应用型本科数学类专业职业技能培养研究

构建应用型本科数学类专业职业技能课程体系,强化职业资格认证,提高数学类专业学生就业能力,拓展数学类专业就业领域.     

铁路选线环境影响量化分析计算方法及应用研究

根据防护费用法、影子工程法等折算办法对环境破坏导致的经济损失等价为具体货币值,并将这些环境影响量化分析计算方法应用于西宝客运专线建设的环境评价问题中.结果表明:提出的算法对铁路选线多目标决策方案比选有应用价值.     

大学英语课堂教学中合作学习有效性探讨

合作学习已经越来越多的被大学教师引入到英语教学中。文章探讨了合作学习中遇到的问题,分析合作学习受阻的原因,提出解决问题的对策。     

铜离子印迹改性壳聚糖海绵的制备及应用研究

以醋酸铜为模板,甲醇、氯仿为溶剂,2-乙烯吡啶、丙烯酰胺为功能单体,乙二醇二甲基丙烯酸酯为交联剂,采用本体聚合法制备铜离子印迹聚合物;然后掺入到壳聚糖海绵的制备中,使壳聚糖海绵对铜离子的吸附率由27．1％提高到72．3％。制备的铜离子印迹改性壳聚糖海绵需要2d达到吸附平衡,吸附-解吸5次后,性能稳定。     

破乳剂与原油管道混合流动的数值模拟

原油开采过程中,原油遇水能够形成比较稳定的乳化液,添加破乳剂是快速高效脱去原油中水的最有效的方法。对破乳剂与原油两相混合的流动形态进行了数值模拟,得出破乳剂在不同速度、不同入口角度下加入原油管道后两相流动的速度分布图和浓度分布图。经过对比发现,当药剂入口角度为0°,药剂流入速度越大,越有利于破乳剂的扩散,破乳剂和原油的混合效果最好,就更有利于原油的脱水。     

氧化鸡肉脂肪制备肉味香精前体物质的研究

研究以鸡肉脂肪为主要原料制备肉味香精的前体物质,通过单因素和正交试验确定氧化反应的最佳反应条件.结果表明氧化鸡肉脂肪的最佳条件是:氧化温度为120℃,氧化时间为3h,VE的添加量为1.0%,不添加水和NaCl.在最优条件下进行氧化试验,得到产物的酸值和过氧化值分别为1.472 mg/g和193.51 mmol/kg,感官评价值为4.905,具有典型特征的鸡肉香气.     

Oxidation Performance of Fe-Al/WC Composite Coatings Produced by High Velocity Arc Sprayed at 650 ℃

Fe-Al intermetallics with remarkable high-temperatureintensity and excellent erosion,high-temperatureoxidation and sulfuration resistance are potential lowcost high-temperature structural material.ProducingFe-Al/WC composite coating by high velocity arcspraying(HVAS)on structural materials would notonly obviate the problems faced in fabrication of thesealloys into useful shapes,but also allow the effectiveuse of their outstanding high-temperature performance,which might thus promisingly mak…     

Electrochemical and microstructural characterization of cyclic redox behaviour of SOFC anodes

The oxidation of Ni to NiO in solid oxide fuel cell (SOFC) anode will result in large bulk volume change, which may change the interfaces of the two phases in the anode cermet and thus may cause significant performance degradation. The reduction and oxidation (redox) of the Ni/YSZ cermet were studied at 800 ℃. Anodic polarization measurements were performed before and after redox cycles. The anode current density at an overpotential of 100 mV kept decreasing during the whole redox treatment. It decreased from 19.11 to 7.95 mA·cm-2 after two redox cycles. Anode supported unit cell was assembled for cell's discharge measurements. Cell performance declined after each redox cycle. The maximum power density decreased from 126.28 to 40.32 mW·cm-2 . The microstructural changes after redox cycling were recorded using scanning electron microscopy (SEM). The results reveal that after re-oxidation, the Ni gets coarse and has a higher porosity; the nickel network structure turns to be desultory.     

高温预析出对Al-Zn-Mg-Cu铝合金显微组织、强度和应力腐蚀抗力的影响

通过改变固溶条件 ,对Al Zn Mg Cu高强铝合金采用先高温后低温的两步固溶处理 (高温预析出 )来改善晶内和晶界的析出状态 ,研究了高温预析出对Al Zn Mg Cu铝合金的金相组织、强度和应力腐蚀性能的影响。结果表明 ,4 6 5℃高温预析出在保持较高强度和塑性的同时 ,可以改善合金的抗应力腐蚀性能     

数控车床振动的控制Ⅰ:振源与力学模型

本文论述了数控车床的振源，建立了三种力学模型，并进行了分析，为数控机床的数学模型的建立和振动的控制打下了基础。