析评价，确定了储层渗流参数，落实了该气藏的边界情况，为该断块下一步开发提供可靠依据。     

Al、Mo含量对铸造钛合金力学性能的影响

运用正交实验 ,考察了Al、Mo含量对Ti Al Mo 1Zr系铸造钛合金力学性能的影响。试验结果表明 :随Al、Mo含量提高 ,铸造合金的强度增加 ,塑性和冲击韧性降低 ,但Al、Mo的交互作用却使合金塑性提高 ,强度和冲击韧性降低     

美国包装考察报告--中国包装总公司美国包装考察团考察记实

一、概述 笔者于2002年11月份随中国包装总公司组织的赴美包装考察团对美国包装业进行考察.本次考察重点参加了在美国芝加哥举行的国际包装机械展览会.它集中展示了美国、加拿大及欧洲发达国家的最新包装技术和整体实力.     

利用信息融合方法的三维特征提取

本文提出了一种基于信息融合的物体三维特征的提取方法，该方法利用两幅互相配准的三维测距图像和灰度图像，来提取多面体的三维特征。首先，通过分析灰度图像中的灰度变化及测距图像中的测距值变化，分别求取各自图像中物体的特征点及特征边；然后，利用两配准图像之间的对应关系，求得所有特征点、面与多边形在三维测距图像中的三维表示；接着，通过分析三维测距图像中所测得的各候选平面上特定点与边处的曲率及法向，验证候选平面     

Enterococcal bacteremia in a medical center

BACKGROUND: The enterococci have become important nosocomial pathogens. They can cause multiple site infections and enterococcal bacteremia becomes more frequently associated with a high mortality rate. Previous studies of enterococcal bacteremia showed a variety of results. To establish the significance and importance of enterococci as nosocomial pathogens in this hospital, to characterize their clinical pictures and to search for the risk factors for mortality, this retrospective study was performed. METHODS: There were 208 cases of enterococcal bacteremia which occurred from 1988 to 1992. Twenty-seven cases had no medical charts, dismissing possibility of evaluation. Finally, 181 cases of enterococcal bacteremia were analysed. RESULTS: One hundred and eighteen episodes were nosocomial infections. Polymicrobial bacteremia occurred in 68.5% of the patients and the most common co-isolate was Pseudomonas aeruginosa. Those patients (78.5%) with underlying diseases and malignancies were the most common underlying problems. The portal of entry could be found in 69.6 percent of patients, with the gastrointestinal tract the most common sources. Antimicrobial susceptibility testing showed high gentamicin resistance rate (89.5%), and ampicillin still had about 80 percent sensitivity rate. The group who received specific antibiotic therapy for enterococcus showed lower mortality (36.4% versus 47.6%). Only one case had infective endocarditis. Forty-nine patients suffered from septic shock, the cause of 30 deaths. Totally 75 patients died during hospitalization. Besides sepsis, another major cause of death was their underlying diseases itself. CONCLUSIONS: Enterococci have no doubt become important nosocomial pathogens and enterococcal bacteremia were associated with high mortality, especially in elderly patients with underlying diseases such as malignancy or diabetes. When clinically dealing with sepsis from the gastrointestinal or biliary tract, especially when previous cephalosporins therapy showed no response, the possibility of enterococcal bacteremia should always be considered.     

Interaction of triton X-100 on silica: A relationship between surface characteristics and adsorption isotherms

Adsorption of Triton X-100 on various silica substrates has been investigated. A number of solids, including a natural quartz, this quartz washed with HCl acid and subsequently heated at 1273 K; two aerosils and one Kieselgel silicas were studied. These solids exhibit surface areas in the range of 5 to 430 m² g^?1. All the Triton adsorption isotherms display an S-shape at the adsorption temperatures studied (298 and 308 K). It has been found that the pretreatments of natural quartz (by water washing, impurities removed by acid and/or high temperature calcination) affect considerably the amounts of TX-100 adsorbed. Measurements of surface composition have been made by X-ray photoelectron spectroscopy (XPS) with particular emphasis on the presence of impurities and on the number of OH groups at the surface of the samples. The nature of the surface hydroxyl has also been studied by infrared spectroscopy. Furthermore, the specific number of hydroxyl groups on the surface of the silica samples has been determined by thermogravimetric analysis. Finally an attempt to correlate solid surface characteristics with adsorption isotherms has been developed.