Classification of DoS Attacks in Smart Underwater Wireless Sensor Network

As per the most recent literature, Orthogonal Frequency Division Multiplexing (OFDM), a multi access technique, is considered most suitable for the 3G, 4G and 5G techniques in high speed wireless communication. What made OFDM most popular is its ability to deliver high bandwidth efficiency and superior data rate. Besides it, high value of peak to average power ratio (PAPR) and Inter Carrier Interference (ICI) are the challenges to tackle down via appropriate mitigation scheme. As a research contribution in the present work, an improved self-cancellation (SC) technique is designed and simulated through Simulink to mitigate the effect of ICI. This novel proposed technique (Improved SC) is designed over discrete wavelet transform (DWT) based OFDM and compared with conventional SC scheme over different channel conditions i.e. AWGN and Rayleigh fading environments. It is found that proposed DWT-OFDM with Improved SC scheme outperforms conventional SC technique significantly, under both AWGN and Rayleigh channel conditions. Further, in order to justify the novelty in the research contribution, a Split-DWT based Simulink model for Improved SC scheme is investigated to analyse the BER performance. This Split-DWT based Simulink model presented here foretells the future research potential in wavelet hybridization of OFDM to side-line ICI effects more efficiently.

     

Structural,Thermal and Luminescence Properties of AlN:Tm Thin Films Deposited on Silicon Substrate and Optical Fiber

Semiconductors - Thin films of AlN:Tm are deposited on a Si(111) and Si(100) substrates and optical fiber by rf magnetron sputtering method. 200–400 nm thick films are deposited at various...     

Low-power CMOS distributed amplifier using new cascade gain cell for high and low gain modes

A CMOS distributed amplifier (DA) with low-power and flat and high power gain (S₂₁) is presented. In order to decrease noise figure (NF) an RL terminating network used for the gate transmission line instead of single resistance. Besides, a flat and high S₂₁ is achieved by using the proposed cascade gain cell consist of a cascode-stage with bandwidth extension capacitor. In the high-gain mode, under operation condition of V _dd  = 1.2 V and the overall current consumption of 7.8 mA, simulation result shown that the DA consumed 9.4 mW and achieved a flat and high S₂₁ of 20.5 ± 0.5 dB with an average NF of 6.5 dB over the 11 GHz band of interest, one of the best reported flat gain performances for a CMOS UWB DA. In the low-gain mode, the DA achieved average S₂₁ of 15.5 ± 0.25 dB and an average NF of 6.6 dB with low power consumption (P_DC) of 3.6 mW, the lowest P_DC ever reported for a CMOS DA or LNA with an average gain better than 10 dB.     

A wide axial-ratio beamwidth circularly-polarized oval patch antenna with sunlight-shaped slots for gnss and wimax applications

Wireless Networks - This paper proposes a quadruple band stacked oval patch antenna with sunlight-shaped slots supporting L1/L2/L5 GNSS bands and the 2.3 Ghz WiMAX band. The antenna produces...     

Correction to: Enhanced TOA Estimation Using OFDM over Wide-Band Transmission Based on a Simulated Model

Wireless Personal Communications -     

Optimized ITO-free tri-layer electrode for organic solar cells

The optical properties of ZnO/Ag/ZnO (ZAZ) multilayer structures were numerically modeled and calculated by a FDTD method. Such tri-layers were also manufactured using an ion beam sputtering plant. A good agreement is obtained between modelizations and realizations. The impact of the oxide thicknesses on the optical properties of the ZAZ structures were experimentally and numerically investigated, and allow us to adjust the spectral position of the transmission maximum. The transmission of these structures is optimized up to around 74%, on the whole absorption spectral range of the photoactive P3HT:PCBM bulk heterojunction. The best electrode design is glass/ZnO (30 nm)/Ag (14 nm)/ZnO (30 nm), which presents a sheet resistance of 7 Ω/□. The optimized ZAZ structure was successfully integrated in an organic solar cell as anode. A photovoltaic efficiency of 2.58% is obtained and is compared to an organic solar cell integrating a traditional ITO anode with an efficiency of 2.99%. Numerical calculations of the intrinsic absorption inside each layer of the organic solar cells are performed. Alternative ITO-free electrodes for organic solar cells are demonstrated.     

Performance analysis of selective cooperation in amplify‐and‐forward relay networks over identical Nakagami‐m channels

In cooperative communications, multiple relays between a source and a destination can increase the diversity gain. Because all the nodes must use orthogonal channels, multiple‐relay cooperation becomes spectrally inefficient. Therefore, a bestrelay selection scheme was recently proposed. In this paper, we analyzed the performance of this scheme for a system with the relays operating in amplify‐and‐forward mode over identical Nakagami‐m channels using an exact source–relay–destination signal‐to‐noise ratio (SNR).We derived accurate closed‐form expressions for various system parameters including the probability density function of end‐to‐end SNR, the average output SNR, the bit error probability, and the channel capacity. The analytical results were verified through Monte Carlo simulations. Copyright © 2011 John Wiley & Sons, Ltd.     

Implementation of OpenFlow based cognitive radio network architecture: SDN&R

Wireless Networks - The static conventional network architecture is ill-suited to the growing management complexity and highly dynamic wireless network topologies. Software Defined Radio systems...     

Hybrid opto-digital signal processing in 112 Gbit/s DP-16QAM and DP-QDB transmission for long-haul large-$$\hbox {A}_\mathrm{eff}$$ pure-silica-core fiber links

In this work, we investigate the energy efficiency in optical code division multiplexing access (OCDMA) networks with forward error correction (FEC). We have modeled the energy efficiency considering the capacity of information transmitted and the network power consumption. The proposed network power consumption model considers the optical transmitter, receiver, optical amplifiers, FEC and network infrastructure as encoders, decoders, star coupler and network control in the overall optical power network consumption balance. Furthermore, an expression relating the signal-to-noise-plus-interference ratio gain for forward error correction with low-density parity-check code scheme considering the power consumption and bandwidth occupancy has been derived. Numerical results for OCDMA networks with aggregated FEC procedure have revealed the viability of the FEC deployment aiming to increase the overall energy efficiency of OCDMA networks.