RT-PCR法检测庚型肝炎病毒C(GBV-C)RNA

应用RT－PCR法在非甲～非戊型肝炎患者血清及单采浆站供血员血浆中检测到GBV－CRNA，扩增产物经序列测定进一步确证，在30例非甲～非戊型肝炎患者中阳性率为6．6％；在600例单采浆供血者血浆中阳性率为0．33％。提示GBV－C可能不是非甲～非戊型肝炎的主要致病因子，可能存在GBV－C健康携带者。     

连续式双膜分离塔的数学模型

本文建立了适用于连续式双膜分离塔的数学模型。用实验数据验证了数学模型的可行性和合理性。将本模型与已发表的模型进行了比较,结果表明本模型具有形式简单、计算方便和适用范围更宽广等优点。     

Rheological study on O−carboxymethylated chitosan/cellulose polyblends from LiCl/N,N‐dimethylacetamide solution

An O?carboxymethylated chitosan (O? CMCh) water solution (I) and N,N‐dimethylacetamide (DMAc) emulsion (II) were blended with a cellulose LiCl/DMAc solution, and corresponding polyblends (Polyblends I and II) were obtained. The rheology of the three fluids, that is, the cellulose solution and Polyblends I and II, was investigated. The cellulose solution was characterized by a power‐law fluid. When an O‐CMCh water solution or DMAc emulsion was added to the cellulose solution, the power‐law curve was preserved. The power‐law indexes (n) of all three fluids increased along with the temperature. Polyblend I displays an n close to but a little higher than that of the cellulose solution, while Polyblend II shows a much higher power index than those of the other two fluids. The values of the apparent viscosity (η_a) for all the three fluids are close and decrease along with an increase in the temperature. Adding O‐CMCh microparticles into Polyblends I and II results in a decrease in the structural viscosity index (Δη) in comparison to that of the cellulose solution, and this effect is very obvious for Polyblend I. A cellulose solution's Δη declines with the augmentation of temperature, while the Δη's of both Polyblends I and II show minimum values at about 323 K. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 88: 1719–1725, 2003     

基体树脂对长玻璃纤维增强PP力学性能的影响

采用在线混合设备制备了长玻璃纤维(LGF)增强聚丙烯(PP)复合材料(LGF-PP),研究了基体性质及界面相容剂对LGF-PP力学性能的影响。基体树脂熔体流动速率的增加,使最终LGF-PP中的玻璃纤维长度从5.63 mm增至8.56 mm,提高了力学性能。与均聚PP比较,以共聚PP为基体树脂的LGF-PP冲击强度高出约10%,但其他性能略差。界面相容剂有利于增强玻璃纤维与PP的界面结合,拉伸强度和拉伸模量明显增加,但是冲击强度降低了20%～30%。     

Anisotropic geodesics for live‐wire mesh segmentation

We present an interactive method for mesh segmentation that is inspired by the classical live‐wire interaction for image segmentation. The core contribution of the work is the definition and computation of wires on surfaces that are likely to lie at segment boundaries. We define wires as geodesics in a new tensor‐based anisotropic metric, which improves upon previous metrics in stability and feature‐awareness. We further introduce a simple but effective mesh embedding approach that allows geodesic paths in an anisotropic path to be computed efficiently using existing algorithms designed for Euclidean geodesics. Our tool is particularly suited for delineating segmentation boundaries that are aligned with features or curvature directions, and we demonstrate its use in creating artist‐guided segmentations.     

Phase Assemblages of Pr α-sialon Derived from SHS-ed Powders and TEM Study on the Nucleation of Pr α-sialon

The Pr α-sialon powders prepared by self-propagating high-temperature synthesis (SHS), consisting of 55 wt% Pr α-sialon and 45 wt% of β-sialon (abbreviated as α' and β'), were hot-pressed at 1800°C for 1 h. The results showed that Pr α' phase would transfer to β' with the appearance of JEM phase (Pr(Si_{6− z} Al _z )(N_{10− z} O _z )) after sintering, thus resulting in the increase of β' phase to 86 wt%. The addition of Y₂O₃ into SHS-ed Pr α' powders as the starting materials restrains the transformation of α' to β' and prevents the formation of JEM phase as well. The nucleation mechanism of Pr α' grain during hot-pressing was investigated in terms of transmission electron microscope and energy-dispersive spectrometer analysis. Two nucleation modes of Pr α' grains were found, i.e., nucleating on the undissolved Pr α' grains and on the nuclei of (Pr, Y) α' grains precipitated from liquid phase.     

Phase evolution and thermophysical properties of high-entropy RE2(Y0.2Yb0.2Nb0.2Ta0.2Ce0.2)2O7 oxides

Pursuing novel thermal barrier–coating materials with lower thermal conductivity and high-temperature stability can simultaneously improve the working efficiency and service temperature of a gas turbine. In this study, a series of high-entropy RE₂(Y_0.2Yb_0.2Nb_0.2Ta_0.2Ce_0.2)₂O₇ (RE = La, Nd, Sm, Gd, Dy, and Er) oxides were prepared though solid-state reaction. Through tuning the rare-earth cations, an order–disorder transition occurs from certain partially ordered weberite structure (C222₁) to disordered defective fluorite structure (Fm$\overline{3}$m). All the high-entropy RE₂(Y_0.2Yb_0.2Nb_0.2Ta_0.2Ce_0.2)₂O₇ oxides possess low thermal conductivity in the range of 0.91–1.34 W m⁻¹ K⁻¹ at room temperature, which can be attributed to increased lattice anharmonicity and disorder, resulting in additional phonon scattering. Herein, we proved that the incorporation of heterovalent cations at B-sites in high-entropy A₂B₂O₇ crystals is an effective strategy to reduce the thermal conductivity without compromising the decrease of oxygen vacancy. Moreover, the high-entropy RE₂(Y_0.2Yb_0.2Nb_0.2Ta_0.2Ce_0.2)₂O₇ oxides show the relatively higher thermal expansion coefficients of 10.3–10.7 × 10⁻⁶°C⁻¹ and excellent phase stability at elevated temperatures.     

凝结水再循环管道振动原因及减振措施

对比了福建省内某电厂一期、二期工程600 MW发电机组凝结水再循环管道的设计和布置,经过分析,得出了一期管道振动的原因。在二期设计中做出了一些改进,基本解决了凝结水再循环管道的振动问题。     

改性聚酰亚胺在摩托车中的应用

本研究选择了改性聚酰亚胺、改性聚甲醛、改性尼龙三种材料应用于摩托车衬套制品,进行了对比试验,结果表明:采用改性聚酰亚胺的衬套具有强度高、耐磨损、尺寸稳定性好等特点,完全达到该产品设计的要求。     

基于前向预测并行追踪的视频压缩传感方法

为了减小视频信号采集端的负担,提出一种基于压缩传感理论的视频压缩算法模型。该模型采用广义轮换矩阵获取视频帧的测量值,再结合视频压缩的运动补偿预测关键技术,消除视频帧间冗余。然后在并行贪婪追踪算法中引入前向预测技术作为重构算法,最终获取重构的压缩图像。实验对比了在不同算法下的重构图像和不同采样比下不同算法的重构PSNR值,然后利用所提方法得到视频序列的重构压缩图像。实验结果表明,该算法模型能较精确地获取压缩的视频图像,适合在视频压缩中应用。